Atlas Sound AT10 Handleiding

Atlas Sound Niet gecategoriseerd AT10

Lees hieronder de 📖 handleiding in het Nederlandse voor Atlas Sound AT10 (1 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 46 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/1

1/1

AtlasSound.com

TELEPHONE: (800) 876-3333

FAX (800) 765-3435

©2012 Atlas Sound L.P. All rights reserved. Atlas Sound is a trademark of Atlas Sound L.P. All other trademarks are the property of their respective owners. All specs are subject to change without notice. ATS004344 RevA 5/12

1601 JACK MCKAY BLVD.

ENNIS, TEXAS 75119 U.S.A.

Attenuator Installations

Wiring

Each terminal will hold up to 2-16AWG stranded wire. For larger wires or home run situations, a small length of wire and a wire nut are

recommended. Attach wire according to label on terminal block as shown to the right (Non-PA Models will not have the "VDC+" and "VDC-"

terminals).

*Install the unit with the terminal block on top. This will ensure that the OFF position is in the bottom.

Schematics for Priority Attenuators Power Switching Req. for -PA Attenuators

Use 2nd external relay

when paging switch is part

of a paging microphone.

This will reduce hum and

noise pickup from the mic.

RELAY SPECIFICATIONS:

Coil Voltage: Coil Current: 24 VDC

10MA

Contacts: SPDT-2Amp Rating

Relay has a protective cover.

WIRING REQUIREMENTS: (1) PAIR FOR AUDIO, (1) PAIR FOR RELAY

(-RM) Rack Mount

Drill holes in panel using the template to the right. Peel off adhesive

backing on escutcheon overlay. Align hole openings with holes in

panel and affix to surface. Remove knob and nut from attenuator.

Insert bushing through large hole in panel making sure that the small

indentation on the bracket lines up with the small hole in the panel.

Fasten attenuator to panel with the nut. Fit attenuator knob on shaft.

Tighten screw on knob to secure.

Dimensional Speciﬁcations

-RM Models supplied without a faceplate. All other models supplied with a single

faceplate. Double gang stainless steel faceplate can be ordered separately.

MODEL A B C

AT10 21

⁄8" (54mm) 23⁄4" (70mm) 13⁄4" (45mm)

AT35 21

⁄8" (54mm) 23⁄4" (70mm) 13⁄4" (45mm)

AT100 21

⁄2" (64mm) 23⁄4" (70mm) 13⁄4" (45mm)

7⁄ "mm16

3⁄ "mm16

3⁄ "mm8

Product specificaties

Merk:	Atlas Sound
Categorie:	Niet gecategoriseerd
Model:	AT10
Gewicht:	450 g
Breedte:	69.8 mm
Diepte:	53.9 mm
Hoogte:	114.3 mm
Maximaal ingangsvermogen:	10 W
Impedantie:	- Ohm
Frequentiebereik:	- GHz
Demping:	33 dB