Argoclima Cult Handleiding

Argoclima Heater Cult

Lees hieronder de 📖 handleiding in het Nederlandse voor Argoclima Cult (5 pagina's) in de categorie Heater. Deze handleiding was nuttig voor 57 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/5

V 05/15

OPERATING INSTRUCTIONS

Read the instructions carefully before installing and operating the appliance or performing

maintenance operations. Observe all the safety instructions; failure to observe the instructions may

cause accidents and/or damages. Store these instructions for future reference.

CERAMIC FAN HEATER

V 05/15

GENERAL SAFETY INFORMATION

• Use this fan heater only as outlined in this manual. Any other use not recommended by the manufacturer may cause fire,

electric shock or injury to people.

• Ensure that the mains power complies with the voltage specified on the fan heater data plate (220-240V~50Hz).

• This product is not a toy. Children of less than 3 years should be kept away unless

continuously supervised.

• This device is not intended for persons (including children) with reduced physical, sensory

or mental capabilities, or without the necessary experience and knowledge, unless they

have received the necessary supervision or instruction concerning use of the appliance by

a person responsible for their safety.

• Children aged from 3 and less than 8 years shall only switch on/off the appliance provided

that it has been placed or installed in its intended normal operating position and they have

been given instruction concerning use of the appliance in a safe way and understand the

hazards involved. Children aged from 3 years and les than 8 years shall not plug in,

regulate and clean the appliance or perform user maintenance.

CAUTION - Some parts of this product can become very hot and cause burns.

Particular attention has to be given where children and vulnerable people are

present.

WARNING: In order to avoid hazard due to inadvertent resetting of the thermal cut-out, this

appliance must not be supplied through and external switching device, such as a timer, or

connected to a circuit that is regularly switched on and off by the utility.

WARNING: do not use the fan heater with a controller or any other external device

that activates the appliance automatically, as there may be a risk of fire if the fan

heater is covered or incorrectly positioned.

• Do not restrict the air inlet and outlet grilles.

• The appliance heats up slightly when in use. In order to avoid burns, do not let bare skin touch hot surfaces.

• Ensure that all objects are at least 1 meter from the front and sides of the appliance.

• Disconnect the mains power when the appliance is not used or for cleaning operations.

• Avoid using the fan heater in dusty environments or in the presence of inflammable vapors (e.g. in workshops or garages)

or paint vapors.

• Do not place anything on the appliance, use the appliance to dry clothing.

• Use the appliance in a well-ventilated area.

• Avoid placing fingers or foreign objects in the air inlet/outlet grilles, as this may lead to electric shock or fire and may

damage the appliance.

• To avoid the risk of fire, do not block the grilles or tamper with them in any way while the fan heater operates.

• Do not use the appliance if the cord or plug are damaged. If the power supply cord is damaged, it must be replaced

by the service centre so as to avoid any safety risks.

• Do not operate the appliance if it has fallen from a height or has suffered damage in any way. Contact qualified technical

personnel to examine the appliance or perform any electrical or mechanical repairs.

• The most common cause of overheating is the build-up of dust in the appliance. Remove dust deposits by unplugging the

appliance and cleaning the air outlets and grilles with the aid of a vacuum cleaner.

• Do not use abrasive detergents for cleaning this appliance. Clean the appliance with the aid of a damp (not wet) cloth

rinsed in hot soapy water. Always remove the plug from the mains socket before cleaning.

• To disconnect the fan heater, push the switch to OFF and remove the plug from the socket. Pull on the plug only. Avoid

pulling on the cord when disconnecting the fan heater.

• Do not place any objects on the cord and do not bend it.

• It is not advisable to use extension cords, as these may overheat and cause the risk of fire. Do not use a single extension

cord to operate multiple appliances.

• Do not immerse the cord, plug or any other element of the appliance in water or other liquids.

• Do not touch the plug with wet hands.

• Do not place the fan heater above or near another heat source.

V 05/15

WARNING: AVOID COVERING THE FAN HEATER TO PREVENT IT FROM OVERHEATING.

The symbol below signals the above warning:

• The fan heater may cause the risk of fire if, while in operation, is covered by or comes into contact with inflammable

material including curtains, drapery, blankets, etc. KEEP THE FAN HEATER AWAY FROM THESE MATERIALS.

• Do not connect the appliance to the mains power before it has been properly assembled and positioned.

• Do not run the cord under carpets. Do not cover the cord with blankets, carpets or similar materials. Place the cord far

away from busy areas or where it cannot be accidentally pulled-out.

• Do not operate the fan heater in close proximity to bathtubs, showers, washbasins or pools.

• Do not position the fan heater below a socket outlet.

• Do not operate the appliance outdoors.

Upon initial start-up, the fan heater may emit a slight, harmless smell. This smell is a normal effect of the initial heating

up of the internal heating elements, and should not recur later on.

WARNING: DO NOT DEPEND ON THE ON/OFF BUTTON SWITCH AS THE SOLE MEANS OF DISCONNECTING

POWER. WHEN SERVICING OR MOVING THE FAN HEATER, ALWAYS UNPLUG THE POWER CORD.

• A fan heater has hot and arcing or sparkling parts inside. It must not be used in potentially dangerous locations such as

flammable, explosive, chemical-laden or wet atmosphere.

• Do not place the fan heater on soft surfaces, like a bed, where openings may become blocked. Always place the fan

heater on a stable, flat, level surface when operating, to avoid the chance of the fan heater overturning. Locate the power

cord so the fan heater or other objects are not resting on it.

• Always unplug the fan heater when not in use.

• In order to avoid accidents turn unit off if unattended.

• In the event of any problems (abnormal noise or a strange smell) switch off the appliance immediately, do not

• attempt to repair it and take it to your local after sales service.

DESCRIPTION OF PARTS

1. Thermostat knob

2. On/off and selection knob

3. Air outlet grille

4. Base of the appliance

5. Tip over switch

6. Intake grille with filter that can be removed for cleaning

7. Carrying Handle

HOW TO USE THE FAN HEATER

Put the fan heater vertically on a flat and stable surface. Use the handle when you move the appliance.

Connect the power cord to a suitable electric socket (220-240V~/50Hz).

Turn the thermostat knob clockwise to maximum position “+”.

Turn on the On/off and selection knob and select one of the possible positions: Cold ventilation, ECO mode (1100W), ECO

mode + oscillation, COMFORT mode (1800 W), COMFORT mode + oscillation.

Product specificaties

Merk:	Argoclima
Categorie:	Heater
Model:	Cult
Soort bediening:	Draaiknop
Kleur van het product:	Black, White
Aantal vermogenniveau's:	2
Warmtebron:	Electrisch
Gewicht:	2000 g
Breedte:	220 mm
Diepte:	148 mm
Hoogte:	312 mm
Soort:	Ventilator elektrisch verwarmingstoestel
Vermogen:	1800 W
Geschikt voor:	Binnen
Instelbare thermostaat:	Ja
Oververhittingsbeveiliging:	Nee
AC-ingangsspanning:	230 V
AC-ingangsfrequentie:	50 Hz
Geschikt voor ruimtevolume tot:	50 m³
Verwarmingsvermogen:	1800 W
Verwarming power (min):	1100 W
Zomer-ventilatie:	Ja
Anti-stof filter:	Ja
Anti-tilt-bescherming:	Ja