Amana PGK01TB Handleiding

Bekijk gratis de handleiding van Amana PGK01TB (2 pagina’s), behorend tot de categorie Airco. Deze gids werd als nuttig beoordeeld door 53 mensen en kreeg gemiddeld 4.3 sterren uit 5 reviews. Heb je een vraag over Amana PGK01TB of wil je andere gebruikers van dit product iets vragen? Stel een vraag

A3495703October 2000

Rev. 1

Standard Louvered Grille

The installation and servicing of this equipment should be

performed by qualified, experienced technicians.

PTAC

Standard Louvered and

Architectural Outdoor Grilles

Installation Instructions

Figure 2

Standard Louvered Grille Installation Instructions

Figure 3

1.Position the grille so that all four flanges are in the up

position.

2.Insert the six grommets provided so the square end

protrudes through the grille in the opposite direction

from the flanges.

3.Manipulate the grille out through the rear sleeve open-

ing using the plastic handle (not shown) provided.

4.Align the guide pins located in the lower right- and left-

hand corners of the grille (Figure 3) with the corre-

sponding holes in the rear of the wall sleeve.

5.Secure the grille by threading each of the six screws

into the plastic grommets.

6.Remove the plastic handle (not shown) from the center

of the grille prior to installing the chassis into the

sleeve.

CAUTION

Be sure to keep a firm grip on the plastic

handle and grille to prevent it from dropping

and /or causing possible injury or property

damage.

NOTE: A baffle kit must notbe used with a standard

louvered grille on any PTAC installation.

Before installing the grille, remove the cardboard stiffener

and rear enclosure panel from the wall sleeve. These

items can be removed from inside of the building. The

sleeve stiffener must be taken out before the rear sleeve

enclosure panel can be removed from the sleeve.

Sleeve Stiffiner Removal

Fold the two outside flaps “A”in and downward to remove

(Figure 1).

Figure 1

Rear Enclosure Removal

Remove the rear enclosure by folding the front ends of the

top and bottom towards the center. Grasp the top and

bottom flanges as shown in Figure 2 and pull out diagonally

from one side of the sleeve.

A

A

Made in USA

Product specificaties