Zoeller 10-4011 Handleiding

Bekijk gratis de handleiding van Zoeller 10-4011 (12 pagina’s), behorend tot de categorie Pomp. Deze gids werd als nuttig beoordeeld door 2 mensen. Heb je een vraag over Zoeller 10-4011 of wil je andere gebruikers van dit product iets vragen? Stel een vraag

© Copyright 2016 Zoeller

®

Co. All rights reserved.

For indoor use only.

All electrical and safety codes must be followed in addition to the National Electrical Code and all applicable local codes.

SPECIFICATIONS

This alarm unit monitors liquid levels in lift pump chambers, sump pumps basins, holding tanks, and other non-potable water applications. It features a green

“power on” light, a red input light, an audible buzzer, and a silence/test button. The APak

®

plugs into a 120 V, 60 Hz receptacle. Battery backup power is applied by

two standard alkaline AA batteries, which are not included and must be purchased separately (see Figure A).

ALARM UNIT INSTALLATION

1) Before installing alarm, remove the 4 cover screws to access battery compartment (see Figure B) and install two standard alkaline AA batteries, not included.

2) Mount the alarm unit securely.

3) Plug transformer’s barrel connector into the APak

®

. Secure power cord so it does not interfere with or obstruct any other devices.

4) Plug transformer into standard, 120 V AC, 60 Hz receptacle.

NOTE:The APak

®

Alarm should be connected to a circuit separate from the pump circuit.

Installations using AC power and batteries can skip the following explanation and chart. Some installations may require the APak

®

alarm to be powered by

batteries only or by AC power only. To receive appropriate alarm behavior in such installations, see the following chart.

FM2931

1016

Supersedes

0816

NOTICE TO INSTALLER: Instructions must remain with installation.

Figure A

SK3103

SILENCE

INPUT 1

POWER

ZOELLER

ALARM

PUMP "ON"

PUMP "OFF"

FIBERGLASS

OR POLYETHYLENE

BASIN

"ON" LEVEL

LEVEL

LEVEL

4" [102 mm] OF GRAVEL

ALARM

ZOELLER

TRANSFORMER TO POWER SUPPLY

TO POWER SUPPLY

UNICHECK

"DO NOT" PLUG A-PAK ALARM SYSTEM

INTO THE SAME CIRCUIT AS THE PUMP

NOTE:

ZOELLER

VERTICAL

REED SENSOR

Product information presented

here reects conditions at time

of publication. Consult factory

regarding discrepancies or

inconsistencies.

MAIL TO: P.O. BOX 16347 • Louisville, KY 40256-0347

SHIP TO: 3649 Cane Run Road • Louisville, KY 40211-1961

(502) 778-2731 • 1 (800) 928-PUMP • FAX (502) 774-3624

visit our web site:

www.zoeller.com

®

Your Peace of Mind is Our Top Priority

®

SILENCE

INPUT 1

POWER

REMOVE (4) COVER SCREWS

TO INSTALL/REPLACE BATTERIES.

TO POWER SUPPLY.

TO CONTROL SWITCH.

Figure B

SK3102

ALARM INSTALLATION INSTRUCTIONS

Power choiceResulting alarm behaviorDo this

AC & batteriesAlarms for power outage and low battery.Insert batteries and connect to power.

AC onlyLow battery alarm disabled.

Hold button while powering up the alarm for about 5 seconds until green power LED turns

on. This setting will be remembered by the alarm even after a power outage. If this setting is

no longer desired, simply adding batteries will remove this setting.

Batteries onlyPower outage alarm disabled.Insert batteries. The alarm will not detect AC power if it is never applied.

10-4011 pictured

Product specificaties