Whirlpool WIE 2B19 UK Handleiding

Whirlpool Vaatwasser WIE 2B19 UK

Lees hieronder de 📖 handleiding in het Nederlandse voor Whirlpool WIE 2B19 UK (8 pagina's) in de categorie Vaatwasser. Deze handleiding was nuttig voor 26 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/8
EN
1
DAILY REFERENCE
GUIDE
Before using the appliance carefully read Health and Safety guide.
APPLIANCE
PRODUCT DESCRIPTION
CONTROL PANEL
1 2 3 4 5
1. On-O/Reset button with indicator light
2. Program selection button
3. Rinse Aid rell indicator light
4. Salt rell indicator light
5. Program indicator lights
THANK YOU FOR BUYING A WHIRLPOOL PRODUCT.
In order to receive a more complete assistance, please
register your appliance on:
www.whirlpool.eu/register
You can download the Safety Instructions and the
Use and Care Guide, by visiting our website
docs.whirlpool.eu and following
the Instructions on the back of this booklet.
0000 000 00000
Service:
1
2
3
4
5
6
10
12
7
11
9
8
1. Upper rack
2. Foldable aps
3. Upper rack height adjuster
4. Upper spray arm
5. Lower rack
6. Cutlery basket
7. Lower spray arm
8. Filter Assembly
9. Salt reservoir
10. Detergent and Rinse Aid dispensers
11. Rating plate
12. Control panel
2
FIRST TIME USE
SALT, RINSE AID AND DETERGENT
ADVICE REGARDING THE FIRST TIME USE
After installation, remove the stoppers from the racks and the reta-
ining elastic elements from the upper rack.
FILLING THE SALT RESERVOIR
The use of salt prevents the formation of LIMESCALE on the dishes and
on the machine’s functional components.
• It is important that the salt reservoir be never empty.
• It is important to set the water hardness.
The salt reservoir is located in the lower part of the dishwasher (see Pro-
duct Description) and should be lled when the SALT REFILL indicator
light in the control panel is lit .
1. Remove the lower rack and unscrew the
reservoir cap (anticlockwise).
2. -Only the rst time you do this: ll the salt re
servoir with water.
3. Position the funnel (see gure) and ll the salt
reservoir right up to its edge (approximately
1 kg); it is not unusual for a little water to leak
out.
4. Remove the funnel and wipe any salt residue
away from the opening.
Make sure the cap is screwed on tightly, so that no detergent can get
into the container during the wash program (this could damage the
water softener beyond repair).
Whenever you need to add salt, it is mandatory to complete the
procedure before the beginning of the washing cycle.
SETTING THE WATER HARDNESS
To allow the water softener to work in a perfect way, it is essential that
the water hardness setting is based on the actual water hardness in
your house. This information can be obtained from your local water
supplier.
The factory setting is for avarage (3) water hardness.
•SwitchontheappliancebypressingtheON/OFF button.
•SwitchotheappliancebypressingtheON/OFF button.
•HolddownbuttonP for 5 seconds, until you hear a beep.
•SwitchontheappliancebypressingtheON/OFFF button.
•Theprogramindicatorlightofthecurrentsetlevelashes.
•PressbuttonP to select the desired hardness level (see WATER
HARDNESS TABLE).
•SwitchotheappliancebypressingtheON/OFFbutton.
Setting is complete!
As soon as this procedure is complete, run a program without loading.
Only use salt that has been specically designed for dishwashers.
After the salt has been poured into the machine, the SALT REFILL indi-
cator light switches o.
If the salt container is not lled, the water softener and the
heating element may be damaged as a result.
FILLING THE RINSE AID DISPENSER
Rinse aid makes dish DRYING easier. The rinse aid dispenser shouldA
be lled when the in the controlRINSE AID REFILL indicator light
panel is lit.
1. Open the dispenser by pressing and pulling up the tab on the lidB .
2. Pour in the rinse aid (max.110 ml), making sure it does not overow
from the dispenser. If this happens, clean the spill immediately with a
dry cloth.
3. Press the lid down until you hear a click to close it.
NEVER pour the rinse aid directly into the appliance tub.
ADJUSTING THE DOSAGE OF RINSE AID
If you are not completely satised with the drying results, you can ad-
just the quantity of rinse aid used.
•SwitchthedishwasheronusingtheON/OFF button.
•SwitchitousingtheON/OFF button.
•PressbuttonP three times - a beep will be heard.
•SwitchitonusingtheON/OFF button.
•Theprogramindicatorlightofthecurrentsetlevelashes.
•PressbuttonP to select the level of rinse aid quantity to be
supplied.
•SwitchitousingtheON/OFF button
Setting is complete!
If the rinse aid level is set to ZERO (ECO), no rinse aid will be supplied. The
LOW RINSE AID indicator light will not be lit if you run out of rinse aid.
A maximum of 4 levels can be set according to the dishwasher model. The
factory setting is specic to the model, please follow instruction above
to check this for your machine.
• If you see bluish streaks on the dishes, set a low number (1-2).
• If there are drops of water or limescale marks on the dishes, set a
mid-range number (3-4).
FILLING THE DETERGENT DISPENSER
A
B
To open the detergent dispenser
use the opening device A. Introduce
the detergent into the dry dispenser
B only. Place the amount of
detergent for pre-washing directly
inside the tub.
1. When measuring out the detergent re-
fer to the mentioned earlier information
to add the proper quantity. Inside the
dispenser B there are indications to help
the detergent dosing.
2. Remove detergent residues from the edges of the dispenser and
close the cover until it clicks.
3. Close the lid of the detergent dispenser by pulling it up until the
closing device is secured in place.
The detergent dispenser automatically opens up at the right time
according to the program.
If all-in-one detergents are used, we recommend using the TABLET
button, because it adjusts the program so that the best washing and
drying results are always achieved.
Water Hardness Table
Level °dH
German degrees
°fH
French degrees
1 Soft 0 - 6 0 - 10
2 Medium 7 - 11 11 - 20
3 Average 12 - 17 21 - 30
4 17 - 34 31 - 60Hard
5 Very hard 35 - 50 61 - 90
M
A
X
A
B
35
25
EN
3
PROGRAMS TABLE
ECO program data is measured under laboratory conditions according to European Standard EN 50242. Note for Test Laboratories: For information on
comparative EN testing conditions, please send an email to the following address: dw_test_support@whirlpool.com
Pre-treatment of the dishes is not needed before any of the programs.
*) The duration of the program shown on the display or in the booklet is an estimate calculated on standard conditions. The actual time may vary
depending on many factors such as temperature and pressure of the incoming water, room temperature, amount of detergent, quantity and type of load,
load balancing, additional selected options and sensor calibration. The sensor calibration can increase program duration up to 20 min.
Standby consumption: Left-on mode consumption: 5 W - O mode consumption: 0.5 W
PROGRAMS DESCRIPTION
Instructions on wash cycle selection.
ECO
Normally soiled crockery. Standard program, the most ecient in
terms of its combined energy and water consumption.
INTENSIVE
Program recommended for heavily soiled crockery, especially suitable
for pans and saucepans (not to be used for delicate items).
NORMAL
Mixed soil. For normally soiled dishes with dried food residues.
RAPID 40’
Program to be used for lightly-soiled dishes with no dried food
residues.
HALF LOAD
Ideal for washing a half load of lightly or normally soiled crockery.
PRE-WASH
Use to refresh crockery planned to be washed later. No detergent to be
used with this program.
Notes:
Please note that cycles like are most eective for lightly soiledRapid
dishes.
To reduce consumption even further, only run the dishwasher
when it is full.
Program
Drying
Detergent
container Duration
of wash
program
(h:min)*)
Water
consumption
(litres/cycle)
Energy
consumption
(kWh/cycle)
Tub B
1 Eco 50° 3:20 12 1,04
2 Intensive 65° - 2:30 15,0 1,50
3 Normal 55° - 2:00 15,0 1,35
4 Rapid 40’ 50° - - 0:40 9,0 0,90
5 Half Load 50° - 1:20 12,0 1,10
6 Pre-Wash - - - - 0:10 4,5 0,01

Product specificaties

Merk: Whirlpool
Categorie: Vaatwasser
Model: WIE 2B19 UK

Heb je hulp nodig?

Als je hulp nodig hebt met Whirlpool WIE 2B19 UK stel dan hieronder een vraag en andere gebruikers zullen je antwoorden


Handleiding Vaatwasser Whirlpool

Whirlpool

Whirlpool WSFC 3M27 X Handleiding

19 Maart 2024
Whirlpool

Whirlpool ADG 6999 FD Handleiding

4 Maart 2024
Whirlpool

Whirlpool Nutid DWN 600 Handleiding

10 Februari 2024
Whirlpool

Whirlpool W7F HS41 X Handleiding

18 Januari 2024
Whirlpool

Whirlpool WRIC 3C26 PF Handleiding

5 Januari 2024
Whirlpool

Whirlpool WDF332PAMB Handleiding

5 Januari 2024
Whirlpool

Whirlpool ADG 9527 Handleiding

20 Oktober 2023
Whirlpool

Whirlpool Renlig DWF A00 Handleiding

14 September 2023
Whirlpool

Whirlpool DWF 406 Handleiding

11 September 2023
Whirlpool

Whirlpool W7U HS31 X Handleiding

29 Augustus 2023

Handleiding Vaatwasser

Nieuwste handleidingen voor Vaatwasser

Neff

Neff S299ZB802E Handleiding

2 Mei 2024
Siemens

Siemens SN636X06KE Handleiding

29 April 2024
Bauknecht

Bauknecht B7I HF60 TUS Handleiding

27 April 2024
Bosch

Bosch SMS6TCW00E Handleiding

27 April 2024
Bosch

Bosch SMV6YCX05E Handleiding

27 April 2024
Bosch

Bosch SMI4EAS09E Handleiding

27 April 2024
IKEA

IKEA RÅGLANDA 005.680.35 Handleiding

25 April 2024
IKEA

IKEA LAGAN 005.680.16 Handleiding

25 April 2024
Omega

Omega ODWIF6015 Handleiding

25 April 2024
Bosch

Bosch SMV45AX00N Handleiding

21 April 2024