Whirlpool UDT518SAF Handleiding

Bekijk gratis de handleiding van Whirlpool UDT518SAF (2 pagina’s), behorend tot de categorie Vaatwasser. Deze gids werd als nuttig beoordeeld door 104 mensen en kreeg gemiddeld 4.2 sterren uit 3 reviews. Heb je een vraag over Whirlpool UDT518SAF of wil je andere gebruikers van dit product iets vragen? Stel een vraag

Undercounter Dishwasher

PRODUCT MODEL NUMBERS

UDT518SAFP

Location Requirements

There must be a minimum of 255/8" (65.1 cm) in front of

dishwasher to allow door to open fully.

Countertop

Dishwasher

2" (5.1 cm) min.

clearance for door

opening

255/8"

(65.1 cm)

Electrical Requirements

■

120 volt, 60 Hz, AC-only, 15 or 20 amp., fused electrical supply

■

Wiring must be 2-wire with ground

We recommend:

■

A time-delay fuse or circuit breaker

■A separate circuit

Drain Requirements

■

Use the new drain hose supplied with your dishwasher. If this is

not long enough, use a new drain hose with a maximum length

of 10 ft (3.05 m) that meets all current AHAM/IAPMO test

standards, is resistant to heat and detergent, use 5/8" (1.58 cm)

or 7/8" (2.2 cm) inside diameter hose and a coupler to connect

the two hose ends. Secure the connection with 2 clamps.

■Connect drain hose to waste tee or disposer inlet above drain

trap in house plumbing and 32" (81.3 cm) minimum above the

floor. It is recommended that the drain hose either be looped

up and securely fastened to the underside of the counter, or be

connected to an air gap.

■Use an air gap if the drain hose is connected to house

plumbing lower than 18" (45.7 cm) above floor.

■

Air gap

Use 1/2" minimum I.D. drain line fittings.

■Do not connect drain lines from other devices to the

dishwasher drain hose.

Water Supply Requirements

■A hot water line with 20-120 psi (138-862 kPa) water pressure.

■

120°F (49°C) water at dishwasher.

■3/8" O.D. copper tubing with compression fitting or flexible

stainless steel braided fill line (1/2" minimum plastic tubing is

not recommended).

■A 90° elbow with 3/8" N.P.T. external pipe threads on one end.

Do not solder within 6 (15.2 cm) from water inlet valve."

Product Dimensions

21/2"

(6.2 cm)

22" (59 cm)*

18"

(45.7 cm)

321/2" (82.6 cm) min.

35" (88.9 cm) max.

*To front of door frame

SIDE VIEW

171/

2" (44.5 cm min.

18"(45.7 cm) max.

REAR VIEW

Because Whirlpool Corporation policy includes a continuous commitment

to improve our products, we reserve the right to change materials and

specifications without notice.

Dimensions are for planning purposes only. For complete details, see

Installation Instructions packed with product. Specifications subject to

change without notice.

Page 1 of 2

W10702387-D-WH

5/16

Product specificaties