Whirlpool AWZ 8477 Handleiding

Whirlpool Wasdroger AWZ 8477

Lees hieronder de 📖 handleiding in het Nederlandse voor Whirlpool AWZ 8477 (9 pagina's) in de categorie Wasdroger. Deze handleiding was nuttig voor 12 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/9

CONTENTS

QUICK REFERENCE GUIDE

PROGRAMME CHART

PREPARING THE LAUNDRY

SELECTING A PROGRAMME AND OPTIONS

STARTING AND COMPLETING A PROGRAMME

CHANGING A PROGRAMME

INTERRUPTING A PROGRAMME

DAILY MAINTENANCE AND CLEANING

INSTRUCTIONS FOR USE

BOOKLET

SAFETY ADVICES BEFORE USING THE

DRYER / CONNECTIONS PAGE 4

ELECTRICAL CONNECTION PAGE 5

SAFETY ADVICES AND GENERAL

RECOMMENDATIONS PAGE 6

DESCRIPTION OF THE DRYER PAGE 7

REMINDER - MAINTENANCE AND CLEANING PAGE 7

DRAINAGE SYSTEM PAGE 8

DOOR REVERSIBILITY / CHILD SAFETY LOCK PAGE 9

HEAT EXCHANGER PAGE 10

TROUBLESHOOTING GUIDE /

AFTER-SALES SERVICE PAGE 11

SAFETY ADVICES BEFORE USING THE

DRYER / CONNECTIONS

1. Removing the packaging and check

•After unpacking, make sure that the dryer is

undamaged. If in doubt, do not use the dryer.

Contact After-Sales Service or your local retailer.

•If the appliance was exposed to the cold prior to

delivery, keep it at room temperature for a few

hours before operating.

•Keep the packaging materials (plastic bags,

polystyrene parts, etc.) out of reach of children, as

they are potentially dangerous.

•Remove the protective foil from the control panel.

2. Electrical Connections

•Electrical connections must be carried out by a

qualified technician in compliance with the

manufacturer’s instructions and current standard

safety regulations.

•Electrical connection must comply with local

Electricity Board regulations.

•Voltage information, power consumption and the

required fuse protection is shown on the rating

plate mounted at the rear of the dryer.

•The manufacturer cannot accept any liability for

personal injury or damage to property resulting

from failure to adhere to these instructions.

•The dryer must be earthed as prescribed by law.

•Do not use extension leads or multiple adaptors.

•Before any maintenance on the dryer disconnect it

from the mains supply.

•Do not operate the dryer if it has been damaged

during transport. Contact one of our After-Sales

Service technicians.

•Mains cable replacement is only to be carried out by

After-Sales Service.

•After installation access to the mains plug has to be

guaranteed, or the all-pole disconnection has to be

possible with a switch.

3. Installation

•The appliance must not be installed behind a

lockable door, a sliding door or a door with a hinge

on the opposite side to that of the tumble dryer.

•Do not install your dryer where it can be subject to

extreme conditions, such as: poor ventilation,

temperatures below 5°C or above 35°C.

•Before running the first cycle ensure the water

container and heat exchanger are correctly positioned.

•Only for water container top version: if possible use

a hose to drain the water directly into the domestic

plumbing system. This will avoid having to empty

the water container at the end of each drying cycle

since the condensation water can be directly

drained away. See also chapter “Drainage System”.

•Take care not to install the dryer on a deep-pile

carpet.

•Take care not to trap the mains cable between the

dryer and the wall.

Stability:

When installing the dryer always carefully level the

dryer adjusting the four feet and check the correct

levelling with a spirit level.

To built in the dryer

Remove the work-top and replace it with the Built-

In kit (according to Eec Electrical Regulations),

available at your dealer. As prescribed by law, only

a qualified technician has to do the installation.

Stacking kit

Depending on the model, your dryer can be

stacked on top of your front loading washing

machine. Please contact your dealer or our

After-Sales Service.

Minimum housing dimensions:

Width: 600 mm

Height: 855 mm

Depth: 600 mm

ELECTRICAL CONNECTION

1) For Great Britain only

Warning - this appliance must be earthed

Fuse replacement

If the mains lead of this appliance is fitted with a BS 1363A 13amp

fused plug, to change a fuse in this type of plug use an A.S.T.A.

approved fuse to BS 1362 type and proceed as follows:

1. Remove the fuse cover (A) and fuse (B).

2. Fit replacement 13A fuse into fuse cover.

3. Refit both into plug.

Important:

The fuse cover must be fuse and if the fuse refitted when changing a

cover is lost the plug must not be used until a correct replacement is

fitted.

Correct replacement are identified by the colour insert or the colour

embossed in words on the base of the plug.

Replacement fuse covers are available from your local electrical

store.

2) For the Republic of Ireland only

The information given in respect of Great Britain will frequently

apply, but a third type of plug and socket is also used, the

2-pin, side earth type.

3) Socket outlet / plug (valid for both countries)

If the fitted plug is not suitable for your socket outlet, please contact

Whirlpool Service for further instruction. Please do not attempt to

change plug yourself. This procedure needs to be carried out by a

qualified Whirlpool technician in compliance with the manufactures

instructions and current standard safety regulations.

Product specificaties

Merk:	Whirlpool
Categorie:	Wasdroger
Model:	AWZ 8477
Apparaatplaatsing:	Vrijstaand
Kleur van het product:	Wit
Deurscharnieren:	Rechts
Ingebouwd display:	Nee
Breedte:	600 mm
Diepte:	596 mm
Hoogte:	850 mm
Type lader:	Voorbelading
Droogsysteem:	Condensatie
Uitgestelde start timer:	Ja
Startvertraging:	9 uur
Maximale centrifugesnelheid:	- RPM
Nominale capaciteit (wassen):	8 kg
Nominale capaciteit:	7 kg