Whirlpool AWO/R 4205/1 Handleiding

Whirlpool Wasmachine AWO/R 4205/1

Lees hieronder de 📖 handleiding in het Nederlandse voor Whirlpool AWO/R 4205/1 (12 pagina's) in de categorie Wasmachine. Deze handleiding was nuttig voor 43 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/12

GB 1

INTENDED USE

This washing machine is exclusively destined to wash

and spin machine washable laundry in quantities

which are usual for private households.

• Observe the instructions given in these

Instructions for Use and the Programme Chart

when using the washing machine

• Keep these Instructions for Use and the

Programme Chart; if you pass on the washing

machine to another person, also give him/her

Instructions for Use and Programme Chart.

SAFETY AND GENERAL RECOMMENDATIONS

1. Safety instructions

• The washing machine is

appropriate for indoor use only.

• Do not store ﬂammable ﬂuids

near the appliance

• Children must not be allowed to

play with the washing machine

or to climb into the drum.

• The washing machine can be

operated by children from the

age of 8 years up, as well as by

people with reduced physical,

sensory or mental capabilities or

lack of experience and knowledge,

provided they are supervised or

instructed regarding the safe use

of the washing machine and they

understand the dangers resulting

from the use.Children must not

play with the washing machine.

Care and maintenance works on

the washing machine must not

be carried out by children without

being supervised.

• Do not operate the washing

machine at temperatures below

5°C.

• For freestanding models: if you

want to place a dryer on top

of your washing machine, ﬁrst

contact our After-Sales Service

or your specialist dealer to

verify if this is possible. This

is only admitted if the dryer is

ﬁxed on the washing machine

by using an appropriate

stacking kit available through

our After-Sales Service or your

specialist dealer.

• Do not leave the appliance

plugged in when not in use.

• Turn off the tap when not in

use.

• Before any cleaning and

maintenance switch off the

machine or disconnect it from

the mains supply.

• Never open the door forcibly or

use it as a step.

• If necessary, the power cable

may be replaced with an

identical one obtained from our

After-Sales Service. The power

cable must only be replaced by

a qualiﬁed technician or by our

After-Sales Service.

• If your washing machine is a

built-in model:

do not operate it unless it is

built-in

you must not remove the up

cover.

2. Packing

• The packaging materials are 100% recyclable

and bear the recycling symbol . Adhere to local

regulations when disposing of packaging material.

3. Disposing of packaging and old

washing machines

• The washing machine is built from reusable

materials. It must be disposed of in compliance

with current local waste disposal regulations.

• Before scrapping, remove all detergent residues

and cut off the power cable so that the washing

machine is made unusable.

• This appliance is marked according to the

European directive 2002/96/EC on Waste

Electrical and Electronic Equipment (WEEE). By

ensuring this product is disposed of correctly, you

will help prevent potential negative consequences

for the environment and human health, which

could otherwise be caused by inappropriate waste

handling of this product.

GB 2

• The symbol on the product, or on the

documents accompanying the product, indicates

that this appliance may not be treated as

household waste. Instead it shall be handed over

to the applicable collection point for the recycling

of electrical and electronic equipment. Disposal

must be carried out in accordance with local

environmental regulations for waste disposal.

For more detailed information about treatment,

recovery and recycling of this product, please

contact your local city ofﬁce, your household waste

disposal service or the shop where you purchased

the product.

4. Frost

• Do not place the washing machine in a room

prone to frost. If you must, make sure that the

washingmachine is completely drained after each

wash:

• Remove inlet hose(s) from water tap and let the

water ﬂow out completely.

• Remove drain hose from siphon or handwash

basin and let the water ﬂow out completely.

• Empty residual water inside the machine by

following the instructions in the chapter “Draining

Residual Water”; for freestanding models: tilt the

appliance forward with two persons to let the rest

water ﬂow out completely.

5. EC Declaration of Conformity

• The appliance conforms to the following European

Standards: 2006/95/EC Low Voltage Directive

2004/108/EC Electromagnetic Compatibility

Directive.

The Manufacturer is not liable for any damage to

laundry resulting from inadequate or incorrect fabric

care instructions which have been provided with the

garment or article.

BEFORE USING THE WASHING MACHINE

1. Removing the packaging and

inspection

• After unpacking, make sure that the washing

machine is undamaged. If in doubt, do not use the

washing machine. Contact After-Sales Service or

your local retailer.

• Keep the packaging materials (plastic bags,

polystyrene parts, etc.) out of reach of children, as

they are potentially dangerous.

• If the appliance was exposed to the cold prior to

delivery, keep it at room temperature for a few

hours before operating.

2. Remove the transport bolts

• The washing machine is ﬁtted with transport

bolts to avoid any possible damage to the interior

during transport. Before using the machine, it is

imperative that the transport bolts are removed.

• After their removal, cover the openings with the 4

enclosed plastic caps.

3. Install the washing machine

• Remove the protective ﬁlm from the control panel

(if available on your model).

• Move the appliance without lifting it by the worktop.

• Install the appliance on a solid and level ﬂoor

surface, preferably in a corner of the room.

• Make sure that all four feet are stable and resting

on the ﬂoor and then check that the washing

machine is perfectly level (use a spirit level).

• In case of wooden or so-called “ﬂoating ﬂoors” (for

instance certain parquet or laminate ﬂoors), place

the appliance on a sheet of plywood at least 60 x

60 cm wide/deep and at least 3 cm thick which is

secured to the ﬂoor.

• Make sure that the ventilation openings in the

base of your washing machine (if available on your

model) are not obstructed by a carpet or other

material.

4. Water inlet

• Connect the water inlet hose(s) to the drinking

water supply in accordance with the regulations of

your local water company.

• For models with one inlet valve: cold water

• For models with two inlet valves: cold AND hot

water, or cold water only (see chapter “Installation

Guide”).

• Water tap: 3/4” threaded hose connector

• Water pressure (ﬂow pressure): 100-1000 kPa

(1-10 bar).

• Use only new hoses to connect the washing

machine to the water supply. Used hoses must not

be used and should be discarded.

• For models with hot ﬁll: the hot water inlet

temperature must not exceed 60°C.

5. Drain

• Firmly connect the drain hose to the siphon, or

another outlet for drain water.

• If the washing machine is connected to an

integrated drainage system, ensure the latter is

equipped with a vent to avoid simultaneous load-

ing and draining of water (siphoning effect).

6. Electrical connection

• Electrical connections must be carried out by a

qualiﬁed technician in compliance with the manu-

facturer’s instructions and current standard safety

regulations.

• Data regarding voltage, power consumption

andprotection requirements is given on the inside

of the door.

• The appliance must be connected to the mains

by means of a socket with an earth connection in

accordance with current regulations. The washing

machine must be earthed by law. The manufac-

turer declines all liability for damage to property

or injury to persons or animals due to non-compli-

ance with the directions given above.

• Do not use extension leads or multiple sockets.

• Access to the mains plug or disconnection from

the mains supply via a double-pole switch must be

ensured at all times after the installation.

• Do not operate the washing machine if it has been

damaged during transport. Inform the After-Sales

Service.

• Mains cable replacement is only to be carried out

by After-Sales Service.

• When using a residual current circuit breaker

(RCCB), only use a model marked with .

Product specificaties

Merk:	Whirlpool
Categorie:	Wasmachine
Model:	AWO/R 4205/1

Heb je hulp nodig?

Als je hulp nodig hebt met Whirlpool AWO/R 4205/1 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden

Uw naam*

Jouw email*

Schrijf hier uw vraag

Handleiding Wasmachine Whirlpool

Whirlpool ZEN FSCR70421 Handleiding

21 April 2024

Whirlpool FDLR80250 Handleiding

17 April 2024

Whirlpool Champion 1400 Handleiding

15 Maart 2024

Whirlpool WB90805 Handleiding

28 Februari 2024

Whirlpool WDFS3R4P Handleiding

26 Februari 2024

Whirlpool WDFS3R4N Handleiding

26 Februari 2024

Whirlpool WDFS3L5P Handleiding

26 Februari 2024

Whirlpool Primo 1406 Handleiding

31 December 2023

Whirlpool Universe 1400 Handleiding

17 December 2023

Whirlpool AWO-D 7324 Handleiding

23 Oktober 2023

Handleiding Wasmachine

Nieuwste handleidingen voor Wasmachine

Winia WVD-A08T1WK14B Handleiding

28 April 2024

Continental Edison CELL7140IB Handleiding

28 April 2024

Bauknecht WAT Smart Eco 12C Handleiding

27 April 2024

Bauknecht B7 89 SILENCE EE Handleiding

27 April 2024

BEKO WTE 7512 BSS Handleiding

26 April 2024

MPM -4610-PH-04 Handleiding

25 April 2024

Samsung WW11DB8B95GH Handleiding

25 April 2024

Sôlt GGSFLW800W Handleiding

22 April 2024

Samsung WW90T4540TE Handleiding

18 April 2024

SEIKI SC-800AU9FLMK2 Handleiding

17 April 2024