Whirlpool AWO/D 3100 Handleiding

Whirlpool Wasmachines AWO/D 3100

Lees hieronder de đź“– handleiding in het Nederlandse voor Whirlpool AWO/D 3100 (14 pagina's) in de categorie Wasmachines. Deze handleiding was nuttig voor 45 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/14
CONTENTS
DEFINITION OF USE
BEFORE USING THE WASHING MACHINE
PRECAUTIONS AND GENERAL
RECOMMENDATIONS
DESCRIPTION OF THE WASHING MACHINE
DOOR
CHILD SAFETY (IF AVAILABLE)
BEFORE THE FIRST WASH CYCLE
PREPARATION OF THE WASHING
DETERGENTS AND ADDITIVES
REMOVING THE FILTER/
DRAINING RESIDUAL WATER
CARE AND MAINTENANCE
TROUBLESHOOTING GUIDE
AFTER-SALES SERVICE
ACCESSORIES
TRANSPORT/HANDLING
ELECTRICAL CONNECTION
IFU Delta-Domino_LR-HR-STEAM-GB NEW.fm Page 1 Monday, September 15, 2008 3:59 PM
Black process 45.0° 100.0 LPI
GB 2
DEFINITION OF USE
This washing machine is exclusively destined to
wash machine washable laundry in quantities which
are usual for private households.
•Observe the instructions given in these Instructions
for Use, the Installation Guide and the Programme
Chart when using the washing machine.
•Keep these Instructions for Use, the Programme
Chart and the Installation Guide; if you pass on
the washing machine to another person, also give
him/her Instructions for Use, Programme Chart
and Installation Guide.
BEFORE USING THE WASHING MACHINE
1.Removing the packaging and inspection
•After unpacking, make sure that the washing
machine is undamaged. If in doubt, do not use the
washing machine. Contact After-Sales Service or
your local retailer.
•Check that the accessories and supplied parts are
all present.
•Keep the packaging materials (plastic bags,
polystyrene parts, etc.) out of reach of children,
as they are potentially dangerous.
•If the appliance was exposed to the cold prior to
delivery, keep it at room temperature for a few
hours before operating.
2.Remove the transport bolts
•The washing machine is fitted with transport
bolts to avoid any possible damage to the interior
during transport. Before using the machine, it is
imperative that the transport bolts are removed.
•After their removal, cover the openings with the
4 enclosed plastic caps.
3.Install the washing machine
•Remove the protective film from the control panel
(if available on your model).
•Move the appliance without lifting it by the worktop.
•Install the appliance on a solid and level floor
surface, preferably in a corner of the room.
•Make sure that all four feet are stable and resting
on the floor and then check that the washing
machine is perfectly level (use a spirit level).
•In case of wooden or so-called “floating floors”
(for instance certain parquet or laminate floors),
place the appliance on a 60 x 60 cm sheet of
plywood at least 3 cm in thickness which is
secured to the floor.
•Make sure that the ventilation openings in the
base of your washing machine (if available on
your model) are not obstructed by a carpet or
other material.
4.Water inlet
•Connect the water supply inlet hose in
accordance with the regulations of your local
water company.
•Water inlet: Cold water only
(if no other information on
your programme chart)
•Water tap: 3/4” threaded hose
connector
•Water pressure
(flow pressure): 100-1000 kPa (1-10 bar).
•Use only new hoses to connect the washing
machine to the water supply. Used hoses must
not be used and should be discarded.
5.Drain
•Connect the drain hose to the siphon or hook it
over the edge of a sink by means of the “U” bend
supplied.
•If the washing machine is connected to an
integrated drainage system, ensure the latter is
equipped with a vent to avoid simultaneous
loading and draining of water (siphoning effect).
6.Electrical connection
•Electrical connections must be carried out by a
qualified technician in compliance with the
manufacturer’s instructions and current standard
safety regulations.
•Data regarding voltage, power consumption and
protection requirements is given on the inside of
the door.
•The appliance must be connected to the mains by
means of a socket with an earth connection in
accordance with current regulations. The
washing machine must be earthed by law. The
manufacturer declines all liability for damage to
property or injury to persons or animals due to
non-compliance with the directions given above.
•Do not use extension leads or multiple sockets.
•Before any maintenance on the washing machine
disconnect it from the mains supply.
•After installation, access to the mains plug or to
disconnection from mains supply must be
ensured at all times via a double-pole switch.
•Do not operate the washing machine if it has
been damaged during transport. Inform the
After-Sales Service.
•Mains cable replacement is only to be carried out
by After-Sales Service.
•The appliance must only be used in the
household for the prescribed uses.
Minimum housing dimensions:
Width: 600 mm
Height: 850 mm
Depth: 600 mm
IFU Delta-Domino_LR-HR-STEAM-GB NEW.fm Page 2 Monday, September 15, 2008 3:59 PM
Black process 45.0° 100.0 LPI
GB 3
PRECAUTIONS AND GENERAL
RECOMMENDATIONS
1.Safety instructions
•The washing machine is appropriate for indoor
use only.
•Do not store flammable fluids near the appliance.
•Children must not be allowed to play with the
washing machine or to climb into the drum (see
also the following page chapter “Child Safety”).
•This appliance is not intended for use by persons
(including children) with reduced physical, sensory
or mental capabilities, or lack of experience and
knowledge, unless they have been given
supervision or instruction concerning use of the
appliance by a person responsible for their safety.
•If you want to place a dryer on top of your
washing machine, first contact our After-Sales
Service or your specialist dealer to verify if this is
possible. Placing a dryer on your washing
machine is only admitted if the dryer is fixed on
the washing machine by using an appropriate
stacking kit available through our After-Sales
Service or your specialist dealer.
•Do not leave the appliance plugged in when not
in use.
•Turn off the tap when not in use.
•Before any cleaning and maintenance switch off
the machine or disconnect it from the mains.
•Never open the door forcibly or use it as a step.
•If necessary, the power cable may be replaced
with an identical one obtained from our After-
Sales Service. The power cable must only be
replaced by a qualified technician.
2.Packaging
•The packaging material is entirely recyclable, and
marked with the recycling symbol . Adhere
to current local regulations when disposing of
packaging material.
3.Disposing of packaging and scrapping
old washing machines
•The washing machine is built from reusable
materials. It must be disposed of in compliance
with current local waste disposal regulations.
•Before scrapping, remove all detergent residues
and cut off the power cable so that the washing
machine is made unusable.
•This appliance is marked according to the
European directive 2002/96/EC on Waste
Electrical and Electronic Equipment (WEEE).
By ensuring this product is disposed of correctly,
you will help prevent potential negative
consequences for the environment and human
health, which could otherwise be caused by
inappropriate waste handling of this product.
The symbol on the product, or on the
documents accompanying the product, indicates
that this appliance may not be treated as
household waste. Instead it shall be handed over
to the applicable collection point for the recycling
of electrical and electronic equipment.
Disposal must be carried out in accordance with
local environmental regulations for waste disposal.
For more detailed information about treatment,
recovery and recycling of this product, please
contact your local city office, your household
waste disposal service or the shop where you
purchased the product.
4.Energy saving
The water consumption of your washing machine is
optimized; in some programmes you therefore
cannot see the water through the door glass when
the machine is in operation.
•Achieve the best use of energy, water, detergent
and time by using the recommended maximum
load size.
•Do not exceed the detergent dosages indicated
in the manufacturer’s instructions.
•The Eco-Ball - a special system in the outlet - will
prevent detergent loss from the drum to avoid
detergent loss into the environment.
•Use “Prewash” (if available on your model) for
heavily soiled laundry only! Save detergent, time,
water and energy consumption by not selecting
“Prewash” for slightly to normally soiled laundry.
•Pretreat stains with stain remover or soak dried-
in stains in water before washing to reduce the
necessity of a hot wash programme.
•Save energy by using a 60° C instead of a 95° C
wash programme or a 40° C instead of a 60° C
wash programme.
•Save energy and time by selecting a high spin
speed to reduce the water content in laundry
before using a tumble dryer (for machines with
adjustable spin speed).
5.EC Declaration of Conformity
•The appliance conforms to the following
European Standards:
2006/95/EC Low Voltage Directive
2004/108/EC Electromagnetic Compatibility
Directive
IFU Delta-Domino_LR-HR-STEAM-GB NEW.fm Page 3 Monday, September 15, 2008 3:59 PM
Black process 45.0° 100.0 LPI


Product specificaties

Merk: Whirlpool
Categorie: Wasmachines
Model: AWO/D 3100

Heb je hulp nodig?

Als je hulp nodig hebt met Whirlpool AWO/D 3100 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Wasmachines Whirlpool

Handleiding Wasmachines

Nieuwste handleidingen voor Wasmachines