Whirlpool AWM 1019 Handleiding


Lees hieronder de đź“– handleiding in het Nederlandse voor Whirlpool AWM 1019 (16 pagina's) in de categorie Wasmachine. Deze handleiding was nuttig voor 62 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/16
INSTRUCTIONS FOR USE
DEFINITION OF USE
BEFORE USING THE WASHING MACHINE
FIRST WASH CYCLE
PRECAUTIONS AND GENERAL RECOMMENDATIONS
DESCRIPTION OF THE WASHING MACHINE
CHILD SAFETY
DETERGENTS AND ADDITIVES
DRAINING RESIDUAL WATER
REMOVING THE FILTER
CARE AND MAINTENANCE
TROUBLESHOOTING GUIDE
AFTER-SALES SERVICE
TRANSPORT AND HANDLING
ACCESSORIES
INSTALLATION
ELECTRICAL CONNECTION
DEFINITION OF USE
This appliance is exclusively destined to wash and
spin machine washable laundry in private
households.
•Observe the instructions given in these Instructions
for Use and in the separate Programme Chart when
using the washing machine.
•Keep these Instructions for Use and the Programme
Chart; if you pass on the washing machine to
another person, also give him/her the Instructions
for Use and the Programme Chart.
BEFORE USING THE WASHING MACHINE
1.Remove the packaging and check
•After unpacking, make sure that the washing
machine is undamaged. If in doubt, do not use
the washing machine. Contact After-Sales
Service or your local dealer.
•Keep the packaging materials (plastic bags,
polystyrene parts, etc.) out of reach of children,
since it is a possible source of danger.
•If the appliance was exposed to the cold prior to
delivery, keep it at room temperature for a few
hours before operating.
2.Remove the transit bolts
•The appliance is fitted with transit bolts to
prevent internal damage during transport.
Before using the washing machine you must
remove the transit bolts (see “Installation”/
”Remove the transit bolts”).
3.Install the washing machine
•Install the appliance on a solid and level floor
surface. In the case of a yielding sub-floor, the
appliance should be installed in the corner of a
room.
•Adjust the feet to ensure that the machine is
stable and level on the floor (see “Installation”/
”Adjust the feet”).
•In case of wooden or so-called “floating floors”
(for instance certain parquet or laminate floors),
place the appliance on a 70 x 70 cm sheet of
plywood at least 3 cm in thickness. The plywood
sheet must be screwed to the floor.
•Make sure that the ventilation openings in the
base of your washing machine (if available on
your washer) are not obstructed by a carpet or
other material.
4.Water inlet
•Connect the water supply inlet hose in accordance
with the regulations of your local water company
(see “Installation”/”Connect the water supply
hose(s)” and instructions on the hose bag).
• Water supply: Cold water only (if no other
information on programme
chart)
• Tap: 3/4” threaded hose connection
• Pressure: 100-1000 kPa (1-10 bar).
•Use only new hoses to connect the washing
machine to the water supply. Used hoses must
not be used and should be discarded.
5.Drain hose
•Connect the drain hose to the ventilated siphon or
hook it over the edge of a sink by means of the “U”
bend and secure it against falling down (see
“Installation”/“Connect the water drain hose”).
6.Electrical connections
•Electrical connections must be carried out by a
qualified electrician in compliance with the
manufacturer's instructions and local safety
regulations.
•Voltage information, power consumption and
electrical fusing data are supplied on the front
panel behind the door frame.
•The appliance must be connected to the mains
exclusively by means of a socket with an earth
connection in accordance with established
regulations. The appliance must be earthed by
law. The manufacturer declines all liability for
possible damage to property or injury to persons
or pets deriving from failure to observe the a/m
directions.
•Do not use extension leads or multi sockets.
•Before any maintenance on the washing
machine disconnect the power plug or switch off
the power supply.
•Access to the mains plug or to disconnection from
mains supply via a double-pole switch must be
ensured at all times following the installation.
•Do not operate the washing machine if it has
been damaged during transport. Inform the
After-Sales Service.
•Mains cable replacement is only to be carried out
by After-Sales Service.
•The washing machine must only be used in the
household for the prescribed uses.
FIRST WASH CYCLE
PRECAUTIONS AND GENERAL RECOMMENDATIONS
1.Safety Instructions
•This washing machine is not intended for use by
persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience
and knowledge, unless they have been given
supervision or instruction concerning use of the
appliance by a person responsible for their safety.
•The appliance must not be operated by children.
•Other appliances must NOT be placed on the
washing machine's worktop (e.g. tumble dryer,
water heater etc.).
•The washing machine is appropriate for indoor
use only.
•Do not store or use flammable fluids near the
washing machine.
•Never use the filter cover, the front panel or the
detergent dispenser to lift the appliance.
2.Packaging
•The packaging is 100% recyclable and is marked
with the recycling symbol . Adhere to
current local regulations when disposing of
packaging material.
3.Disposing of packaging and old appliances
•This appliance is marked according to the
European directive 2002/96/EC on Waste
Electrical and Electronic Equipment (WEEE).
By ensuring this product is disposed of correctly,
you will help prevent potential negative
consequences for the environment and human
health, which could otherwise be caused by
inappropriate waste handling of this product.
The symbol on the product, or on the
documents accompanying the product, indicates
that this appliance may not be treated as
household waste. Instead it shall be handed over
to the applicable collection point for the
recycling of electrical and electronic equipment.
Disposal must be carried out in accordance with
local environmental regulations for waste disposal.
For more detailed information about treatment,
recovery and recycling of this product, please
contact your local city office, your household
waste disposal service or the shop where you
purchased the product.
•Before scrapping, pull out the mains plug and
cut off the power cable so that the washing
machine becomes unusable.
•The detergent residues should also be removed
from the detergent dispenser, the drum, the
water drain hose and pump before the washing
machine is scrapped. The detergent residues
might otherwise get into the groundwater
during the disposal process and contaminate it.
4.General recommendations
•Never leave the appliance switched on
unnecessarily. Turn off the tap.
•Before any cleaning and maintenance pull out
the mains plug or switch off the power supply.
•Never force the door open.
•If necessary, the power cable may be replaced
with an identical one obtained from our After-
Sales Service. The power cable must only be
replaced by a qualified technician.
5.EC Declaration of Conformity
•This washing machine has been designed,
constructed and distributed in compliance with
EC safety requirements:
2006/95 EC Low Voltage Directive
2004/108/EC Electromagnetic Compatibility
Directive
We recommend that the first wash cycle be made without laundry.
This will remove any residual water used by the manufacturer in testing your washing machine.
1.Turn on the tap.
2.Close the appliance door.
3. Pour a small amount of detergent (about 30 ml) into the detergent dispenser .
4.
Select a short wash
programme (see
programme chart).
5.Press the “Start (Pause)” button.


Product specificaties

Merk: Whirlpool
Categorie: Wasmachine
Model: AWM 1019

Heb je hulp nodig?

Als je hulp nodig hebt met Whirlpool AWM 1019 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Wasmachine Whirlpool

Handleiding Wasmachine

Nieuwste handleidingen voor Wasmachine