Vonyx SWP18 Handleiding

Vonyx Subwoofer SWP18

Lees hieronder de 📖 handleiding in het Nederlandse voor Vonyx SWP18 (8 pagina's) in de categorie Subwoofer. Deze handleiding was nuttig voor 66 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/8

INSTRUCTION MANUAL

HANDLEIDING

MODE D’EMPLOI

BEDIENUNGSANLEITUNG

MANUAL DE INSTRUCCIONES

V1.3

2 - 8

Basis aansluiting /Basic connections / Connexions de base / Grundanschlüsse / Conexiones básicas:

Control panel / Bedieningspaneel / Panneau de commande / Bedienfeld / Panel de control:

Ordercode: 170.823 170.826  

Type:SWP15 SWP18 

Peakpower800W 1200W 

Powermax.400W 600W 

Frequencyresponse40Hz‐250Hz40Hz‐250Hz

SPL @ 1W/1m116dB 120dB 

Signalto noise ratio>80dB >80dB 

Woofer15" 18"(38cm) (46cm)

TophatYes Yes 

ConnectorXLR XLR‐RCA ‐RCA

Dimensions

400 470 x x

530mm

435 550 x x

615mm

Weight19.9kg 26.85kg 

3 - 8

SAFETY INSTRUCTIONS

 Hearing damage: Loudspeakers are easily

capable of generating high sound pressure levels

(SPL) sufficient to cause permanent hearing

damage to performers, production crew and

audience members. Caution should be taken to

avoid prolonged exposure to SPL in excess of 90

dB.

 Do not overload the box to avoid damage to the

speakers.

 Do not place an open fire (candle, etc.) on top or

next to the box - FIRE HAZARD

 Only connect to an earthed mains outlet of

230Vac/50Hz.

 For indoor use only. If the box is used outdoors,

you need to make sure that no humidity can enter

the box.

 When not in use, unplug the unit from the mains.

 Unplug the unit from the mains prior to checking

or replacing the fuse.

 Make sure that the box is placed on a stable,

strong surface.

 The boxes can be stacked but do not put more

than 60kg weight on the box.

 The boxes can be hung. Use only strong and

approved mounting material. During the mounting,

make sure that nobody is standing below the

mounting area.

 Place the stand always on a flat, level, and stable

surface and that the legs do not present a trip

hazard.

 Use only stands which are designed to support

the weight of the speaker. Do not attempt to place

more than one speaker on a stand designed for a

single speaker.

 Route cables so that peoples will not trip over

them pulling the speaker over.

 Do not place liquids on the box and protect it

against humidity. Humidity can shorten the life

time considerably.

 Only use suitable means of transportation if you

want to move the box – BEWARE OF YOUR

BACK !!

 If the unit is damaged to an extent that you can

see internal parts, do not plug the unit in a mains

outlet. In this case, please contact Tronios.

 Always unplug the unit during a thunderstorm or

when it is not in use.

 If the unit has not been used for a longer period of

time, condensation can occur inside the housing.

Please let the unit reach room temperature prior

to use.

 Never try to repair the unit yourself. It does not

contain any user serviceable parts.

 Run the mains lead in such a way that nobody

can fall over it and nothing can be put on it.

 Only use the supplied mains lead or another lead

recommended by Vonyx .

 Set the unit to the lowest volume prior to switching

it on

 Keep the unit out of the reach of children.

Protect your environment. Recycle packing

material whenever possible.

Do not throw a faulty unit into normal

household waste but bring it to a special

collection point. A large part of it can be

recycled.

CONNECTIONS: (see illustration on page 1)

1. XLR Line input/output

right channel

2. XLR Line input/output

left channel

3. Ground lift switch

4. RCA Line input/output

5. ON/OFF switch

6. Mains inlet

7. Crossover frequency

control

8. Phase control

9. Volume control

Make sure that the subwoofer and audio source (mixer, CD player, etc.) are switched off prior to making the

connections. Connect the line output of your audio source to the line input (1/2) of the subwoofer. The

connections must be made firmly to prevent noise. If you want to connect a second active speaker or

subwoofer, you can connect it to the line output (1/2). Connect the mains lead to the IEC socket (6) and the

other end to a normal mains outlet. Turn the volume control (9) fully counter clockwise to the lowest level.

Switch the audio source on at first and then the subwoofer (5). Set the filter frequency (7) to the frequency range

that suits your satellite speakers. Turn to the left for less basses and to the right for more basses. Finally set the

volume (9). Turn to the left for lower volume and to the right for higher volume. If the sound of the subwoofer is

not in phase with the satellite speakers, you can turn it at 180° via switch (8).

Do not attempt to make any repairs yourself. This would invalid your warranty. Do not make any changes to the unit. This would

also invalid your warranty. The warranty is not applicable in case of accidents or damages caused by inappropriate use or

disrespect of the warnings contained in this manual. Tronios cannot be held responsible for personal injuries caused by a

disrespect of the safety recommendations and warnings. This is also applicable to all damages in whatever form.

Product specificaties

Merk:	Vonyx
Categorie:	Subwoofer
Model:	SWP18
Kleur van het product:	Zwart
Gebruikershandleiding:	Ja
Type stroombron:	AC
Gemiddeld vermogen subwoofer:	1200 W
Diameter driver subwoofer (imperiaal):	18 "
Subwoofertype:	Actieve subwoofer
Frequentiebereik subwoofer:	40 - 250 Hz
Breedte van de subwoofer:	550 mm
Hoogte van de subwoofer:	615 mm
Diepte van de subwoofer:	435 mm
Gewicht subwoofer:	26850 g
Subwoofer sensitiviteit:	112 dB
XLR in:	Ja
Fase verandering:	0 - 180 °