Vollrath MIX1020CE Handleiding

Bekijk gratis de handleiding van Vollrath MIX1020CE (2 pagina’s), behorend tot de categorie Niet gecategoriseerd. Deze gids werd als nuttig beoordeeld door 14 mensen en kreeg gemiddeld 4.7 sterren uit 8 reviews. Heb je een vraag over Vollrath MIX1020CE of wil je andere gebruikers van dit product iets vragen? Stel een vraag

Item No. 2350053-1 Rev 07/10

Installation Instructions

Meat Grinder Chamber and Components

Assembly and Disassembly

To ensure safe installation and operation, read the following statements

and understand their meaning. Please read carefully.

WARNING

Warning is used to indicate the presence of a hazard that can cause

severe personal injury, death, or substantial property damage if the

warning is ignored.

Safety PrecautionS

WARNING

Electrical Shock Hazard.

Keep water and other liquids from entering the inside of

the unit. Liquid inside the unit could cause an electrical

shock.

Do not spray water or cleaning products. Liquid could contact the

electrical components and cause a short circuit or an electrical shock.

Do not use unit if power cord is damaged or has been modied. Do not

use an extension cord with this unit.

WARNING

Sharp Blade Hazard.

Blades are sharp and can cause cuts and amputation.

To avoid injury from sharp blades, handle with caution. Only trained

personal should operate equipment or preform maintenance.

aSSembly ProcedureS

1. Turn the meat grinder off and unplug from its power source.

2. Thoroughly clean and dry all parts.

3. If necessary assemble the blade shaft (B) into the worm gear (A). See Figure 1.

A

B

Figure 1. Blade Shaft and Worm Gear

4. Inspect the shaft washer (A) for wear. See Figure 2. Replace if necessary.

A

B

Figure 2. Shaft Washer and Worm Gear Shaft

5. Slide the shaft washer (A) onto the worm gear shaft (B).

6. Slide the shaft washer (A) so that it is seated against the worm gear

assembly (B) as shown. See Figure 3.

A

C

B

D

Figure 3. Shaft Washer, Worm Gear Assembly and Grinder Chamber

7. Slide the worm gear assembly (B) and the shaft washer (A) into the grinder

chamber (C). Slide the worm gear shaft (D) in until it is seated fully.

Product specificaties