Volkswagen Jetta (2013) Handleiding

Volkswagen Auto Jetta (2013)

Lees hieronder de 📖 handleiding in het Nederlandse voor Volkswagen Jetta (2013) (4 pagina's) in de categorie Auto. Deze handleiding was nuttig voor 33 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/4

Jump-starting



 Introduction

In this section you’ll find information about:

Using jumper cables

If your engine does not start because the vehicle battery is dead, your vehicle's battery can be

connected to the battery of another vehicle to start your engine (jump-starting). Check the battery acid

level indicator on the vehicle battery before jump-starting .

You must use jumper cables that meet recognized industrial standards (check information provided by

the jumper cable manufacturer). For vehicles with gasoline engines, the cross-section of the jumper

cable wire must be at least 0.038 in.2 (25 mm2), or about 3 ga. (AWG). For vehicles with diesel

engines, the cross-section must be at least 0.054 in2 (35 mm2), or about 2 ga. (AWG).

More information:

 Starting assistance systems

 Preparations for working in the engine compartment

 Vehicle battery

WARNING

Working on the batteries or the electrical system in your vehicle can cause serious acid

burns, fires, or electrical shock.



 Always keep children away from battery acid and vehicle batteries in general.



 Sulfuric battery acid is very corrosive and can cause blindness and damage to

unprotected skin. Never let battery acid or lead particles contact your eyes, skin, and

clothing.



 Never lean over a vehicle battery. Always wear protective gloves and eye protection. To

reduce your risk of injury, never tilt the batteries; acid could spill out through the vents and

burn you.



 A highly explosive mixture of gases is given off when the battery is being charged.



 Always avoid fires, sparks, open flame, and smoking. Never create sparks or electrostatic

charges when handling cables and electrical equipment. Never short-circuit the battery

terminals. High-energy sparks can cause serious personal injury.



 If you get battery acid in your eyes or on your skin, immediately rinse with cold water for

several minutes and get medical attention immediately. If you swallow any battery acid, get

medical attention immediately.

WARNING

Improper use of jumper cables when jump-starting a vehicle with a dead battery can cause

the battery to explode, leading to serious personal injury. To help reduce the risk of battery

explosion:



 All work on the batteries or the electrical system in your vehicle can cause serious acid

burns, fires, or electrical shocks. Always read and heed the following WARNINGS and safety

precautions before working on the batteries or the electrical system , Vehicle battery.



 Always make sure that the battery providing starting assistance (the booster battery) has

the same voltage as the dead battery (12 V) and about the same amperage capacity (see

battery label).



 Never jump-start a vehicle with a thawed or frozen vehicle battery. The battery can

explode. A dead battery can freeze at temperatures around +32 °F (0 °C).



 A battery that is frozen or was frozen, but has since thawed, must be replaced.



 When the vehicle battery is jump-started, it gives off hydrogen gas, which is highly

explosive! Always keep fire, sparks, open flame, and smoking materials far away from vehicle

batteries. Never use a cellular telephone while connecting or disconnecting jumper cables.



 Jump-start batteries only in well-ventilated areas. Batteries give off highly explosive

hydrogen gas during jump-starting.



 Always route the jumper cables so that they cannot get caught in any moving parts in the

engine compartment.



 Never short out the battery terminals by connecting the positive (+) and negative (-)

terminals with each other.



 Never connect the negative cable from the other vehicle directly to the negative terminal

of the dead battery, as this may cause the hydrogen gas given off by the dead battery to

explode.



 Never attach the negative cable from the vehicle providing starting assistance to any part

of the fuel system or to the brake hoses or brake lines.



 Never allow the non-insulated parts of the battery clamps to touch.



 Never allow the jumper cable attached to the positive battery terminal to contact metal

parts of the vehicle.



 Always follow the instructions of the jumper cable manufacturer.

NOTICE

To help prevent extensive damage to the vehicle electrical system, read and heed the

following:



 Connecting jumper cables improperly can cause a short circuit and do expensive damage

to the vehicle's electrical system.



 Do not let the vehicles touch each other while the jumper cables are connected. If they do,

electrical current may flow between the vehicles when the positive (+) terminals are connected,

causing electrical system damage.

Using jumper cables

Fig. 181 Diagram for attaching the jumper cables: Dead battery 1 and booster battery 2.



 Please first read and note the introductory information and heed the WARNINGS .

The dead battery must be properly connected to the vehicle's electrical system.

Make certain that the vehicles are not touching each other. Otherwise, electric current could flow as

soon as the positive terminals (+) are connected. Use longer jumper cables if necessary.

The clamps on the jumper cables must have good contact to bare metal on the battery terminals.

If the engine does not start, stop the process after 10 seconds and repeat after about 1 minute.

The procedure for attaching and for removing the jumper cables is described below. Perform each of

the following steps only in the order described, which follow the letters shown in the illustration

⇒fig. 181 A – B – C – D.

Attaching jumper cables

1. Switch off the ignition in both vehicles .

2. Open the battery cover in the engine compartment if the battery has a cover .

3. Attach one end of the red jumper cable to the positive terminal (+) of the dead battery: (1) ⇒.

4. Attach the other end of the red jumper cable to the positive terminal (+) of the good battery

(booster battery): (2).

5. Attach one end of the black jumper cable to the negative terminal (-) of the booster battery: (2) .

6. Attach the other end of the black jumper cable (3) to a bare metal part of the vehicle with the

dead battery. This part should be connected directly to the engine block. You may also attach the

cable to the engine block itself or to the towing eye installed on the front of the vehicle . Attach the

clamp to a point that is as far away as possible from the dead battery (1)

7. Route the jumper cables so that they cannot get caught in any moving parts in the engine

compartment of either vehicle.

Starting the engine

 Start the engine of the vehicle with the good battery that is providing help and let it run at idle

speed.

Product specificaties

Merk:	Volkswagen
Categorie:	Auto
Model:	Jetta (2013)

Heb je hulp nodig?

Als je hulp nodig hebt met Volkswagen Jetta (2013) stel dan hieronder een vraag en andere gebruikers zullen je antwoorden

Uw naam*

Jouw email*

Schrijf hier uw vraag

Handleiding Auto Volkswagen

Volkswagen Golf GTI (2014) Handleiding

19 Juni 2023

Volkswagen Golf SportWagen (2015) Handleiding

30 Mei 2023

Volkswagen Eos (2014) Handleiding

15 Mei 2023

Volkswagen Polo (2015) Handleiding

3 Mei 2023

Volkswagen Jetta Hybrid (2013) Handleiding

27 April 2023

Volkswagen Jetta (2014) Handleiding

24 April 2023

Volkswagen Passat Variant Taxi (2012) Handleiding

23 April 2023

Volkswagen Jetta GLI (2014) Handleiding

8 April 2023

Volkswagen Touareg (2014) Handleiding

7 April 2023

Volkswagen Passat Taxi (2012) Handleiding

5 April 2023

Handleiding Auto

Nieuwste handleidingen voor Auto

Suzuki S-Cross (2021) Handleiding

26 April 2024

Suzuki Celerio (2018) Handleiding

26 April 2024

Mini Cooper (2014) Handleiding

2 April 2024

Hyundai Ioniq 6 Electric (2024) Handleiding

29 Maart 2024

GEM eM1400 LSV (2012) Handleiding

29 Maart 2024

GEM INTL (2018) Handleiding

29 Maart 2024

GEM e6 (2020) Handleiding

29 Maart 2024

GEM eM1400 (2018) Handleiding

29 Maart 2024

GEM e4 (2015) Handleiding

29 Maart 2024

GEM e6 (2012) Handleiding

29 Maart 2024