Vemer LPG Sensor Handleiding

Vemer Niet gecategoriseerd LPG Sensor

Bekijk gratis de handleiding van Vemer LPG Sensor (1 pagina’s), behorend tot de categorie Niet gecategoriseerd. Deze gids werd als nuttig beoordeeld door 27 mensen en kreeg gemiddeld 4.4 sterren uit 14 reviews. Heb je een vraag over Vemer LPG Sensor of wil je andere gebruikers van dit product iets vragen? Stel een vraag

Download PDF

Pagina 1/1

V3IS00462-010

CH4 Sensor CO Sensor LPG Sensor, and areprobesforthedetectionof

methanegas,carbonmonoxideandLPGtobeconnectedtoSRG and SRG.4

controlunitstocreatesystemsfordetectinggasinareassuchasboilerrooms,

warehouses,etc.

It is wall-mounted in a vertical position using screws and plastic plugs.

SAFETY WARNINGS

During installation and operation of the instrument, comply with the

following instructions:

1) The device must be installed by a competent person

2) Before removing the cover, make sure that power is NOT provided to

the device

3) Before accessing the terminals, make sure that the electrical leads are

not live

4) Install the detector in the correct position (see “Installation”)

5) Do not power on the device if any part of it is damaged

Code Model Description

VE205100 CH4SENSOR Methanedetectionsensor

VE206900 LPG SENSOR LPG sensor

VE207700 CO SENSOR Carbonmonoxidesensor

TECHNICAL CHARACTERISTICS

• Powersupply:fromthecontrolunitSRGorSRG.4

 −Currentinput(at6.5V):40mA

 −Connection:terminalsof2.5mm2C(common),S(signal),A(powersupply)

• Modelsandcalibration:

 −Methanegas:CH4Sensor,(default)10%LIEofmethane

 −LPG:LPGSensor,(default)12%LIEofisobutene

 −Carbonmonoxide:COSensor,(default)200ppmofcarbonmonoxide

• Max.lengthofconnection:50m

• Container:inself-extinguishingplasticmaterial

• Fastenedtowallusingscrewsandplasticplugs

• Protection:IP30

• Operatingtemperature:0÷+50°C

• Humidity: 90%R.H.withoutcondensation≤

INSTALLATION

 LPG,COandCH4Sensorsaredesignedtobewall-mounted(vertically),using

screwsandplasticplugs.Toproceedwithinstallation,openthecontainerby

unscrewingthescrewlocatedonthelowerside.Makesurenottodamagethe

sensorandnottotouchthecalibrationdevices.

POSITIONING

 Thecorrectinstallationoftheprobeisessentialtoproperoperationofthe

system.Therefore,itmustbeinstalled:

• Inareaswithcirculationofnaturalair;

• Inareasthatarenotsubjecttodustordirtthatmayrenderthesensor

inoperative;

• Nearjetsofwater,intakegrilles,openings,etc.

• Atanadequatedistancefromusersofgassoastopreventthesystemfrom

interveningimproperlyduetofunctionalleakage.

 Also,positioningdependsonthetypeofgastobedetected,specically:

• CH4 Sensor: Methane gas – at top, about 20-30 cm from the ceiling

• LPG Sensor: LPG – at bottom, about 20-30 cm from the ﬂoor

• CO Sensor: carbon monoxide – about 1.5 m from the ﬂoor

 Fornewsystems,theprobemustbeinstalledaslateaspossible,sothattypical

constructionsiteactivitiesdonotdamagethedetector.

CONNECTIONS

 Normalelectricalcablescanbeusedforconnections.Inanycase,when

installationisinplacesthatarestronglyexposedtoelectromagnetic

disturbances,itisadvisabletouseshieldedcables.Thedetectionsystemmust

alwaysbeinoperation.Therefore,theelectricalpowersupplyofthedetector

mustnotincludeswitchesorotherdevicesthatmayaccidentallyshutitoff.The

averagelifespanoftheprobesis5yearsfromthedateofinstallation.Therefore,

attheendofthattimetheywillneedtobereplaced.

Note. Make sure you check operation at least once a year, and in any

case whenever there is an extended period of disuse or in the event of

replacement. Any tampering may compromise correct operation of the

system.

REFERENCE STANDARDS

CompliancewithCommunityDirectives:

2006/95/EC (lowvoltage)

89/336/EECmod.from andfrom92/31/EEC 93/68/EEC(E.M.C.)

isdeclaredwithreferencetothefollowingstandards:

EN 61779-4, EN 50270

User Manual

SENSORS FOR SRG/SRG.4 CONTROL UNITS

Read all the instructions carefully

Dimensions

Connection diagrams

119,0

75,3

36,0

CH4 SENSOR

C S A

SRG/SRG.4

Mod. CH4 SENSOR

Mod. LPG SENSOR

Mod. CO SENSOR

Product specificaties

Merk:	Vemer
Categorie:	Niet gecategoriseerd
Model:	LPG Sensor

Heb je hulp nodig?

Als je hulp nodig hebt met Vemer LPG Sensor stel dan hieronder een vraag en andere gebruikers zullen je antwoorden

Uw naam*

Jouw email*

Schrijf hier uw vraag

Handleiding Niet gecategoriseerd Vemer

Vemer Mini Time Handleiding

17 Juni 2025

Vemer Elettrosonda Z Handleiding

5 September 2023

Vemer Memo NFC Handleiding

17 Juni 2023

Vemer Orion Handleiding

17 Juni 2023

Vemer FHT-2DA Handleiding

12 Juni 2023

Vemer HT NTC-1P3D Handleiding

5 Juni 2023

Vemer HR-1P7A Handleiding

2 Juni 2023

Vemer VE LAN Handleiding

31 Mei 2023

Vemer LCR048 Handleiding

29 Mei 2023

Vemer CH4 Sensor Handleiding

24 Mei 2023

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd

Rane DC 22S Handleiding

17 Juni 2025

Media-tech ZONE 61 MT1258 Handleiding

17 Juni 2025

Parkside PDZ 349 A1 Handleiding

17 Juni 2025

Silvercrest HG03025 Handleiding

17 Juni 2025

ErgoAV ERMTL3 Handleiding

17 Juni 2025

Rane SSA 6 Handleiding

17 Juni 2025

Vitammy Autoband Handleiding

17 Juni 2025

Toparc Mini 350L Handleiding

17 Juni 2025

Ulsonix ULX-GB5 N Handleiding

17 Juni 2025

Fiamma CaravanStore ZIP XL Handleiding

17 Juni 2025