Varo MOTSA23EL Handleiding

Bekijk gratis de handleiding van Varo MOTSA23EL (2 pagina’s), behorend tot de categorie Kluis. Deze gids werd als nuttig beoordeeld door 18 mensen en kreeg gemiddeld 4.4 sterren uit 4 reviews. Heb je een vraag over Varo MOTSA23EL of wil je andere gebruikers van dit product iets vragen? Stel een vraag

MOTSA23EL EN

Copyright © 2 VARO www.varo.com 201NVP a g e | 1

OPERATING INSTRUCTIONS

CAUTION: Do not keep the keys in the safe.

1 TO OPEN THE SAFE

To open the door of the safe for the first time: remove the small plastic cover (B, see diagram “ ”

1) on the front panel, insert the key into the key hole and turn it counter-clockwise direction, at

the same time, turn the doorknob (A, see diagram 1) clockwise direction to open the safe. “ ”in

2 INSTALLING THE BATTERIES

The safe requires 4×size “AA” (1.5V) batteries.

Open the safe, push the battery cover plate “D”(see diagram 2) on the back of the door and

install the batteries. Ensuring the batteries are fitted with the correct corresponding polarity.

Use of alkaline batteries is recommended.

3 PROGRAMMING THE CODE

A. With the safe door open press the red button on the back of the door near the hinge, “C”

release it and you will hear two beeps. The yellow light will be on at the same time.

B. Now press from 3 to 8 numbers that you wish to use as a combination, and confirm by

pressing the letter A in 15 seconds. The safe bleeps twice and the yellow light “” or “B” with“”

will go off, your personal code is now set.

C. Write down your new combination immediately and check whether your new combination

has been programmed or not with the safe door open.

4 USING YOUR SAFE

To open the safe, enter your personal code followed by the letter A B, you will hear a “” or “ ”

beep and the green light will be on, then turn the doorknob in clockwise direction to open the

door within 5 seconds.

If you or an intruder uses the incorrect group of numbers, it will not open. If the incorrect

combination is used 3 times consecutively, you must wait for 20 seconds before reattempting.

If again the incorrect combination is selected 3 times, you must wait approximately 5 minutes

before reattempting access.

5 BATTERY REPLACEMENT WARNING

If the batteries are low, the red light (in the middle) will warn you immediately. To test the

batteries, just input your personal numbers to open the door. If the batteries are low, the red

light will be on. If nothing happens the batteries are . ok

6 REPLACING THE BATTERIES

The safe requires 4× siOpen the safe, push the battery cover ze “AA” (1.5V/ R06) batteries.

plate on the back of the door and replace the 4 pcs old batteries. You must reprogram the

code, using the above step nr. 3.

Use of alkaline batteries is recommended.

7 OPENING THE SAFE MANUALLY OVERRIDE INSTRUCTION TO

OPEN THE SAFE

For your convenience, we have engineered a manual override system for your safe. If you

forget or misplace your combination, remove the small central plate on the front panel B(“ ”,

see in diagram 1), insert the key into the keyhole and turn it in a counter-clockwise direction,

then turn the knob (A, see in diagram 1)in a clockwise direction towards the right. This will “ ”

manually open your safe at any time.

Product specificaties