Uline H-5457 Handleiding

Bekijk gratis de handleiding van Uline H-5457 (3 pagina’s), behorend tot de categorie Niet gecategoriseerd. Deze gids werd als nuttig beoordeeld door 4 mensen en kreeg gemiddeld 4.8 sterren uit 9 reviews. Heb je een vraag over Uline H-5457 of wil je andere gebruikers van dit product iets vragen? Stel een vraag

PAGE 1 OF 3 0824 IH-5457

πH-5457, H-5795

WALL MOUNT

EYEWASH STATION

1-800-295-5510

uline.com

INSTALLATION AND MAINTENANCE

INSTALLATION

• Unit should be assembled in accordance with the

parts diagram, installed in close proximity to hazard

and should be in a clearly identified location, free

of obstructions.

• Shut-off valve(s) (supplied by others) should be

installed and located in accordance with the local

plumbing code.

• Backflow prevention device(s) (supplied by others)

should be installed and located in accordance with

the local plumbing code.

• Drain location and waste discharge should be

installed and located in accordance with the local

plumbing code.

• Eyewash water flow pattern should be positioned

between 33-53" inches from the floor and at least 6"

from the wall or nearest obstruction.

• Unit should be connected with a recommended

minimum 1/2" IPS line to a tepid, clean water source

capable of supplying 30-80 PSI flowing pressure

for a minimum of 15 minutes. If shut-off valves

are installed inline, provisions should be made to

prevent unauthorized shut off.

NOTE: Do not use 3/8" nominal flex connector,

as flow may be insufficient.

• Where freezing conditions exist, unit must be

protected from freezing.

• Performance should be verified after installation.

Check for any leaks while all valves are in the closed

position. All valves should stay in the open position

upon activation.

• With the eyewash valve in the fully opened position

and using a test gauge, the spray pattern should

meet required pattern per ANSI Z358.1. Verify that

the water is tepid, and flow rate is at least 0.4 GPM

for eyewash and 3.0 GPM for eye/face wash.

MAINTENANCE

• All units should be tested on a weekly basis to clear

supply lines and verify proper activation. Units must

also be inspected annually to verify the continued

conformance of required performance standards

stated above.

ANSI/ISEA Z358.1 COMPLIANCE

• Location: Install eye/face wash unit within 10

seconds (approximately 55 feet) of hazard, on

the same level as hazard and with unobstructed

travel path. Where strong acids or caustics are

being handled, emergency eye/face wash units

should be located adjacent to the hazard, and an

appropriate professional should be consulted for

advice on the proper distance.

• Identification: Identify eye/face wash location with

highly visible sign. Area around eye/face wash unit

should be well-lit.

• Water Temperature: Water delivered by eye/face

wash should be tepid (60-100°F).

• Training: Instruct all employees in the location in

proper use of eye/face wash units.

• Maintenance/Inspection: Activate plumbed

eye/face wash units at least weekly. Inspect all

eye/face wash units annually for compliance with

standard.

Para Español, vea página 2.

Pour le français, consulter la page 3.

Product specificaties