Ubiquiti Networks UVC-G3-FLEX Handleiding

Ubiquiti Networks Bewakingscamera UVC-G3-FLEX

Lees hieronder de 📖 handleiding in het Nederlandse voor Ubiquiti Networks UVC-G3-FLEX (29 pagina's) in de categorie Bewakingscamera. Deze handleiding was nuttig voor 35 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/29

1080p Indoor/Outdoor IP Camera with

Infrared and 802.3af Support

Model: UVC-G3-FLEX

Introduction

Thank you for purchasing the Ubiquiti Networks® G3 Flex

camera. This Quick Start Guide is designed to guide you

through installation and includes warranty terms.

Package Contents

G3 Flex Camera Flush Mount Pole/Wall

Mount

Outdoor

Cover

Security Screw

(Qty. 1)

Screws

(Qty. 3)

Screw Anchors

(Qty. 3)

Zip Ties

(Qty. 2)

Installation Requirements

• Phillips screwdriver

• Drill and 6 mm (1/4") bit for drywall anchors and 3 mm (1/8")

for screws)

• Category 5e (or above) Ethernet cable

Note:

When using the Outdoor Cover, use an Ethernetcable

without a strain-relief boot on the connector. This willprevent

unnecessary tension on the cable ends during installation.

Cable without a strain-relief boot Cable with a strain-relief boot

cable and earth grounding must be used for outdoor installations as conditions of product

warranty. TOUGHCable™ is designed for outdoor installations. It is the professional installer’s

responsibility to follow local country regulations.

Outdoor Installation Requirements

IMPORTANT: When installed outdoors, the camera must be

installed in the upright postion only.

• Mounting location should be at least 60 cm (2 ft) from the

edge of the eave or ceiling.

• Mount the camera in the upright position only. Please see

diagram below.

• Shielded Category 5e (or above) cabling with drain wire

should be used for all outdoor wired Ethernet connections

and should be grounded through the AC ground of the PoE.

We recommend that you protect your networks from

harmful outdoor environments and destructive ESD events

with industrial‑grade, shielded Ethernet cable from Ubiquiti

Networks. For more details, visit www.ubnt.com/toughcable

• Surge protection should be used for all outdoor installations.

We recommend that you use two Ethernet Surge Protectors,

model ETH‑SP‑G2, one near the UVC‑G3‑Flex and the other

at the entry point to the building. The ETH‑SP‑G2 will absorb

power surges and safely discharge them into the ground.

To LAN

ETH-SP-G2

US-8-150W

UVC-G3-FLEX

60 cm (2 ft)

Diagram Showing Use of Ethernet Surge Protectors

Product specificaties

Merk:	Ubiquiti Networks
Categorie:	Bewakingscamera
Model:	UVC-G3-FLEX
Kleur van het product:	Wit
Gewicht:	170 g
Breedte:	48 mm
Diepte:	48 mm
Hoogte:	107.5 mm
Soort:	IP-beveiligingscamera
Vormfactor:	kubus
Ondersteuning voor plaatsing:	Binnen & buiten
Connectiviteitstechnologie:	Bedraad
Ethernet LAN:	Ja
Montagewijze:	Plafond/muur/paal
Maximum resolutie:	1920 x 1080 Pixels
Totaal aantal megapixels:	2 MP
Type stroombron:	Power over Ethernet (PoE)
Minimale belichting:	- Lux
Nachtvisie:	Ja
Vaste focale lengte:	3.4 mm
Vermogensverbruik (max):	4 W
Omvang optische sensor:	1/2.7 "
Ingebouwde microfoon:	Ja
Maximaal 30 frames per seconde:	25 fps
Bedrijfstemperatuur (T-T):	-20 - 50 °C
Relatieve vochtigheid in bedrijf (V-V):	20 - 90 procent
Code geharmoniseerd systeem (HS):	85258900
Kijkhoek lens, horizontaal:	87.4 °
Kijkhoek lens, diagonaal:	104 °
Kijkhoek lens, verticaal:	47 °