Tripp Lite VRX2008R Handleiding

Bekijk gratis de handleiding van Tripp Lite VRX2008R (2 pagina’s), behorend tot de categorie Niet gecategoriseerd. Deze gids werd als nuttig beoordeeld door 30 mensen en kreeg gemiddeld 4.6 sterren uit 6 reviews. Heb je een vraag over Tripp Lite VRX2008R of wil je andere gebruikers van dit product iets vragen? Stel een vraag

Owner’s Manual

Important Safety Instructions

Warranty Information

Installation

Fax/Modem Protection

Indicator Lights

Copyright © 2010 Tripp Lite. All rights reserved.

1111 W. 35th Street, Chicago, IL 60609 USA

www.tripplite.com/support

Voltage Regulator

Model: VRX2008R (220V, 50/60Hz Input, Output)

• Install your voltage regulator indoors, away from excess

moisture and heat, direct sunlight, and dust and other conductive

contaminants.

• For best performance, keep the indoor temperature between 0º C and

40º C (between 32º F and 104º F ).

• Leave adequate space around all sides of the voltage regulator for

proper ventilation.

• Connect your voltage regulator directly to a three-wire, grounded

AC power outlet. Do not remove or modify the ground pin of the

voltage regulator’s plug. Do not use adapters that would eliminate

the voltage regulator’s connection to ground.

• Do not use extension cords between the voltage regulator and the

AC outlet. If necessary, a Tripp Lite Surge Suppressor may be used

between the voltage regulator and the AC outlet.

• Use of this equipment in life support applications where failure

of this equipment can reasonably be expected to cause the failure

of the life support equipment or to significantly affect its safety or

effectiveness is not recommended. Do not use this equipment in

the presence of a flammable anesthetic mixture with air, oxygen or

nitrous oxide.

TRIPP LITE warrants its products to be free from defects in materials and workmanship

for a period of two years from the date of initial purchase. TRIPP LITE’s obligation under

this warranty is limited to repairing or replacing (at its sole option) any such defective

products. This warranty does not apply to equipment which has been damaged by accident,

negligence or misapplication or has been altered or modified in any way. This warranty

applies only to the original purchaser who must have properly registered the product within

10 days of purchase.

EXCEPT AS PROVIDED HEREIN, TRIPP LITE MAKES NO WARRANTIES, EXPRESS

OR IMPLIED, INCLUDING WARRANTIES OF MERCHANTABILITY AND FITNESS

FOR A PARTICULAR PURPOSE. Some states do not permit limitation or exclusion of

implied warranties; therefore, the aforesaid limitation(s) or exclusion(s) may not apply to

the purchaser.

EXCEPT AS PROVIDED ABOVE, IN NO EVENT WILL TRIPP LITE BE LIABLE FOR

DIRECT, INDIRECT, SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES

ARISING OUT OF THE USE OF THIS PRODUCT, EVEN IF ADVISED OF THE

POSSIBILITY OF SUCH DAMAGE. Specifically, TRIPP LITE is not liable for any costs,

such as lost profits or revenue, loss of equipment, loss of use of equipment, loss of software,

loss of data, costs of substitutes, claims by third parties, or otherwise.

Regulatory Compliance Identification Numbers

For the purpose of regulatory compliance certifications and identification, your Tripp Lite

product has been assigned a unique series number. The series number can be found on the

product nameplate label, along with all required approval markings and information. When

requesting compliance information for this product, always refer to the series number.

The series number should not be confused with the marking name or model number of the

product.

WEEE Compliance Information for Tripp Lite Customers and Recyclers (European

Union)

Under the Waste Electrical and Electronic Equipment (WEEE) Directive and implementing

regulations, when customers buy new electrical and electronic equipment from Tripp Lite

they are entitled to:

•Sendoldequipmentforrecyclingonaone-for-one,like-for-likebasis(thisvaries

depending on the country)

•Sendthenewequipmentbackforrecyclingwhenthisultimatelybecomeswaste

Tripp Lite follows a policy of continuous improvement. Product specifications are subject to

change without notice.

1Connect your voltage regulator to an electrical outlet.

2Plug your computer and electronics into your voltage regulator’s

outlets. NOTE: Four outlets feature Automatic Voltage

Regulation (AVR) only and four outlets feature surge

suppression only. Connect your computer and electronics

accordingly.

3Turn your voltage regulator’s power switch on.

NOTE: This connection is optional. Your voltage regulator will

work properly without this connection. Using telephone cords,

connect your wall jack to the voltage regulator jack marked “IN” and

your equipment to the voltage regulator jack marked “OUT”.

BOOST: This yellow light will turn ON whenever your voltage

regulator is boosting low AC line voltage up to nominal

voltage levels.

POWER: This green light will turn ON when your voltage regulator is

receiving normal AC line voltage. It will blink if the system

load is too high at very low voltages. Reducing loads at very

low voltage levels will provide optimal AVR operation.

CUT: This red light will turn ON whenever your voltage regulator

is reducing high AC line voltage down to nominal voltage

levels.

201006066 • 933028-EN

Product specificaties