Thorma Mallorca Handleiding

Thorma Kachel Mallorca

Lees hieronder de 📖 handleiding in het Nederlandse voor Thorma Mallorca (16 pagina's) in de categorie Kachel. Deze handleiding was nuttig voor 55 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/16

BILBAO, MALAGA, MALLORCA

Installation and Operation Manual

solid fuel heater

BILBAO, MALAGA, MALLORCA

tested according to the standard EN 13240

1. Installation Instruction

The heater has been designed to allow simple connection to an existing chimney by a single connecting piece. The connecting piece

must be as short and straight as possible, in a horizontal position or slightly inclined. The piece must be tight.

Be sure that all local regulations, including those concerning both national and European standards on construction and fire prevention,

are respected during installation. Inform the competent inspector prior to installation. Be sure that combustion air supply is sufficient;

particularly in rooms where windows and doors are closed tight. The heater must not be placed in a damp environment.

Chimney properties shall be calculated in accordance with DIN 4705 parts 1 and parts 2, eventually also part 3, with the three values

stated in this manual.

The heater must stand on a hearth with adequate bearing capacity. If bearing capacity is too low, adequate measures must be taken

(e.g. a board must be laid to split weight).

2. General Safety Instructions

Fuel combustion emits calorific energy that heats the surface of the heater, combustion chamber door, door and control elements handles,

safety glass, flue pipes, and eventually also the front of the heater. Do never touch those parts without adequate safety wear or elements

(fireproof gloves etc.).

Warn children of such danger and make sure they do not stay close to heater when in operation.

3. Acceptable Fuel

Fuels acceptable for burning include wood logs of up to 25 cm in length and 30 cm in circumference, and lignite briquettes.

Make sure that only air dried wood logs are used. Burning of waste, and plastics in particular, is forbidden by law on emissions. Besides,

such fuel may cause damage to the fire place and chimney and subsequently may injure health and smell may annoy your neighbours.

Air dried wood logs with 20% maximum humidity may be obtained after at least one year (soft wood) or two years (hard wood) of drying.

Wood is not slow combustion fuel and thus, continuous heating throughout the night is not possible when burning wood.

Liquid fuel is unacceptable.

4. Firing

During the first firing bad smell due to drying of protection paint is inevitable but the smell shall fade quickly. Make sure the room with the

heater is well aerated when firing. Quick firing is essential because incorrect procedure may cause increased emissions.

Add more fuel as soon as firing fuel catches fire. Do never use alcohol, petrol or other flammable liquids for firing. Do always use some

paper, wood chips, and a small amount of fuel for that. Make sure that primary and secondary air is supplied to heater when firing. Make

sure that heater is under control during firing.

5. Operating More than One Fireplace

Make sure that combustion air supply is sufficient when operating more than one fireplace in one room or within the same air system.

6. Transition Season Operation

When exterior temperature rise during transition season draught can decrease at low burning capacity and flue gas may not be evacuated

completely. In such case add only small quantities of fuel and open the slider of primary air supply so that loaded fuel burns more quickly

(flame) and draught gets steady. Ash needs to be raked carefully more often to enhance air circulation below fireplace.

7. Cleaning and Checking

Heater flue pipes need to be checked for deposit and eventually swept at least once a year or more often, e.g. while sweeping chimney.

Make sure your chimney is swept regularly by a chimneysweep. The frequency of sweeping shall be defined by competent inspector.

Heater should be checked by an expert every year.

It is forbidden to clean the heater with a damp cloth.

8. Versions

Heaters with spring fireplace door can be connected to a chimney with multiple taking for other heaters and fireplaces provided that

dimensions of the chimney are in compliance with DIN 4705 part 3.

The door of the heater with spring fireplace door must always be closed during operation, except for firing, fuel charging, and ash

removing. Otherwise operation of other equipments connected to the chimney may be affected or flue gas may leak.

9. Combustion Air

Since heaters are fireplaces depending on surrounding air and take combustion air from the room, adequate intake of combustion air is

vital.

In rooms with tight windows and doors (e.g. as energy-saving measure) fresh air intake may be low and thus affect draught of the heater.

Also your well-being may be affected; even your safety may be threatened. It may sometimes be necessary to assure adequate intake of

fresh air e.g. by installing air shutter close to heater or by combustion air pipe leading to exterior or to a well aerated room (except boiler

room). In particular it is vital that combustion air pipes are open during operation of fireplace. Steam flues located in the same room with

fireplace may affect heater’s operation (smoke may leak to inhabited room despite closed fireplace door) and therefore must never be

operated parallely with the heater.

BILBAO, MALAGA, MALLORCA

The outdoor combustion air could be supplied to the heater through the connecting socket which can be mounted on the bottom of the

backside of the heater.

10. Fire Protection

Distance from flammable structures and furniture

To assure adequate heat protection, a minimum distance of 20 cm in the back and 20 cm on the sides is required between the heater

and flammable structures and furniture.

Fire protection within radiation perimeter

Make sure that no flammable structures or furniture are within radiation perimeter of glass door, which is 80 cm. The distance may be

reduced to 40 cm if safety shade is installed between fireplace and flammable structures leaving enough space on both sides.

Fire protection outside radiation perimeter

Minimum distances from flammable structures and furniture are stated on heater’s label and must be observed.

Heater

For solid fuel heaters floor in front of fireplace’s door made of flammable materials must be protected by a non-flammable hearth. Its

minimum dimensions are 50 cm in the front and 30 cm on the sides of fireplace door.

11. Spare Parts

Only spare parts approved or provided by the manufacturer may be used. For inquiries, please, contact a specialized vendor.

No modifications to heater are allowed!

12. Warning in case of fire in chimney

Deposit in chimney may catch fire if unsuitable or humid fuel is used. In such case close all heater air holes immediately and call the fire

brigade. After fire is extinguished chimney should be inspected by an expert for cracks or untight places.

13. Nominal heating capacity, combustion air adjustment, and fuel burning time

Nominal heating capacity of heater is 11,5 kW for wood and 8,5 kW for lignite briquettes it is obtained at minimum supply

pressure of 12 Pa:

Fuel

Wood logs (25 cm length, 30 cm circumference)

Lignite briquettes

Maximum dose

3.75 kg

2.37 kg

Air regulator

set perpendicular to the front wall of the stove

set to the right

Burning time

1.0 hour

When operating with wood, the air regulator is set so that the regulator arm is set perpendicular to the front wall of the stove, that is,

the primary combustion air supply is completely closed and the secondary combustion air supply is completely open.

When operating with brown coal briquettes, set the air regulator so that the regulator arm is set to the right, meaning that

the primary and secondary air inlets are fully open.

The combustion air regulator arm is located under the front door. The handle can be manipulated with a handle that is a tile fitting.

Quantity and adjustment of combustion air for moderate operation:

Fuel

Lignite briquettes

Maximum dose

1.7 kg

Air regulator

set to the right

Burning time

approx. 2 hours

14. Space Heating Capacity

For rooms with insulation non-conform with calorific insulation regulations space heating capacity should be determined pursuant to DIN

18 893 for nominal heating capacity of 11.5 /8.5 kW:

in favourable heating conditions - 220 m3

in poor heating conditions - 180 m3

in unfavourable heating conditions - 120 m3

For occasional heating – interrupted for more than 8 hours – space heating capacity is reduced by 25%.

15. Technical Data

Capacity: 11.5 / 8.5 kW

Weight: BILBAO = 125 kg, BILBAO UNI = 130 kg, MALAGA = 125 kg, MALLORCA UNI = 135 kg

Upper flue gas outlet: 150 mm

BILBAO, MALAGA, MALLORCA

Data for chimney properties calculation (at nominal heating capacity):

Fuel

Wood logs

Lignite briquettes

Flue gas flow [gs-1]

17,1

Average temperature of flue after draught shaft [°C]

427

382

Min. draught at nominal heating capacity [Pa]

Guarantee

Shall any failure, malfunction, or surface defect occur on your heater within the guarantee period do never repair it by yourself. After-

sale service can be done only by the manufacturer or distributor.

We guarantee the quality, function, and construction of the heater for 2 years from the day of purchase: defects definitely occurred as a

consequence of manufacturing defect will be remedied within short time at our cost under the condition that the heater:

- has been operated in conformity with operating instruction,

- has been connected to the chimney in conformity with applicable standards,

- has not been damaged mechanically by force,

- has not been subject to modifications, repairs and incompetent handling.

When making a complaint give your exact address and circumstances when the dysfunction occurred. We will deal with the complaint

if you deliver the warranty certificate with the date of purchase and the sales point stamp along with the complaint.

Ask for legible warranty certificate at purchase. Our company will decide on method and place of reparation to be carried out.

Upon purchase, check for integrity of the firing door glass. This is under guarantee for 15 days after the purchase.

It is unacceptable to operate the appliance at extreme conditions, which means:

- fuel quantity exceeds the recommended quantity,

- air supply exceeds the recommended quantity,

- unacceptable fuel types are used.

Heat overcharge shows in the following ways:

- fireplace ceiling deflection,

- firing door damage,

- grille has burnt over,

- vermiculite bricks have cracked,

- change of colour tone of the heater surface

The complaint will not be accepted by the manufacturer if the appliance has not been operated correctly.

Exchange of the product or making the purchase contract void is subject to applicable dispositions of the Civil Code and the

Complaints Order.

Aufstell - und bedienungsanleitung für den

Kaminofen BILBAO, MALAGA, MALLORCA

geprüft nach DIN EN 13240, 2. Stufe 1.BImSchV

1. Aufstellhinweise

Der Kaminofen ist anschlussfertig montiert und muss mit einem Verbindungsstück an den bestehenden Hausschornstein angeschlossen

werden. Das Verbindungsstück soll möglichst kurz, geradlinig, waagerecht oder leicht steigend angeordnet sein.

Verbindungen sind abzudichten.

Nationale und Europäische Normen, örtliche und baurechtliche Vorschriften sowie feuerpolizeiliche Bestimmungen sind einzuhalten.

Informieren Sie daher vorher Ihren

Bezirks-Schornsteinfegermeister. Es ist sicherzustellen, dass die für die Verbrennung benötigte Luftmenge ausreichend ist. Hierauf ist

besonders bei dichtschließenden Fenstern und Türen (Dichtlippe) zu achten.

Die Schornsteinberechnung erfolgt nach DIN EN 13384 – 1 bzw. 13384 - 2 mit dem dieser Anleitung zugefügten Wertetripel.

Prüfen Sie vor dem Aufstellen, ob die Tragfähigkeit der Unterkonstruktion dem Gewicht Ihres Kaminofens standhält. Bei unzureichender

Tragfähigkeit müssen geeignete Maßnahmen (z. B. Platte zur Lastverteilung) getroffen werden, um diese zu erreichen.

2. Allgemeine Sicherheitshinweise

Durch den Abbrand von Brennmaterial wird Wärmeenergie frei, die zu einer starken Erhitzung der Oberflächen, der Feuerraumtüren, der

Tür- und Bediengriffe, der Sichtfensterscheibe, der Rauchrohe und ggf. der Frontwand des Ofens führt. Die Berührung dieser Teile ohne

entsprechende Schutzbekleidung oder Hilfsmittel (hitzebeständige Handschuhe oder andere Betätigungsmittel) ist zu unterlassen.

Machen Sie Kinder auf diese Gefahren aufmerksam und halten Sie sie während des Heizbetriebes von der Feuerstätte fern.

3. Zulässige Brennstoffe

Zulässige Brennstoffe sind Scheitholz mit einer Länge von 25 cm und einem Umfang von 30 cm.

Es darf nur lufttrockenes Scheitholz verwendet werden. Die Verfeuerung von Abfällen und insbesondere Kundstoff ist laut

Bundesimmisionschutzgesetz verboten. Darüber hinaus schadet dies der Feuerstätte und dem Schornstein und kann zu

Product specificaties

Merk:	Thorma
Categorie:	Kachel
Model:	Mallorca

Heb je hulp nodig?

Als je hulp nodig hebt met Thorma Mallorca stel dan hieronder een vraag en andere gebruikers zullen je antwoorden

Uw naam*

Jouw email*

Schrijf hier uw vraag

Handleiding Kachel Thorma

Thorma Bozen Handleiding

12 Oktober 2022

Thorma Almeria Handleiding

12 Oktober 2022

Thorma Domino III Handleiding

12 Oktober 2022

Thorma Cremona Top Handleiding

12 Oktober 2022

Thorma Falun Handleiding

12 Oktober 2022

Thorma Domino II Handleiding

12 Oktober 2022

Thorma Horby Handleiding

12 Oktober 2022

Thorma Falun Ii Handleiding

12 Oktober 2022

Thorma Bolzano Handleiding

12 Oktober 2022

Thorma Filex Eurofen II Handleiding

12 Oktober 2022

Handleiding Kachel

Nieuwste handleidingen voor Kachel

Essentiel B ECHS 1502C Handleiding

9 April 2024

Essentiel B ECHB 933n Handleiding

9 April 2024

Essentiel B ECHS C1b Handleiding

9 April 2024

Essentiel B ECHC 2300P Handleiding

9 April 2024

Essentiel B ECSB 1500 Meca Handleiding

9 April 2024

Nobo NTL4Y Handleiding

19 Maart 2024

Alpatec PRMD 1000 Handleiding

15 Februari 2024

Alpatec PRMDT 1500 Handleiding

15 Februari 2024

Alpatec PRMDT 1000 Handleiding

15 Februari 2024

Alpatec PRMD 1500 Handleiding

14 Februari 2024