Televés T.0X Optical 2339 Handleiding

Televés Splitter T.0X Optical 2339

Lees hieronder de 📖 handleiding in het Nederlandse voor Televés T.0X Optical 2339 (8 pagina's) in de categorie Splitter. Deze handleiding was nuttig voor 15 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/8
w w w . t e l e v e s . c o m
ES
DE
EN
Refs. 2337, 2339
Art. Nr. UOV2, UOV4
Manual de Instrucciones
User´s Manual
Bedienungsanleitung
Инструкция по эксплуатации
Repartidores Ópticos 2D - 4D
2W - 4W Optical Splitters
Optische Verteiler 2- und 4-fach
Оптические делители на 2-4 выхода
РУС
ES
Instrucciones de seguridad
Condiciones generales de instalación:
Antes de manipular o conectar el equipo leer este
manual.
No obstruir las ranuras de ventilación del equipo.
Deje un espacio libre alrededor del aparato para
proporcionar una ventilación adecuada.
No situar el equipo cerca de fuentes de calor o en
ambientes de humedad elevada.
No situar el equipo donde pueda estar sometido
a fuertes vibraciones o sacudidas.
Operación segura del equipo:
Si algún líquido u objeto se cayera dentro del
equipo, por favor recurra al servicio técnico es-
pecializado.
No conectar el equipo hasta que todas las demás
conexiones del equipo hayan sido efectuadas.
Instrucciones para la conexión ópti-
ca:
Para la conexión óptica se utilizará un cable de -
bra monomodo con conector tipo SC/APC.
Sacar la tapa protectora del conector óptico ubi-
cado en el interior del equipo, así como el capu-
chón del conector del cable monobra.
Realizar la conexión del cable al equipo teniendo
cuidado de enfrentar las guías de ambos conec-
tores, presionando el conector totalmente hasta
el fondo.
Precauciones de conexionado:
Tratar con sumo cuidado la punta desprotegida
de los conectores, pequeños arañazos, rascadu-
ras, impurezas y/o partículas de suciedad, aceites,
grasas, sudor, etc.. pueden degradar signicativa-
mente la señal.
Para la limpieza de la punta de los conectores,
frotar (sin ejercer presión) con un paño de limpiar
lentes, que no suelte pelusa, humedecido con al-
cohol isopropílico sin aditivos. Antes de realizar la
conexión dejar secar totalmente el alcohol.
Reservar las tapas de conectores y capuchones de
los cables para futuras operaciones de extracción/
protección de los mismos.
Colocar siempre las tapas protectoras a los conec-
tores de los equipos que no estén conectados a
cables para evitar que el haz láser pueda alcanzar
los ojos.
Evite en lo posible el encendido del transmisor sin
tener la  bra conectada a dicho transmisor.
Instrucciones para la conexión óptica:
Aviso.-
Este producto emite un rayo de luz invisible láser.
Evite exponerse a la radiación láser. El uso de apa-
ratos de ayuda visual (por ejemplo binoculares, lu-
pas, etc.) puede aumentar el peligro a los ojos.





Acorde a EN60825-1_ 2007
Precaución
- El uso de controles o ajustes, así como el uso de
procedimientos diferentes de los especicados
en éste manual puede provocar la exposición a la
radiación peligrosa.
- Lea y siga las instrucciones en este manual cuida-
dosamente, retenga éste manual para referencia
futura.
- No utilice los equipos de forma no conforme con
estas instrucciones de operación ni bajo cualquier
condición que exceda las especi caciones am-
bientales estipuladas.
- El usuario no puede dar servicio cnico a estos
equipos. Para asistencia técnica contacte con
nuestro departamento de asistencia técnica.
- El rayo láser no debe ser apuntado a las personas
y/o animales intencionadamente.
3
EN
Important safety instructions
General installation conditions:
Before handling or connecting the equipment,
please read this manual.
Do not obstruct the equipment’s ventilation
system.
Please allow air circulation around the equipment.
Do not place the equipment near sources of heat
or in excessively moisture conditions.
Do not place the equipment where it may be a
ected by strong vibrations or knocks.
How to use the equipment safely:
If any liquid or object falls inside the equipment,
please contact a specialized technician.
Do not connect the equipment to the mains until
all the other connections have been made.
Instructions for the optical
connection:
For the optical connection, a single mode bre
cable is used with an SC/APC-type connector.
Remove the protective cover from the optical
connector on the front panel of the device, and
the cap on the connector of the singlebre cable.
Connect the cable to the device, carefully slotting
the guides together for both connectors, pushing
the connector all the way in.
Precautionary measures with the
connection point:
Take special care to avoid damaging the
unprotected ends of the connectors, as small
scratches, impurities and/or particles of dirt, oil,
grease, sweat etc. may signi cantly a ect the
quality of the signal.
To clean the ends of the connectors, gently rub
with a lint-free lens cleaning cloth, dampened
using additive-free isopropyl alcohol. Make sure
the alcohol evaporates fully before connecting.
Keep the connector covers and cable caps in a
safe place in case they are needed in the future.
Always  t the covers on the connectors of devices
that are not connected to cables to prevent the
laser beam from damaging the eyes.
Avoid turning on the transmitter without having
the  bre optic cable connected.
Safety measures
Warning.-
This product emits an invisible laser beam.
Avoid contact with laser radiation. The use of
equipment such as binoculars or
magnifying glasses may increase damage caused
to the eyes.





Accord to EN60825-1_ 2007
Caution!
- The use of controls or adjustments or any other
procedures other than those speci ed in this
manual may lead to exposure to harmful radiation.
- Carefully read and observe the instructions given
in this manual, and keep it for future reference.
- Do not use the equipment in any way that does
not comply with the operating instructions or
in any conditions that exceed the stipulated
atmospheric speci cations.
- This equipment is not user-serviceable. Should
you require assistance, contact our technical
service department.
- Never point the laser beam intentionally at people
or animals.


Product specificaties

Merk: Televés
Categorie: Splitter
Model: T.0X Optical 2339

Heb je hulp nodig?

Als je hulp nodig hebt met Televés T.0X Optical 2339 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Splitter Televés

Handleiding Splitter

Nieuwste handleidingen voor Splitter