Taramp’s TS 1200X4 Handleiding
Lees hieronder de 📖 handleiding in het Nederlandse voor Taramp’s TS 1200X4 (8 pagina's) in de categorie Receiver. Deze handleiding was nuttig voor 6 personen en werd door 3.5 gebruikers gemiddeld met 4.9 sterren beoordeeld
Pagina 1/8
The installation of this product must be made by a qualified professional.
AMPLIFIER - 1200WATTS - 2 OHMS
4 x 300W RMS
Index
•Defects caused by accessories, modifications or features attached to the product;
•Damaged products by improper installation, water infiltration, violation by unauthorized
individuals;
•Tamper or torn warranty seal;
This warranty excludes:
•Cases in which the product is not used in adequate conditions;
•Warranty card is not properly filled or torn;
TARAMPS, located on Abilio Daguano Street 274, Res. Manoel Martins – Alfredo Marcondes,
SP - Brazil, ZIP CODE 19180-000, guarantees this product against any defects on terms of
project, making, assembling, and/or with solidarity, due to project vices which cause it
improper or inadequate to its original use within 12 months from the date of purchase. In case
of defect during the warranty period, TARAMPS responsibility is limited to the repairing or
replacement of the device of its own making.
•Damage of any kind, due to problems in the product, as well as losses caused by discontinued
use of the product.
•Costs involving uninstallation, reinstallation of equipment as well the shipment to the
factory;
•The product with damage from falling, bumps or nature related problems (flooding,
lightning, etc);
Term of warranty
Technical assistance
For international support, check on our website:
Phones: +55 18 3266-4050 / +55 18 99749-3391
www.taramps.com.br/en/rede-de-assistencias-tecnicas or contact direct the factory support:
E-mail: service@taramps.com.br
• Technical assistance
02 • Introduction
• Safety
01 • Term of warranty
• Safety requirements
04 • Output & power supply connector
05 • Installation
06 • Technical features
•Protection system
03 • Functions & inputs
• Recommended wire gauge & fuse
01
Safety requirements
Introduction
Taramps reserves the right to modify the contents of this document at any time without prior notice and does
not have the obligation to apply the changes in units which were previously produced.
Pay attention to the safety symbols.
Safety
This symbol with “CAUTION” is intended to alert the user to the presence of
important instructions. Failure to heed the instructions will result in risk of
injury to user or product damage.
CAUTION
Read this manual before preparing the product. In case of
doubt, contact our technical support: ( or18) 3266-4050
www.taramps.com.br.
At the end of its useful life, this product must not be
disposed of in household waste. Look for an
electronic equipment collection or recycling center
for proper disposal.
Declaration of Conformity
TARAMPS ELEC TRONICS LTDA
Alfredo Marcondes - SP
Brazil
Hereby, Taramps Electronics Ltda declares that the product
TS 1200X4 complies with the Directive 2014/30/EU, according
with the following harmonized standard:
-EN 50498:2010
Electromagnetic compatibility (EMC) -
Product family standard for aftermarket
electronic equipment in vehicles
The full text of the EU Declaration of Conformity is available at
the following Product Page on Internet.
- Never install the amplifier in places exposed to dust, humidity and water. Pay attention to
install it far from fuel tank, fuel lines, heat sources and other parts of vehicle.
- Be sure to install protection fuse or a circuit braker near to battery. Follow the ampere rating
as indicated here in this manual. Use of improper fuse or circuit breaker could result in
overheat, smoke, damage to product, injury or burns.
- Avoid running wires over or through sharp edges. Use rubber or plastic grommets to protect
any wires routed through car's body.
- Before make any connection to amplifier, disconnect the battery negative terminal.
- When in use, the external surface of may amplifier becomes hot. Avoid touching the heatsink
area and keep childrens far from the amplifier.
- Wear safety glasses, insulated gloves and correct tools for installing this product.
To ensure proper use, please read through this manual before using the amplifier. It is
specially important that you know the CAUTIONS contained here.
- This amplifier is for use with 12V batteries. Always check the voltage before installing.
- This amplifier must be installed in a firm place with at least 1” space around the heatsink for
proper heat spreading.
- The installation of this amplifier must be done by a qualified professional.
- Output connections for speakers may have voltage levels when the amplifier is operating.
Make sure that the amplifier is turned OFF before proceed any connection or disconnection in
this terminals.
- If you want to dispose this amplifier, don't throw it on domestic waste. It must be collected by
an used electronic product disposal service for proper recycling.
- This amplifier may produce high sound pressure levels. Avoid continuous exposure to levels
over 85dB to prevent permanent hearing loss.
02
Product specificaties
| Merk: | Taramp’s |
| Categorie: | Receiver |
| Model: | TS 1200X4 |
Heb je hulp nodig?
Als je hulp nodig hebt met Taramp’s TS 1200X4 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden
Handleiding Receiver Taramp’s
6 Juni 2025
4 Juni 2025
4 Juni 2025
3 Juni 2025
3 Juni 2025
Handleiding Receiver
- Receiver Lab Gruppen
- Receiver Palsonic
- Receiver Yaesu
- Receiver LEA
- Receiver Hama
- Receiver AER
- Receiver Alto
- Receiver DARTS
- Receiver Reloop
- Receiver Hilti
- Receiver Golden Age Project
- Receiver Gold Note
- Receiver Matrox
- Receiver Benchmark
- Receiver Meridian
Nieuwste handleidingen voor Receiver
6 Juni 2025
6 Juni 2025
6 Juni 2025
6 Juni 2025
6 Juni 2025
6 Juni 2025
5 Juni 2025
5 Juni 2025
5 Juni 2025
4 Juni 2025