Tannoy QFlex 40 Handleiding

Tannoy Speaker QFlex 40

Lees hieronder de 📖 handleiding in het Nederlandse voor Tannoy QFlex 40 (56 pagina's) in de categorie Speaker. Deze handleiding was nuttig voor 21 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/56
u s e r m a n u a l
SAFETY WARNING
This equipment is designed for permanent installation. Disconnection from the mains supply is to be achieved by
isolation of the circuit to which it is connected.
Do not remove any covers, loosen any xings or allow items to enter any aperture.
Objects lled with liquids should not be placed on this apparatus.
The rear of this product can get hot. direct skin contact during operation and for at least 5 minutes after power Avoid
has been isolated.
To prevent injury this apparatus must be secured to the wall in accordance with the installation instructions.
AVERTISSEMENT DE SECURITE
Ce matĂ©riel est destinĂ© Ă  ĂȘtre installĂ© de façon permanente. Toute coupure de l’alimentation secteur est a effectuer au
niveau de la prise oĂč le matĂ©riel est raccordĂ©.
Ne retirez pas les couvercles, ne desserrez pas les xations et ne laissez aucune piĂšce s’introduire dans les ouvertures.
Ne placez pas d’objets contenant du liquide Ă  proximitĂ© de l’appareil.
La partie arriĂšre de ce produit est susceptible de chauffer. Eviter tout contact direct avec la peau pendant fonctionnement
et au moins 5 minutes aprùs coupure de l’alimentation secteur.
An de prĂ©venir toute blessure cet appareil doit ĂȘtre xĂ© au mur conformĂ©ment aux instructions d’installation.
IMPORTANT SAFETY INSTRUCTIONS
1 Read these instructions.
2 Keep these instructions.
3 Heed all warnings.
4 Follow all instructions.
5 Do not use this apparatus near water.
6 Clean only with dry cloth.
7 Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.
8 Do not install near any heat sources such as radiators, heat registers, stoves or other apparatus (including
ampliers) that produce heat.
9 Only use attachments / accessories specied by the manufacturer.
10 Refer all servicing to qualied service personnel. Service is required when the apparatus has been damaged in any
way, such as, liquid has been spilled or objects have fallen into the apparatus, this apparatus has been exposed to
rain or moisture, does not operate normally, or has been dropped.
INSTALLATION INSTRUCTIONS
1 THIS PRODUCT MUST BE EARTHED. The safety ground terminal of the appliance must be connected to the
earthing terminal of the installation. The cord must be of maximum length 7.5 meters, rated SJ, SJT, or SJE, 10A
minimum and be marked VW-1.
2 The electrical power connection to this product is only to be made via the connector as supplied with the equipment.
and available from Tannoy under part number 3431-1150.
3 Wiring to this connector must conform with instructions in this manual, must only be made by suitably qualied per
sonnel and must comply with all local requirements.
4 Do not equipment in free ventilation movement of air install this an enclosed space. Do not limit and around back the
panel. Ensure that there is at least 100mm (4”) of space around all sides of the product for ventilation.
5 QFlex modules must only be joined or separated with the complete column laying at on the ground and
disconnected from the mains supply.
6 QFlex is designed and intended for use in non-domestic situations. Mains power is to be supplied from a permanent
hard wired feed. The feed for each QFlex must be protected by a fuse or circuit breaker rated at no more than 10A.
It must be possible to isolate the feed to each QFlex by means of a double pole switch with a minimum of 3mm con
tact separation.
IMPORTANTES INSTRUCTIONS RELATIVES A LA SECURITE
1 Lire ces instructions.
2 Conserver ces instructions.
3 Tenir compte de tous les avertissements.
4 Respecter toutes les instructions.
5 Ne pas utiliser cet appareil a proximitĂ© d’eau.
6 Ne nettoyer qu’avec un chiffon sec.
7 Ne bloquer aucune ouverture de ventilation. Installer en suivant les instructions du fabricant.
8 Ne pas installer prĂšs de sources de chaleur, telles que radiateurs, enregistreurs de chaleur, fourneau, ou tout autre
 appareil(ycomprisamplicateurs)quiproduisentdelachaleur.
9 Utiliseruniquementlesxations/accessoiresspĂ©ciésparlefabricant.
10 Conertoutentretienadupersonnelqualié.UnentretienestnĂ©cessairequandl’appareilaétéendommagéde
quelconque façon, notamment quand un liquide ou des corps Ă©trangers sont tombĂ©s dans l’appareil, quand
l’appareil a Ă©tĂ© exposĂ© Ă  la pluie ou Ă  l’humiditĂ©, ne fonctionne pas normalement, ou est tombĂ©.
INSTRUCTIONS POUR L’INSTALLATION
1 CE PRODUIT DOIT ETRE RELIE A LA TERRE. La borne de terre de sĂ©curitĂ© de l’appareil doit ĂȘtre connectĂ©e Ă  la
borne de terre de l’installation. Le cordon ne doit pas dĂ©passer 7.5 mĂštres de long, ĂȘtre de calibre SJ, SJT, or SJE,
10A minimum et avec un marquage VW-1.
2 La connexion secteur de ce produit doit ĂȘtre effectuĂ©e uniquement par l’intermĂ©diaire du connecteur fourni avec
l’appareil, et disponible auprĂšs de Tannoy sous le numĂ©ro de piĂšce 3431-1150.
3 Le cĂąblage de ce connecteur doit ĂȘtre conforme aux instructions de ce manuel, ĂȘtre rĂ©alisĂ© par du personnel quali
 é,etenconformitéaveclesrĂšglesenvigueurlocalement.
4 NepasinstallerceproduitdansunespaceconnĂ©.Nepasrestreindrelaventilationetlacirculationd’airautourdu
panneau arriùre. Veiller à ce qu’il y ait un espace d’au moins 100 mm tout autour du produit pour sa ventilation.
5 Les Ă©lĂ©ments QFlex doivent ĂȘtre assemblĂ©s ou dĂ©sassemblĂ©s uniquement quand la colonne est allongĂ©e sur le sol,
et dĂ©connectĂ©e de l’alimentation secteur.
6 QFlex est conçu pour et est destinĂ© Ă  une utilisation excluant un usage domestique. L’alimentation secteur doit ĂȘtre
assurĂ©e au moyen d’un cĂąblage non volant. L’alimentation de chaque QFlex doit ĂȘtre protĂ©gĂ©e par un fusible ou
coupe-circuit d’un calibre n’excĂ©dant pas 10A. Il doit ĂȘtre possible d’isoler chaque QFlex au moyen d’un commuta
teur à double circuit ayant des contacts distants d’au moins 3mm.
FOR CUSTOMERS IN EUROPE
This product complies with both the LVD (electrical safety) 73/23/EEC and EMC (electromagnetic compatibility) 89/336/
EEC directives issues by the commission of the European community.
Compliance with these directives implies conformity with the following European standards:
EN60065 Product safety
EN55103-1 EMC emissions
EN55103-2 EMC immunity
This product is intended for the following electromagnetic environments: E2; E3 & E4. Environment E1 (domestic) is
specically excluded.
FOR CUSTOMERS IN THE USA & CANADA
This product has been tested for electrical safety and complies with:
UL60065 7th edition 2003
CA /CSA C22.2 No.60065-03
This equipment has been designed to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC
Rules. limits are designed to provide reasonable protection against harmful interference when the equipment is These
operated in a commercial environment.
Industry Canada Class A emission compliance statement: This Class A digital apparatus complies with Canadian
ICES-003.
Avis de conformite’ a’ la re’glementation d’Industrie Canada. Cet appareil nume’rique de classe A est conforme a’ la
norme ICES-003.


Product specificaties

Merk: Tannoy
Categorie: Speaker
Model: QFlex 40

Heb je hulp nodig?

Als je hulp nodig hebt met Tannoy QFlex 40 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Speaker Tannoy

Handleiding Speaker

Nieuwste handleidingen voor Speaker