StarTech.com CPUMNTUD Handleiding

Bekijk gratis de handleiding van StarTech.com CPUMNTUD (2 pagina’s), behorend tot de categorie Flat panel steun. Deze gids werd als nuttig beoordeeld door 22 mensen en kreeg gemiddeld 4.3 sterren uit 4 reviews. Heb je een vraag over StarTech.com CPUMNTUD of wil je andere gebruikers van dit product iets vragen? Stel een vraag

Quick-Start Guide

To view manuals, FAQs, videos, drivers, downloads, technical drawings, and more, visit www.startech.com/support.

Product Diagram (CPUMNTUD)

PartFunction

1Mounting Plate

• Allows for lateral adjustments.

• Mounts the into place.CPU Holder

Note: The needs a minimum table CPU Holder

thickness of .75” (19mm).

2

Adjustment

buttons (2)

• Allows for height adjustments.

Note: The has a height range of minimum CPU Holder

14” (357mm) and maximum 21.9” (557mm).

3

Adjustment

Knobs (2)

• Allows for width adjustments.

Note: The has a width range of minimum CPU Holder

4.84” (123mm) and maximum 9.96” (253mm).

4CPU Holder

• Mounts the CPU.

Note: The has a maximum weight CPU Holder

capacity of 66 lbs (30 kg).

Requirements

For the latest requirements, please visit .www.startech.com/CPUMNTUD

CPU Table Mount

Installation

Notes: StarTech.com is not responsible for any damages related to the installation of

this product.

The needs a minimum table thickness of .75” (19mm).CPU Holder

Please refer to the warning statements prior to installation.

Mounting Plate

1. Align the into position on the mounting surface.Mounting Plate

2. Insert the (6) through the (6) on the Mounting ScrewsMounting HolesMounting

Plate and into the mounting surface.

3. Using a , tighten the (6). Be careful not Phillips Head ScrewdriverMounting Screws

to over-tighten.

CPU Holder

• Align the on the bottom of the with the on the SwivelCPU HolderRailsMounting

PlateRailsSwivelRails. Make sure that the on the are properly aligned with the on

the so that you can easily slide the across the .Mounting PlateCPU HolderRails

Stopper Installation

1. Align two of the with the (2), on one end of the StoppersStopper HolesMounting

Plate.StopperMounting PlateRails Insert the between the base of the and the on

the .Mounting Plate

2. Insert the through the and into the .Stopper ScrewMount Plate RailStopper

3. Using a , tighten the (2). Be careful not Phillips Head ScrewdriverStopper Screws

to over-tighten.

Adjusting the CPU Holder

Width

The has a width range of 4.84” (123mm) - 9.96” (253mm).CPU Holder

1. Loosen the two located on either side of the .Adjustment KnobsCPU Holder

2. Slide the away from the .Width Adjustment BarCPU Holder

3. Once the is at the desired width, tighten the Width Adjustment BarAdjustment

KnobsWidth Adjustment Bar to lock the in place.

4

1

3

2

Product specificaties