Square D QO2L30SCP Handleiding

Bekijk gratis de handleiding van Square D QO2L30SCP (4 pagina’s), behorend tot de categorie Niet gecategoriseerd. Deze gids werd als nuttig beoordeeld door 2 mensen. Heb je een vraag over Square D QO2L30SCP of wil je andere gebruikers van dit product iets vragen? Stel een vraag

1

40269-469-02

03/2006

Lexington, KY, USA

Replaces 40269-469-01 03/1983

Instruction Bulletin

QO

®

Circuit Breaker Load Centers

Retain for future use.

INSTALLATION

Remove Knockouts

1.Turn off all power supplying this equipment before working on or inside

equipment.

2.Drive center knockout inward and alternately pry up or drive in outer rings,

one at a time.

Mount Box

Position box somarking is up for top feed and down for bottom feed.

Pull Conductors Into Box

NOTE:Conductors must enter the box through approved wire clamps, conduit

bushing or by other methods approved for the purpose, to prevent damage to

conductor insulation.

Figure1:Wire Mains and Neutral

DANGER

HAZARD OF ELECTRIC SHOCK, EXPLOSION, OR ARC FLASH

•Apply appropriate personal protective equipment (PPE) and follow safe electrical work

practices. See NFPA 70E.

•This equipment must only be installed and serviced by qualified electrical personnel.

•Turn off all power supplying this equipment before working on or inside equipment.

•Always use a properly rated voltage sensing device to confirm power is off.

•Replace all devices, doors and covers before turning on power to this equipment.

Failure to follow these instructions will result in death or serious injury.

Line

Line

Main Lugs (125 A Max.)Main Circuit Breaker (125 A Max.)

Main Lugs (225 A Max.)

Main Circuit Breaker (225 A Max.)

Product specificaties