SPL MTC Mk2 Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor SPL MTC Mk2 (13 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 12 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/13
MTC Mk2
Monitor & Talkback Controller
Manual
Further information:
mtc-mk2.spl.audio
EN
DE
MTC Mk2
2
Getting started
Read the safety instructions starting on page11.
Make sure that the mains voltage of the MTC Mk2 mentioned in the specications
(page10) corresponds to the voltage of your region.
The power switch on the back of the MTC Mk2 must be in the o position.
(O = O / On = I).
Connect the supplied power cord to the power connector of the MTC Mk2 and to a power
outlet.
If the supplied power cord does not match your mains socket outlet, please contact your dealer.
The devices that are to be connected to the MTC Mk2 must be be switched o.
Connect the outputs of your analog sources to the analog inputs of the MTC Mk2. Please
use appropriate audio cables (TRS, RCA).
Audio cables not included in the scope of delivery.
Connect audio cables between the MTC Mk2 and following ampliers or active monitors
(XLR, TRS).
Audio cables not included in the scope of delivery.
Connect headphones to the headphone outputs of the MTC Mk2.
Warning: Never connect a mono jack cable to the front panel stereo jack. Make sure that the stereo jack is fully inserted,
otherwise a short circuit might damage the headphone amplier.
Power on
Turn down the volume and the headphone volume of the MTC Mk2.
Switch on the power switch on the rear panel of the MTC Mk2 (On = I).
The Power LED and all activated switches light up.
Power o
Turn down the volume and the headphone volume of the MTC Mk2.
Switch o the power switch on the rear panel of the MTC Mk2 (O = O).
The Power LED and all activated switches will no longer light up.
MTC Mk2
4
Loudspeakers
SUB OUT:
Mono summed
output with full
frequency range.
FOOTSWITCH:
Latching or
momentary foot
switch for
Talkback
CUE OUT:
When CUE MIX is activated, only the
signal from IN C/CUE MIX and the
talkback signal (Unity Gain). Phoni-
tor Matrix and monitoring modes are
deactivated.
TALK OUT:
Talkback signal


Product specificaties

Merk: SPL
Categorie: Niet gecategoriseerd
Model: MTC Mk2

Heb je hulp nodig?

Als je hulp nodig hebt met SPL MTC Mk2 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Niet gecategoriseerd SPL

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd