SPL Crescendo duo Handleiding

SPL Receiver Crescendo duo

Bekijk gratis de handleiding van SPL Crescendo duo (6 pagina’s), behorend tot de categorie Receiver. Deze gids werd als nuttig beoordeeld door 66 mensen en kreeg gemiddeld 3.6 sterren uit 33.5 reviews. Heb je een vraag over SPL Crescendo duo of wil je andere gebruikers van dit product iets vragen? Stel een vraag

Pagina 1/6
Crescendoduo
120V Two Channel Microphone Preamplier
EN
Manual
Find more information: spl.audio
DE
Crescendo – Manualduo
Crescendo duo
Two-Channel Microphone Preamplier with
V Technology
The Crescendo features a fully balanced signal flow. The input stage uses duo
 pairs of matched PNP Transistors (Dierential Input Transistors) for extremely
low noise and a very high common mode rejection.
Both input stages have six th generation V SPL SUPRA Operation Ampliers
each.
The transformerless design of the input/output stages guarantees highly linear
amplifying.
The output stages operate as current ampliers and therefore provide Class-A
operation with more than 6mA quiescent current.
Start up
Read the security advices on page .
Make sure that the selected mains voltage of the Crescendo is according to duo
the mains voltage of your region.
Make sure that the mains switch on the rear of the Crescendo duo is set to O
(O = O / ON = I).
Connect the supplied power cord to the Crescendo and an appropriate duo
mains socket outlet.
If the supplied power cord does not match your mains socket outlet, please contact your dealer.
Please connect the outputs of the Crescendo to the inputs of your audio duo
interface or mixing console.
Connect your microphones to the inputs  and  of the Crescendo with duo
high-quality microphone cables.
Microphone cables not included in the scope of delivery.
Switch on mains on the rear of the Crescendo (On = I).duo
The VU meter light up.
1
2
3
4
5
6
7
Crescendo – Manualduo
Specications
Frequency range
-kHz (dB Gain) -dB
Mic pre amp gain
dB (in   dB steps) to
Output gain
+/ dB
Input impedance
 kOhm
Output impedance
<  Ohm
Noise (A-weighted)
(dB Gain) -. dBu
(dB Gain) - dBu
Noise FFT
(dB Gain) -dBu
(dB Gain) -dBu
CMRR
(dB Gain) > dBu/kHz
(dB Gain) > dBu/kHz
THD/N
(dB Gain) .%
(dB Gain) .%
(dB Gain) .%
E.I.N
(dB Gain)  Ohm -. dBu
(dB Gain)  Ohm -.dBu
Power consumption
 .V: W
 V: W
Fuses
 mA (Fast)V
 mA (Fast)V
The phantom power required for condenser microphones can be activated with
the V switch.
If phantom power is on, the V LED lights up blue.
IMPORTANT:
Use phantom power only for condenser microphones. For all other microphone types – especially
ribbon micorphones – switch o the phantom power!
Use the Mic Gain switch to adjust the preamplication gain in  dB steps.to
The Output Gain controls the output level from -  to + dB.
With the OUTPUT switch the signal can be completely switched o.
The polarity of a microphone signal can be inversed (°) with the Polarity
Inversal switch.
The High Pass switch activates a high pass lter with dB per ocatve at  Hz.
If the input signal is too hot, switch on PAD. This reduces the level by dB.
You can make the VU Meters less sensitive by activating the VU-dB switch.
Power down
Switch omains on the back of the Crescendo (O = O).duo
The VU Meter no longer light up.
8
9
10
11
12
13
14
15


Product specificaties

Merk: SPL
Categorie: Receiver
Model: Crescendo duo

Heb je hulp nodig?

Als je hulp nodig hebt met SPL Crescendo duo stel dan hieronder een vraag en andere gebruikers zullen je antwoorden