Soundmaster UR140 Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor Soundmaster UR140 (7 pagina's) in de categorie Wekkerradio. Deze handleiding was nuttig voor 54 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/7
ENVIRONMENTAL PROTECTION
Please contact your local authorities for details about collection points.
The materials are reusable according to t heir markings. By reusing, recycling or
other forms of utilization of old devices you make an important contribution to
the protection of our environment.
Do not dispose of this product with the normal household waste at the end
of its life cycle. Return it to a collection point for the recycling of electrical
and electronic devices. This is indicated by the symbol on the product,
user manual or packaging.
This symbol indicates the presence of dangerous
voltage inside the enclosure, sufficient enough to
cause electric shock.
WARNING
Risk of electric shock
Do not o
p
en!
Caution: To reduce the risk of electric shock, do not remove the
cover (or back). There are no user serviceable parts inside. Refer
servicing to qualified service personnel.
This symbol indicates the presence of important
operating and maintenance instructions for the
device.
Safety, Environmental and Setup Instructions
•Use the device in dry indoor environments only.
•Protect the device from humidity.
•Do not open the device. Refer opening and servicing to qualified personnel.RISK OF ELECTRIC SHOCK!
•Connect this device to a properly installed and earthed wall outlet only. Make sure the mains voltage corresponds with
the specifications on the rating plate.
•Make sure the mains cable stays dry during operation. Do not pinch or damage the mains cable in any way.
•A damaged mains cable or plug must immediately be replaced by an authorized service center.
•In case of lightning, immediately disconnect the device from the mains supply.
•Children should be supervised by parents when using the device.
•Clean the device with a dry cloth only.
Do NOT use CLEANING AGENTS or ABRASIVE CLOTHS!
•Do not expose the device to direct sunlight or other heat sources.
•Install the device at a location with sufficient ventilation in order to prevent heat accumulation.
•Do not cover the ventilation openings!
•Install the device at a safe and vibration-free location.
•Install the device as far away as possible from computers and microwave units; otherwise radio reception may be
disturbed.
•Do not open or repair the enclosure. It is not safe to do so and will void your warranty. Repairs only by authorized
service/ customer center.
•Only use mercury and cadmium-free batteries.
•Used batteries are hazardous waste and NOT to be disposed of with the household waste!!!
Return the batteries to your dealer or to collection points in your community.
•Keep batteries away from children. Children might swallow batteries.
Contact a physician immedi ately if a battery was swallowed.
•Check your batteries regularly to avoid battery leakage.
•Batteries shall not be exposed to excessive heat such as sunshine, fire or the like.
•CAUTION: Danger of explosion if battery is incorrectly replaced
Replace only with the same or equivalent type
14
15
16
17
18 19
20 21 22 23
24
FUNCTION AND CONTROLS
1. TO SET THE LIGHT INTENSITY HIGH
2. TO SET THE LIGHT INTENSITY LOW
3. LIGHT ON/OFF
4. MEMORY/MEMORY+/NAP/AUTO OFF DISPLAY
5. LAMP SHADE
6. SNOOZE / SLEEP / DIMMER
7. SET/ TEMPERATURE
8. << / TUNE - / YEAR/MONTH/DAY
9. ALARM 1 ON / OFF SET
10. DISPLAY
11. ON / OFF
12. >> / TUNE + / DST/C-F
13. ALARM 2 ON / OFF SET
14. VOLUME UP / DISPLAY AUTO CHANGE ON/OFF
15. VOLUME DOWN
16. PROJECTION TIME 180° FLIP/TIME- TEMPERATURE
17. PROJECTION ON/OFF
18. FOCUS ADJUSTMENT FOR PROJECTION UNIT
19. SPEAKER
20. FM ANTENNA
21. TEMPERATURE SENSOR (IN DOOR)
22. BATTERY COMPARTMENT
23. AC POWER CORD
24. RATING LABEL
LED DISPLAY
TIME Indic ator STAN DB Y Indicator
PM Indicator
ALARM 1 In dica tor A LARM 2 Indicator
MH Indicatorz
POWER CONNECTION
Plug the AC power cord to a household outlet AC source. This unit is equipped with a
battery back up system, it requires a 3V CR2032 flat lithium battery (not included).
Insert the battery in the battery compartment, making certain that the positive and
negative (+ and -) battery terminals are attached to the corresponding terminals on the
plate in the battery compartment. If an AC power failure occurs, the clock automatically
switches to the battery power supply, the clock and timer memory continue running.
When the AC power resumes, the clock switches back to AC again.
GETTING STARTED
1. TIME AND CALENDAR MANUAL SETTING
A. Setting Time and Calendar Press set button (7) in normal mode and keep–
depress over 2 seconds to enter time set mode, after enter the setting mode, press
set button (7) to change the mode cycle as follows :
Normal Year Month Day 12/24 H Real time Hour Real time Min → → → → → → →
Normal
Action (during data adjustment):
-Press << / Tune - button (8) to adjust data backward.
-Press >> / Tune + button (12) to adjust data forward.
-Keep depress << or >> button for 2 seconds to enable auto forward.
B. Setting Alarm 1 and Alarm 2 Press alarm set button (9/13) during normal mode–
and keep depress over 2 seconds to enter alarm set mode, after enter the setting
mode, press alarm set button (9/13) to change the mode cycle as follows :
Normal AL 1 Hour AL 1 Min AL 1 wee→ → → kday Alarm AL 1 wake beep AL 1→ →
wake radio AL 1 wake radio volume Light Light intensity Normal.→ → → →
Normal AL 2 Hour AL 2 Min AL 2 weekday Alarm AL 2 wake beep AL 2→ → → → →
wake radio AL 2 wake radio volume Light Light intensity Normal.→ → → →


Product specificaties

Merk: Soundmaster
Categorie: Wekkerradio
Model: UR140

Heb je hulp nodig?

Als je hulp nodig hebt met Soundmaster UR140 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Wekkerradio Soundmaster

Handleiding Wekkerradio

Nieuwste handleidingen voor Wekkerradio