Soundmaster SCD 6800MP3 Handleiding

Soundmaster CD-spelers/recorder SCD 6800MP3

Lees hieronder de 📖 handleiding in het Nederlandse voor Soundmaster SCD 6800MP3 (4 pagina's) in de categorie CD-spelers/recorder. Deze handleiding was nuttig voor 43 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/4

SCD 6800MP3

ENG 1

1.) 3,5 mm STEREO

HEADPHONE JACK

2.) DUMB

3.) VOLUME

4.) FUNCTION SELECTOR

5.) DYNAMIC BASS BOOST

6.) CASSETTE RECORDER KEYS

7.) CD DOOR

8.) HANDLE

9.) BAND SELECTOR

10.) TUNING CONTROL

11.) FM STEREO ICON

12.) DISPLAY

13.) PROGRAM

14.) MODE

15.) SKIP |<</<< >>/>>|

16.) STOP/FOLDER

17.) PLAY/PAUSE

18.) TELESCOPIC ANTENNA

19.) BATTERY DOOR

20.) AC MAINS

8 x 1,5V Type UM-2/C

ENG 2

Power Supply

Whenever convenient, use the power supply if you want to conserve battery life. Make sure you remove the

plug from the set and wall outlet before inserting batteries.

Batteries (not included):

Open the battery compartment and insert eight batteries, type 1,5V UM-2 or C-cells, (preferably alkaline) with

the correct polarity as indicated by the “ + “ and “ – “ symbols inside the compartment.

Batteries contain chemical substances, so they should be disposed of properly. Incorrect use of batteries can

cause electrolyte leakage and will corrode the compartment or cause the batteries to burst. Therefore:

- Do not mix battery types: e.g. alkaline with carbon zinc. Only use batteries of the same type for the set.

- When inserting new batteries, do not try to mix old batteries with the new ones.

- Remove the batteries if the set is not to be used for a long time.

AC Power:

1) Check if the power voltage, as shown on the type plate located on the bottom of the set, corresponds to

your local AC power supply. If it does not, consult your dealer or service centre.

2) Connect the power cord to the AC MAINS inlet and the wall outlet. The power supply is now connected

and ready for use.

3) To switch off completely, unplug the power cord from the wall outlet. Unplug the power cord from the wall

outlet to protect your set during heavy thunderstorms.

General operation:

1) To select your sound source adjust the source selector to MP3.CD/TAPE (OFF)/RADIO

2) Adjust the sound with the VOLUME controls

3) To switch off the set, adjust the source selector (4) to TAPE (OFF) position.

Radio operation:

1) Slide the FUNCTION selector (4) to RADIO

2) Select waveband FM ST. / FM / AM with Band selector (9)

3) Rotate the TUNING control (10) to find the desired stations

4) When you have finished listening, slide the FUNCTION selector (4) to the OFF position

- For FM, pull out the telescopic antenna. Incline and turn the antenna. Reduce its length if the signal is too

strong (very close to a transmitter)

- For AM the set is provided with a built-in antenna so the telescopic antenna is not needed. Direct the

antenna by turning the whole set.

Cassette operation

1) Slide the FUNCTION selector (4) to TAPE (OFF)

2) Press STOP/EJECT (6) to open the cassette door

3) Insert a recorded cassette and close the cassette door

4) Press PLAY (6) to start playback

5) To interrupt playback, press PAUSE (6). To resume, press the key again

6) By pressing << or >> on the set, fast winding of the tape is possible in both directions

7) To stop the tape, press STOP/EJECT (6)

- The keys are automatically released at the end of the tape, except if PAUSE has been activated

Recording from the radio:

1) Tune to the desired radio station (see TUNING TO RADIO STATIONS)

2) Press STOP/EJECT (6) to open the cassette door

3) Insert a suitable cassette into the cassette deck and close the cassette door

4) Press RECORD (6) to start recording

5) For brief interruptions, press PAUSE (6). To resume recording, press PAUSE again.

6) To stop recording, press STOP/EJECT (6)

Playing a CD/MP3

This CD-player can play Audio Discs, CD-R, CD-RW, CD-MP3.

1) Adjust the source selector (4) to CD/MP3. Display: shows “ - - - “ Briefly.

2) To open the CD door (7), press the CD door at the edge marked OPEN

3) Insert a CD with the printed side facing up and press the CD door gently close

4) Press PLAY/PAUSE (17) on the set to start play back

5) To pause playback press PLAY/PAUSE (17) to resume, press PLAY/PAUSE again

6) To stop CD playback, press STOP (16)

Product specificaties

Merk:	Soundmaster
Categorie:	CD-spelers/recorder
Model:	SCD 6800MP3

Heb je hulp nodig?

Als je hulp nodig hebt met Soundmaster SCD 6800MP3 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden

Uw naam*

Jouw email*

Schrijf hier uw vraag

Handleiding CD-spelers/recorder Soundmaster

Soundmaster SCD 6800MP3 Handleiding

12 Juni 2023

Soundmaster RCD1180 Handleiding

26 Mei 2023

Soundmaster CD9290 Handleiding

9 Mei 2023

Soundmaster KCD50 Handleiding

7 Mei 2023

Soundmaster MCD400 Handleiding

5 Mei 2023

Soundmaster RCD 1400 Handleiding

28 April 2023

Soundmaster C500BE Handleiding

27 April 2023

Soundmaster TS500BE Handleiding

24 April 2023

Soundmaster CD9180 Handleiding

16 April 2023

Soundmaster SCD1800 Handleiding

11 April 2023

Handleiding CD-spelers/recorder

Nieuwste handleidingen voor CD-spelers/recorder

Hegel Viking Handleiding

10 April 2024

Philips CDR880 Handleiding

9 April 2024

S.M.S.L PL200 Handleiding

26 Maart 2024

Marantz CD60 Handleiding

25 Maart 2024

GPX PCB319 Handleiding

22 Maart 2024

GPX PRC257B Handleiding

20 Maart 2024

Creek 4040 CD Handleiding

19 Maart 2024

Advance MCX 300 Handleiding

19 Maart 2024

Advance MCX 400 Handleiding

19 Maart 2024

Advance EZY 80 Handleiding

19 Maart 2024