Sony bravia kdl-s40a11 Handleiding

Sony LCD Plasma televisie bravia kdl-s40a11

Lees hieronder de 📖 handleiding in het Nederlandse voor Sony bravia kdl-s40a11 (32 pagina's) in de categorie LCD Plasma televisie. Deze handleiding was nuttig voor 24 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/32
KE-V42A10E
KLV-V40A10E
KLV-S40A10E
KDL-V40A11E
KDL-S40A11E
Installing the Wall-Mount Bracket GB
Installation du support de fixation mural FR
Instalación del soporte de montaje mural ES
Installieren der Wandhalterung DE
De wandmontagesteun installeren NL
Installazione della staffa di montaggio a parete IT
Instalar o Suporte de Montagem na Parede PT
Montering af beslaget til vægmontering DK
Installera väggfästet SE
Seinäasennuskiinnittimen asentaminen FI
Montere veggmonteringskonsollen NO
Τοποθέτηση του στηρίγµατος τοίχου GR
Instalacja uchwytu ściennego PL
Поpядок ycтaновки нacтeнного монтaжного кpонштeйнa
RU
© 2005 Sony Corporation 2-635-540-12(2)
2 (GB)
English
Before installation
To Customers
For product protection and safety reasons, Sony
strongly recommends that wall-mounting of your
Display Unit be performed by a reliable licensed
contractor. Do not attempt to install it yourself.
Your KE-V42A10E/KLV-V40A10E/KLV-S40A10E/
KDL-V40A11E/KDL-S40A11E can be wall-
mounted using SU-PW2 Wall-Mount Bracket (sold
separately). Please provide your contractor with
this installation supplement as well as the
Instructions (supplied with SU-PW2 Wall-Mount
Bracket). Read these documents carefully for safety
and proper installation.
To Sony Dealers and Contractors
Provide full attention to safety during the
installation, periodic maintenance and
examination of this product.
Installing the Display Unit
on a wall
The Display Unit can be installed on a wall by
attaching a Wall-Mount Bracket (sold separately).
Verify your TV’s model number and be sure to use
the bracket specified for your model only. Refer to
the Steps on this leaflet along with the Instructions
supplied with SU-PW2 Wall-Mount Bracket, to
properly carry out the installation.
Sufficient expertise is required for installing
this product. Be sure to subcontract the
installation to Sony dealers or licensed
contractors and pay special attention to safety
during the installation.
Sony is not liable for any damages or injury
caused by mishandling or improper
installation. Your Statutory Rights (if any) are
not affected.
Step 1: Check the parts
required for the
installation
Open the Wall-Mount Bracket package and check
the contents for all required parts along with the
Instructions.
Step 2: Decide on the
installation location
Decide where you want to install your Display
Unit. Turn to the back cover or inside the back
cover for the display installation dimensions and
determine the location.
If you intend to route the cables in the wall, also
determine the position of the cable hole and bore a
hole in the wall.
Refer to the Instructions for the SU-PW2.
Step 3: Install the Plate Unit on
the wall
Change the position of the Mounting Hook Unit
supported shafts.
Refer to the Instructions for the SU-PW2.
Hole for cable routing (One of two)
(GB) 3
GB
3Remove six screws on the rear side of the
Display Unit (for KE-V42A10E only).
4Attach the supplied four hooks with the
supplied four screws (+PSW5 × L16).
Note
When using an electric screwdriver, set the
torque setting to approximately 2 N·m.
Step 4: Install the Display Unit
Refer to the Instructions for the SU-PW2.
Prepare for the installation of
the Display Unit
Before removing the Table-Top Stand, disconnect
all the cables from the Display Unit.
Refer to the Instructions for the SU-PW2.
1Place the Display Unit, with its screen
facing down, on a stable, cloth-covered
work surface, at least 20 cm off the floor.
2Remove the screws that hold the Display
Unit to the Table-Top Stand and detach the
Table-Top Stand from the Display Unit.
Note
Remove the cable holder beforehand when it is
attached to the Display Unit. For details on the
cable holder, refer to the instruction manual of
the Display Unit (for KE-V42A10E/KLV-
V40A10E/KDL-V40A11E only).
Screw into the
recessed screw
holes.

Product specificaties

Merk: Sony
Categorie: LCD Plasma televisie
Model: bravia kdl-s40a11

Heb je hulp nodig?

Als je hulp nodig hebt met Sony bravia kdl-s40a11 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden


Handleiding LCD Plasma televisie Sony

Sony

Sony kdl 32s2030e Handleiding

10 Augustus 2022
Sony

Sony kdf e42a11e Handleiding

16 Augustus 2022
Sony

Sony kdl 46 t 3500 Handleiding

6 Augustus 2022
Sony

Sony kdl 40l4000e Handleiding

7 Augustus 2022
Sony

Sony kdl 40p3600 Handleiding

6 Augustus 2022
Sony

Sony kdl 37p5600k Handleiding

8 Augustus 2022
Sony

Sony kdl 32u4000e Handleiding

7 Augustus 2022
Sony

Sony kdep61mrx1 Handleiding

31 Juli 2022
Sony

Sony kdl 40s5600e Handleiding

10 Augustus 2022
Sony

Sony fwd-50px2 Handleiding

17 Augustus 2022

Handleiding LCD Plasma televisie

Nieuwste handleidingen voor LCD Plasma televisie

Sanyo

Sanyo DP32640 Handleiding

22 September 2023
Sanyo

Sanyo DP50741 Handleiding

22 September 2023
Sanyo

Sanyo DP42841 Handleiding

22 September 2023
Yakumo

Yakumo 81 j Handleiding

1 September 2023
D.BOSS

D.BOSS PDP 4219 Handleiding

23 Augustus 2023
Magnavox

Magnavox 40MF401B Handleiding

19 Juni 2023
Fujitsu Siemens

Fujitsu Siemens MYRICA VQ40-1 Handleiding

14 Augustus 2023
Fujitsu Siemens

Fujitsu Siemens MYRICA PQ50-1 Handleiding

14 Augustus 2023
Metz

Metz linus 32 hdtv 100 Handleiding

26 Juli 2023
Tatung

Tatung v26mmfj-et1 Handleiding

22 December 2022