Smeg KSEG24XU Handleiding

Smeg Afzuigkap KSEG24XU

Lees hieronder de ๐Ÿ“– handleiding in het Nederlandse voor Smeg KSEG24XU (20 pagina's) in de categorie Afzuigkap. Deze handleiding was nuttig voor 23 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/20
KSEG24XU - KSEG30XU
Installation Instructions
Use and Care Information
Instructions d'installation
Utilisez et d'entretien
Instrucciones de instalaciรณn
Informaciรณn de uso y cuidado
2
READ AND SAVE THESE INSTRUCTIONS BEFORE YOU
START INSTALLING THIS RANGE HOOD
WARNING: - TO REDUCE THE RISK OF A RANGE TOP GREASE FIRE:
a) Never leave surface units unattended at high settings. Boilovers cause smoking and
greasy spillovers that may ignite. Heat oils slowly on low or medium setting.
b)๎˜ƒAlways๎˜ƒturn๎˜ƒhood๎˜ƒON๎˜ƒwhen๎˜ƒcooking๎˜ƒat๎˜ƒhigh๎˜ƒheat๎˜ƒor๎˜ƒwhen๎˜ƒ๎›€ambeing๎˜ƒfood๎˜ƒ(i.e.๎˜ƒCrepes๎˜ƒ
Suzette, Cherries Jubilee, Peppercorn Beef Flambรฉ).
c) Clean ventilating fans frequently. Grease should not be allowed to accumulate on fan
or๎˜ƒ๎šฟlter.๎˜ƒ๎˜ƒ
d) Use proper pan size. Always use cookware appropriate for the size of the surface element.
WARNING: - TO REDUCE THE RISK OF INJURY TO PERSONS IN THE EVENT OF A
RANGE TOP GREASE FIRE, OBSERVE THE FOLLOWING*:
a)๎˜ƒSMOTHER๎˜ƒFLAMES๎˜ƒwith๎˜ƒa๎˜ƒclose-๎šฟtting๎˜ƒlid,๎˜ƒcookie๎˜ƒsheet,๎˜ƒor๎˜ƒmetal๎˜ƒtray,๎˜ƒthen๎˜ƒturn๎˜ƒo๓ฐ€จ๎˜ƒthe๎˜ƒburner.๎˜ƒ๎˜ƒ
BE๎˜ƒCAREFUL๎˜ƒTO๎˜ƒPREVENT๎˜ƒBURNS.๎˜ƒ๎˜ƒIf๎˜ƒthe๎˜ƒ๎›€ames๎˜ƒdo๎˜ƒnot๎˜ƒgo๎˜ƒout๎˜ƒimmediately๎˜ƒEVACUATE๎˜ƒ
AND CALL THE FIRE DEPARTMENT.
b) NEVER PICK UP A FLAMING PAN - You may be burned.
c) DO NOT USE WATER, including wet dishcloths or towels - a violent steam explosion will
result.
d) Use an extinguisher ONLY if:
1. You know you have a Class ABC extinguisher, and you already know how to operate it.
๎˜ƒ๎˜ƒ๎˜ƒ๎˜ƒ2.๎˜ƒ The๎˜ƒ๎šฟre๎˜ƒis๎˜ƒsmall๎˜ƒand๎˜ƒcontained๎˜ƒin๎˜ƒthe๎˜ƒarea๎˜ƒwhere๎˜ƒit๎˜ƒstarted.๎˜ƒ๎˜ƒ
๎˜ƒ๎˜ƒ๎˜ƒ๎˜ƒ3.๎˜ƒ The๎˜ƒ๎šฟre๎˜ƒdepartment๎˜ƒis๎˜ƒbeing๎˜ƒcalled.๎˜ƒ๎˜ƒ
๎˜ƒ๎˜ƒ๎˜ƒ๎˜ƒ4.๎˜ƒ You๎˜ƒcan๎˜ƒ๎šฟght๎˜ƒthe๎˜ƒ๎šฟre๎˜ƒwith๎˜ƒyour๎˜ƒback๎˜ƒto๎˜ƒan๎˜ƒexit.
* Based on "Kitchen Firesafety Tips" published by NFPA
WARNING - TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, do not use this fan
with any solid-state speed control device.
WARNING - TO REDUCE THE RISK OF FIRE, ELECTRICAL SHOCK, OR INJURY TO
PERSONS, OBSERVE THE FOLLOWING:
1. Use this unit only in the manner intended by the manufacturer. If you have any
questions, contact the manufacturer.
2. Before๎˜ƒservicing๎˜ƒor๎˜ƒcleaning๎˜ƒunit,๎˜ƒswitch๎˜ƒpower๎˜ƒo๓ฐ€จ๎˜ƒat๎˜ƒservice๎˜ƒpanel๎˜ƒand๎˜ƒlock๎˜ƒthe๎˜ƒ
service disconnecting means to prevent power from being switched on acciden-
tally. When the service disconnecting means cannot be locked, securely fasten a
prominent warning device, such as a tag, to the service panel.
CAUTION: For General Ventilating Use Only. Do Not Use To Exhaust Hazardous or
Explosive Materials and Vapors.
WARNING - TO REDUCE THE RISK OF FIRE, ELECTRICAL SHOCK, OR INJURY TO
PERSONS, OBSERVE THE FOLLOWING:
1. Installation๎˜ƒWork๎˜ƒAnd๎˜ƒElectrical๎˜ƒWiring๎˜ƒMust๎˜ƒBe๎˜ƒDone๎˜ƒBy๎˜ƒQuali๎šฟed๎˜ƒPerson(s)๎˜ƒIn๎˜ƒAccor-
dance With All Applicable Codes And Standards, Including Fire-Rated Construction.
2. Su๓ฐ€ฉcient๎˜ƒ air๎˜ƒ is๎˜ƒneeded๎˜ƒfor๎˜ƒ proper๎˜ƒcombustion๎˜ƒ and๎˜ƒexhausting๎˜ƒ of๎˜ƒgases๎˜ƒ through๎˜ƒ
the๎˜ƒ๎›€ue๎˜ƒ(chimney)๎˜ƒ of๎˜ƒfuel๎˜ƒburning๎˜ƒequipment๎˜ƒ to๎˜ƒprevent๎˜ƒbackdrafting.๎˜ƒFollow๎˜ƒ the๎˜ƒ
heating equipment manufacturer's guideline and safety standards such as those
published๎˜ƒ by๎˜ƒthe๎˜ƒ National๎˜ƒ Fire๎˜ƒ Protection๎˜ƒAssociation๎˜ƒ (NFPA),๎˜ƒ and๎˜ƒ the๎˜ƒAmerican๎˜ƒ
Society๎˜ƒfor๎˜ƒHeating,๎˜ƒRefrigeration๎˜ƒand๎˜ƒAir๎˜ƒConditioning๎˜ƒEngineers๎˜ƒ(ASHRAE),๎˜ƒand๎˜ƒ
the local code authorities.
3
3. When cutting or drilling into wall or ceiling, do not damage electrical wiring and
other hidden utilities.
4. Ducted fans must always be vented to the outdoors.
ALL WALL AND FLOOR OPENINGS WHERE THE RANGE HOOD IS INSTALLED
MUST BE SEALED.
This Range Hood requires at least 24" of clearance between the bottom of the Range Hood
and the cooking surface or countertop. This hood has been approved by UL at this distance
from the cooktop.
This minimum clearance may be higher depending on local building codes. For gas cooktops
and combination ranges, a minimum of 30" is recommended and may be required.
Overhead cabinets on both sides of this unit must be a minimum of 18" above the cooking surface
or countertop. Consult the cooktop or range installation instructions given by the manufacturer
before making any cutouts.
The warranty does not consider the installation of this range hood into manufactured /
mobile homes; so this product is not intended for use in manufactured / mobile home.
See Electrical Requirements.
โ€ข Venting system MUST terminate outside the home.
โ€ข DO NOT terminate the ductwork in an attic or other enclosed space.
โ€ข DO NOT use 4" laundry-type wall caps.
โ€ข Flexible-type ductwork is not recommended.
โ€ข DO NOT obstruct the ๎›€ow of combustion and ventilation air.
โ€ข Failure to follow venting requirements may result in a ๎šฟre.
WARNING
VENTING REQUIREMENTS
Determine which venting method is best for your application. Ductwork can extend either through
the wall or the roof.
The length of the ductwork and the number of elbows should be kept to a minimum to provide ef-
๎šฟcient performance. The size of the ductwork should be uniform. Do not install two elbows together.
Use duct tape to seal all joints in the ductwork system. Use caulking to seal exterior wall or ๎›€oor
opening around the cap.
Flexible ductwork is not recommended. Flexible ductwork creates back pressure and air turbulence
that greatly reduces performance.
Make sure there is proper clearance within the wall or ๎›€oor for exhaust duct before making cutouts.
Do not cut a joist or stud unless absolutely necessary. If a joist or stud must be cut, then a support-
ing frame must be constructed.
WARNING - To Reduce The Risk Of Fire, Use Only Metal Ductwork.
CAUTION๎˜ƒ-๎˜ƒTo๎˜ƒreduce๎˜ƒrisk๎˜ƒof๎˜ƒ๎šฟre๎˜ƒand๎˜ƒto๎˜ƒproperly๎˜ƒexhaust๎˜ƒair,๎˜ƒbe๎˜ƒsure๎˜ƒto๎˜ƒduct๎˜ƒair๎˜ƒoutside๎˜ƒโ€“๎˜ƒDo๎˜ƒ
not vent exhaust air into spaces within walls or ceilings or into attics, crawl spaces, or garages.
Cold Weather installations
An additional back draft damper should be installed to minimize backward cold air ๎›€ow and a nonmetal-
lic thermal break should be installed to minimize conduction of outside temperatures as part of the vent
system. The damper should be on the cold air side of the thermal break. The break should be as close
as possible to where the vent system enters the heated portion of the house.


Product specificaties

Merk: Smeg
Categorie: Afzuigkap
Model: KSEG24XU

Heb je hulp nodig?

Als je hulp nodig hebt met Smeg KSEG24XU stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Afzuigkap Smeg

Handleiding Afzuigkap

Nieuwste handleidingen voor Afzuigkap