SereneLife SLSFE11 Handleiding

SereneLife Kluis SLSFE11

Lees hieronder de đź“– handleiding in het Nederlandse voor SereneLife SLSFE11 (2 pagina's) in de categorie Kluis. Deze handleiding was nuttig voor 29 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/2
SLSFE11
Portable Electronic Safe Box
INSTRUCTIONS
1. TO PROGRAM AND CHANGE
THE USER CODE
a. First, open the door of your safe,
without turning the rotary knob before
you start to program your safe.
Remove the battery compartment cover on the back of the door and
place the batteries (4x1.5 batteries type AA) into the battery holder
correctly. (Batteries included inside the safe).
b. While the door is open, press the button behind the door. The yellow
light will be on with a short beep. Please input the user code (from 3-8
digits) using any number from “0” to “9” within 30 seconds, then press “E”
to conrm it.
c. To change the user code, please use the same procedures as above.
2. TO OPEN THE SAFE
Input the user code you programmed, then press ”E”. The green light will
be on. Please turn the knob within 5 seconds and pull out to open the
safe. If a wrong digit is input, you can press “C” to cancel it.
Note: With each press the yellow light will ash with a short beep,
indicating that the micro processor conrmed it. If the yellow light keeps on
ashing with the beep, it means the code is wrong. Inputting the wrong
code three times will result in the micro processor refusing to accept the
input for 20 seconds. If you press the wrong code three times again, the
micro processor will refuse to accept input for 5 minutes.
3. TO CLOSE THE SAFE
Close the door and turn the knob counter-clockwise to lock the safe.
www.SereneLifeHome.com
4. HOW TO USE YOUR OVERRIDE KEYS
For your convenience, we have engineered a manual override system for
your safe. We have supplied 2 override keys. These keys allow you to
open the safe at all times, even when the batteries are run down or when
you have forgotten your code. The keyhole is situated behind the over
ride cover plate (logo) beside the knob. Take o the cover, insert the
override key and turn anti-clockwise; then open the safe as usual.
5. TO REPLACE THE BATTERIES
If the red light is on with the green light, when you input your personal
code to open the safe, it means the batteries are low and you should
change the batteries. To be sure the batteries are installed correctly,
please test the code before you close the door.
Always use alkaline batteries only.
6. INSTALLING THE SAFE
The safe can be secured to the oor, wall or in a cupboard.
For your convenience, there are holes both in the bottom and on the
back of the safe, so it can be xed by the expansion bolts supplied.
WARNING:
a. Please keep the override keys of the safe in another safe place.
Not inside the safe.
b. In the event the keys are lost, the code is misplaced and the batteries are
weak, the supplier does not take responsibility for this product.
www.SereneLifeHome.com


Product specificaties

Merk: SereneLife
Categorie: Kluis
Model: SLSFE11

Heb je hulp nodig?

Als je hulp nodig hebt met SereneLife SLSFE11 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Kluis SereneLife

Handleiding Kluis

Nieuwste handleidingen voor Kluis