Schneider MTN649802 Handleiding
Pagina's 37 Engels Niet gecategoriseerd
Bekijk de handleiding van Schneider MTN649802 gratis online of download de PDF. Deze handleiding is 5 keer bekeken. Vraag over dit model? Stel een vraag
1
KNX Blind actuator REG-K/x/10 with manual mode
Art. no. MTN649802, MTN649804, MTN649808
© 2012 Schneider Electric
Application Shutter.Blind.Safety.Position.Manual 5700/1.1
●General information
This software application allows you to program series
REG K/x/10 blind actuators with manual operation,
which in turn allows you to control connected blind or
roller shutter drives. The ETS allows you to individually
set the type of connected load, as well as the
functions available to it, for each of the blind actuator's
output channels.
You can also operate the blind actuator using the push-
buttons on the front. For more information see the
section "Operation".
All the settings described refer to ETS version 3, but
you can use all the settings and functions with ETS
version 2 as well.
Maximum number of group addresses: 252
Associations: 252
½Caution!
If you switch back to the preset values in either
ETS 2 or ETS 3 (by clicking "Standard"), then all
the values that you have changed so far will be
deleted!
|Note: Due to the fact that various functions
depend on other functions, these dependant
functions are only visible and selectable in the
ETS when the preceding function has been
enabled. If you de-select functions or
parameters, group addresses that have already
been connected may be deleted.
|Note:Due to the fact that the output relays of a
channel are locked against each other, you
cannot switch on both outputs of the channel in
question at the same time.
|Note: The application files (vd2 and vd3) are
configured in such a way that the application
loading time is considerably reduced. When you
convert a ETS 2 project to ETS 3, you lose this
time saving. It therefore makes sense to load
the vd3 file when using ETS 3.
●Application functions
The software application for the blind actuator
provides you with numerous functions, which can be
broken down into three groups. The description of the
functions specifies and explains the parameters that
are relevant for these functions. You will find an
overview of all the parameters of the ETS application
for the blind actuator in the last section "Parameters
and settings“.
Basic functions
These functions allow you to commission the device
and equip it with simple functionality.
–Move height positions and slat opening angle
manually
Advanced functions
–Move height position and slat opening angle using
absolute position commands
–Automatic control
–Calibration/Reference movement
–Disable function for manual operating options
–Preset function
–Scene function
Higher-level functions
Higher-level functions are executed before the basic
function and advanced functions. There are four
higher-level functions:
–Weather alarm
–Alarm function
–Disable function
–Limit travel range
You can select the priorities freely:
A higher-level function only becomes active if there is
no other higher-level function active at the same time.
If a higher-level function is reset and there is another
higher-level function of lower priority active at the
same time, then the actions of the lower priority
function are then carried out.
0.1Shutter.Blind.Safety.Position.Manual
5700/1.1
Tab Parameter
GeneralPriority sequence of higher-level
functions
Product specificaties
| Merk: | Schneider |
| Categorie: | Niet gecategoriseerd |
| Model: | MTN649802 |
Heb je hulp nodig?
Als je hulp nodig hebt met Schneider MTN649802 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden