Schlage FC21 Handleiding

Bekijk gratis de handleiding van Schlage FC21 (2 pagina’s), behorend tot de categorie Niet gecategoriseerd. Deze gids werd als nuttig beoordeeld door 15 mensen. Heb je een vraag over Schlage FC21 of wil je andere gebruikers van dit product iets vragen? Stel een vraag

*P518-149*

P518-149

L

This lock can be installed as passage (hall/closet) or privacy (bed/bath).

See the included Privacy function kit.

a

b

c

d

e

f

b

a

g

h

j

k

i

l

a. Knob/Lever

b. Trim

c. Exterior chassis

d. Latch

e. Interior chassis

f. Chassis screws

g. Backplate

h. Faceplate

i. Drive-in faceplate

j. Latch/strike screws

k. Strike

l. Hex wrench (Do not discard!)

1 Watch the installation video.

Go to Schlage.com/faqs-custom.

2 Check door dimensions.

2a If dimensions do

not match, you

may need to

modify your door.

For further assistance,

call Customer Service

at (888) 805-9837.

2b Check latch length.

Measure the backset as shown above.

• 2 3/8" (60 mm): no adjustment is necessary.

• 2 3/4" (70 mm): see the Adjust latch section.

3 Install the latch.

3a Install backplate.





This backplate

is backward.

Rotate into

place. Notch

goes here.

3a Install drive-in faceplate.

Push to snap.

3b Add faceplate and secure with

screws.

Bevel must face

door frame!

Actual Size (2)

3b Use wood block and hammer.

Bevel must face

door frame!

4 Install the strike onto the door frame.

Actual Size (2)

Use included strike for

best performance.

5 PRIVACY FUNCTION ONLY: Choose privacy pin location.

Location is based on preference and does not change the function.

Pin on bottom, go on to step 6.

Pin on top, go to

Schlage.com/faqs-custom.

6 Identify the exterior and interior chassis

Pegs

Interior

Chassis

Posts

Slots

Exterior

Chassis

7 Install the exterior chassis.

Push rmly!

8 Install the interior chassis.

8a Chassis is spring-loaded. Push pegs into

slots and hold in place.

8b Secure with two (2) screws.

Hold in place!

Actual Size (2)

Make sure

chassis is

straight!

9 Install the trim.

L

Align hole in trim with hole in chassis.

click

hook

OR

click

hook

Repeat for the other side of the door.

10 Install the exterior knob/lever.

10a Push knob/lever rmly into

place.

10b Then tighten set screw.

11 PRIVACY FUNCTION ONLY: Install the privacy pin.

Follow the included

Privacy function kit instructions.

12 Install the interior knob/lever.

12a Push knob/lever rmly into

place.

12b Then tighten set screw.

Adjust latch

For 2 3/4" backset, rotate and pull latch out to long setting.

2 1/8" (54 mm)

hole

Backset

2 3/8" or 2 3/4"

(60mm or 70mm)

1 3/8" - 1 3/4"

(35mm) - (44mm)

1" (25 mm) hole

OR

OR

OR

Emergency

unlock tool

Privacy pin

Pin cap

Model FC21, Combined interiorInstallation Instructions

Customer Service

(888) 805-9837www.schlage.com

Product specificaties