Samsung SWT50B3 Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor Samsung SWT50B3 (7 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 41 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/7
BEFORE USING THE WASHING MACHINE
1
PRECAUTIONS 1
CONTROL PANEL 1
DESCRIPTION AND CLEANING OF PART 2
WASHING PROCEDURE 3
To Wash 3
To Spin Dry 3
To Rinsing 3
Overflow rinse 3
Additional rinse 4
INSTALLATION 4
Location 4
Connecting the drain hose
4
Mounting the legs
4
LAUNDRY GUIDE 5
MAINTENANCE 5
TROUBLE SHOOTING 5
WASHING MACHINE
Owner’s Instructions
SWT50A1(P) / SWT50A2(P) / SWT50B1(P) / SWT55B1
Before operating the washing machine, please read this manual
thoroughly, and retain it for future reference.
•Remove the cap-hose
from the drain hose.
•In the case of pump drained
washer, remove
the cap-hose from
the drain hole.
•Don't use excessively hot water.
(50ËšC or more)
Plastic parts may be deformed or damaged.
Also, clothing may be deformed or decolored.
•Before washing,check all pockets.
If nails or pins remain in pockets,they may
damage the washer or clothes.
•Close the water tap a little if the
water pressure is too high.
•Never splash water on the control panel.
•Be sure to cover with the inner
cover on laundry before spinning.
This prevents laundry from
being tossed out and damaged.
•To avoid water splashes, close the
wash tub lid.
•Be sure laythe drain hose down.
(in case no drain pump)
•Be sure that the washer is grounded.
To avoid electrical shock,use a
metal pipe for the ground
connection. But, don't ground the
washer with gas pipes or telephone
lines to avoid to dangers of explosion
or lightning strike.
•Do not put your hands into the
spin dryer basket when it is
spinning.
Your fingers can be caught by
spinning laundry and damaged.
•Never allow children to operate
or play with the washer.
Children playing with the
washer may accidentally
fall into the washing tub.
•Disconnect the power cord from the
power supply when not in use.
•Ventilation opening must not be obstructed
by carpeting when the washing machine is
installed on a carpeted floor.
•If the supply cord of this appliance is
damaged, it must only be replaced by a repair
shopappointed by the manufacturer, because
special purpose tools are required.
•Warning to avoid overfilling and damages this
appliance must be filled with the operator
present using a moderate water supply
pressure only.
•
Do not store or use gasoline or other flammable
vapors and liquids in the vicinity of this or any
other appliance.
•
To avoid overfilling and damages this appliance
must be filled with the operator present using a
moderate water supply pressure only.
1.WASH TIMMER
This is used to set the
wash time, 1-15 minutes.
2.CYCLE SELECTOR
This is used to set the
Washing/Rinsing
or Draining.
3.SPIN DRY TIMER
This is used to set the
spin time, 1-5 minutes.
4.WATER SELECTOR(FOR SW-50B1)
During washing, WATER SELECTOR
KNOB should be selected.
During spin rinsing, WATER
SELECTOR KNOB should
be selected.
CONTROL PANEL
Wa sh /R in se
Dra in R inse
CYCLE SELECTOR
Wa sh
Dra in
CYCLE SELECTOR
0
3
1
42
5
SPIN DRY TIMER
0
9
3
12 6
15
WASH TIMER
WATER SELECTOR
Wa s h S pin
BEFORE USING THE WASHING MACHINE
CAUTIONS
PRECAUTIONS WHEN OPERATING
1
HOW TO CLEAN THE FILTER
(In case drain pump)
1. Place a rag under the washer filter
not to wet the floor.
2. Rotate the filter counterclockwise
and pull out the filter.
3. Remove dirts and
rotate the filter
clockwise until it
locks in position.
When you open this
lid while the spin basket is
spinning,the spinning will
be stopped by the brake
system.
POWER CORD
EARTH WIRE
WATER DRAIN HOSE
(without pump)
SPIN DRYER BASKET
PULSATOR
The plug’s shape
may not be similar to that
shown in this drawing.
SPIN DRYER LID
(with pump)
WASH TUB LID
Be sure to keep
the lid closed
during washing
and spinning.
WASH TUB
DRAIN FILTER
DRAIN HOSE
OVERFLOW
FILTER
LINT FILTER
INNER LID
DESCRIPTION AND / CLEANING OF PARTS
.
This is used for
gathering the
dregs made
during washing.
OVERFLOW FILTER
• Pull the upper side of the
overflow filter with your
fingers into the holes
in the direction of
arrow as shown
in the figure.
CLEANING THE LINT FILTER
• If the dregs are piled up in the
lint filter after finishing the wash,
push down and
pull it out as
shown in the
figure.
• Wash the filter
net in water.
OVERFLOW FILTER
Pull the upper side of the
overflow filter with
two
fingers inserted into
hole ‘A’ in the
direction of arrow
as shown in the figure.
A
CLEANING THE FILTER
• Pull the overflow filter out and take up
the filter by removing 3 screws as
shown in figure. Wash the filter and
washing tub.
• Push the strainer(filter) out and take
up the filter as shown in figure.
Wash the filter and washing tub.
DRAIN FILTER
In case of incomplete drain,
disassemble the drain filter with
screw driver(+), and remove
lints from the filter as shown
in the filter as shown in
the figure.
CLEANING THE WASH TUB
First, fill water in the wash tub to ‘L’ level( , then drain water from the wash tub simultaneously with
operating wash cycle for 1~2 minutes. •Close the wash tub lid.
2


Product specificaties

Merk: Samsung
Categorie: Niet gecategoriseerd
Model: SWT50B3

Heb je hulp nodig?

Als je hulp nodig hebt met Samsung SWT50B3 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Niet gecategoriseerd Samsung

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd