Ryobi RLT5030 Handleiding

Ryobi Grastrimmer RLT5030

Lees hieronder de 📖 handleiding in het Nederlandse voor Ryobi RLT5030 (25 pagina's) in de categorie Grastrimmer. Deze handleiding was nuttig voor 29 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/25

RLT5030

ORIGINAL INSTRUCTIONS

Electric Line Trimmer

and Edge Trimmer

Important!

It is essential that you read the instructions in this manual before operating

this machine.

Subject to technical modications.

Safety

GENERAL SAFETY WARNINGS

WARNING

When using the product, the safety rules must be

followed. For your own safety and that of bystanders,

please read these instructions before operating the

product. Please keep the instructions safe for later use.

WARNING

The product is not intended for use by persons (including

children) with reduced physical, sensory or mental

capabilities, or lack of experience and knowledge,

unless they have been given supervision or instruction

concerning use of the product by a person responsible

for their safety.

Children should be supervised to ensure that they do not

play with the product.

TRAINING

■ Never allow children or people unfamiliar with these

instructions to operate the product.

■ Keep the area clear of all bystanders, children and pets

while using the product. Stop the product if anyone

enters the area.

■ Never operate the product when you are tired, ill or

under the influence of alcohol, drugs or medicine.

■ Use the product for cutting grass and light weeds only.

Do not use for any other purpose.

■ Keep in mind that the operator or user is responsible

for accidents or hazards occurring to other people or

their property.

ELECTRICAL

■ Avoid unintentional starting. Always check that the

switch is in the off position before plugging in the

product to the power supply. Do not carry a plugged in

product with your finger on the switch.

■ Electrical power should be supplied via a residual

current device (RCD) with a tripping current of not more

than 30 mA.

■ Before use, examine the power cord or extension cable

for damage. If there are signs of damage, it must be

replaced by a qualified service technician.

■ Do not use the product if the electric cables are

damaged or worn.

■ If the power cord or extension cable becomes

damaged during use, disconnect from the power supply

immediately. Do not touch the electric cables until the

power supply has been disconnected. Do not repair.

Replace only with identical electric cable.

■ Extension cable must be uncoiled during use. Coiled

cables can overheat.

■ Make sure the power cord is positioned so that it will not

be stepped on, tripped over or otherwise subjected to

damage or stress.

■ Never carry the product by the power cord.

■ Never pull by the power cord to disconnect from the

power supply.

■ Keep the power cord away from heat, oil and sharp

edges.

■ Make sure voltage is correct for the product. A

nameplate on the product indicates the product’s

voltage. Never connect the product to an AC voltage

that differs from this voltage.

■ Make sure the switch is in the off position before

disconnecting from the power supply.

■ For storage, always disconnect from the power supply

and wind cable.

PREPARATION

■ Always wear protective non-slip footwear and long

trousers.

■ Before use, check that there are no damaged parts. A

defective switch or any part that is damaged should be

properly repaired or replaced by an authorized service

facility.

■ Consider the environment in which you are working.

Keep the working area free from wires, sticks, stones

and debris.

■ Make sure the head attachment is properly installed

and securely fastened.

■ Make sure all guards, deflectors and handles are

properly and securely attached.

OPERATION

■ To avoid using the product in bad weather especially

there is a risk of lightning.

■ Use the product in daylight or good artificial light.

■ Avoid using on wet grass.

■ Keep proper footing and balance at all times.

■ Do not walk backwards when using the product.

■ Walk, never run.

■ Keep the head attachment below waist level.

■ Do not cut on surfaces other than grass on ground.

■ Never operate the product with damaged guards or

without guards in place.

■ Never fit a metal replacement line.

■ Keep hands and feet away from the cutting means at

all times and especially when switching on the product.

■ Never pick up or carry the product by the electric cable.

■ Beware of objects thrown by the cutting line.

■ Switch off and disconnect from the power supply before:

–servicing

–leaving the product unattended

Product specificaties

Merk:	Ryobi
Categorie:	Grastrimmer
Model:	RLT5030

Heb je hulp nodig?

Als je hulp nodig hebt met Ryobi RLT5030 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden

Uw naam*

Jouw email*

Schrijf hier uw vraag

Handleiding Grastrimmer Ryobi

Ryobi RBC36X26E Handleiding

30 April 2023

Ryobi RBC430SBS Handleiding

6 April 2023

Ryobi RLT5027 Handleiding

27 Maart 2023

Ryobi RLT3123 Handleiding

26 Maart 2023

Ryobi One+ RLT1831H20F Handleiding

25 Maart 2023

Ryobi RLT1832133H Handleiding

23 Maart 2023

Ryobi RLT430CESD Handleiding

15 Maart 2023

Ryobi RLT5030S Handleiding

13 Maart 2023

Ryobi RY30564 Handleiding

8 Maart 2023

Ryobi One+ RY18EGA Handleiding

8 Maart 2023

Handleiding Grastrimmer

Nieuwste handleidingen voor Grastrimmer

Worx WG185E Handleiding

26 April 2024

Worx WG157E Handleiding

26 April 2024

Worx WG183E Handleiding

17 April 2024

Worx WG119E Handleiding

17 April 2024

Shindaiwa T236TS Handleiding

11 April 2024

Fieldmann FZS 2107-E Handleiding

11 April 2024

Shindaiwa B45 Handleiding

11 April 2024

Shindaiwa B45LA Handleiding

11 April 2024

Grizzly ERT 3525 Handleiding

27 Maart 2024

Draper GTP34 Handleiding

27 Maart 2024