Ryobi One+ RY18BI150B Handleiding

Ryobi Niet gecategoriseerd One+ RY18BI150B

Lees hieronder de 📖 handleiding in het Nederlandse voor Ryobi One+ RY18BI150B (4 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 141 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/4

RY18BI150B

IMPORTANT!

The product is not intended to be used or cleaned by persons

with reduced physical, sensory, or mental capabilities or lack of

experience or knowledge unless they have been given instructions

concerning the safe use of the product by a person legally

responsible for their safety. They should be supervised while using

the product. Children shall not use, clean, maintain, or play with the

product, which when not in use should be secured out of their reach.

Subject to technical modication.

Safety, performance, and dependability have been given top priority

in the design of your battery inverter.

INTENDED USE

The product may be used for the following purposes:

■operating and charging USB-powered devices

■supplying electrical power for operating compatible small

electronics such as cell phones, tablets, laptops, LED lights, fans,

radios, etc.

■charging RYOBI 18V ONE+ battery packs

The product is intended for indoor use only.

When a battery pack is installed, the product converts DC electricity

to the charging power outputs listed in this manual, allowing the user

to charge and power a variety of devices. If a battery pack is being

charged, the battery inverter does not provide power to any device

connected to the USB-A charging ports.

The product’s AC receptacle has a non-sinusoidal output and is not

recommended for use with certain types of sensitive electronics or

electrical devices containing a compressor. Refer to the electronics’

operator’s manual.

The product is rated at 150 W power output. Check the power rating of

your electrical device before using it with the product. Do not use the

product if the power rating of your electrical device exceeds 150 W.

GENERAL SAFETY WARNINGS

Read and understand all instructions. Failure to follow all

instructions listed below may result in electric shock, re, and/or

serious injury.

■Save these instructions. Refer to them frequently and use them to

instruct others who may use this product. If you loan someone the

product, loan them these instructions also.

■Do not expose the product to rain, wet, or damp conditions. Water

entering the product increases the risk of electric shock.

■Use the product with the provided power supply unit only.

■Do not use the product if it has been dropped or received a sharp

blow. A damaged product increases the risk of fire. Always inspect

the product for damage before use.

■Remove the battery pack from the product when not in use.

■Do not disassemble or modify the product. Electric shock hazard

may occur even when a battery is not installed. Any part that is

damaged should be properly repaired or replaced by an authorised

service centre.

100%

30%

60%

A B C D

RY18BI150B-120

■To reduce the risk of injury, close supervision is necessary when

the product is used near children.

■Store the product indoors and away from children.

■Use caution when plugging or unplugging other devices into the

product. Do not force plugs into the product.

■If the product is used in a manner not specified by the manufacturer,

the protection provided by this equipment may be impaired.

■Do not overload the product. The product must be used for

powering devices less than the product rating.

■Never block the air vents. Blocked vents may cause overheating.

The product automatically turns off when overheated.

■Keep the product cool. Do not place the product near heat vents

or in direct sunlight.

■Do not use the product around flammable fumes and gases, such

as in the bilge of a boat or near propane tanks.

■Do not put foreign objects into the product.

■Operate the product using only the AC power type listed in the

product specifications.

■The product should never be hard-wired into a circuit.

■Do not leave the product unattended during operation.

■Operate the product only in temperatures between 0°C and 40°C.

■Do not use the product to power life support devices or other

medical equipment.

■Risk of electric shock. When using a grounded appliance, the

product does not provide an electrical path to earth ground. Do

not power devices which are damaged or with damaged or frayed

power cords.

■An internal cooling fan runs to regulate the product’s operating

temperature. Always wait for the fan to stop before disconnecting

the battery pack from the product.

■Use RYOBI 18V ONE+ battery packs only. Do not use battery

packs from other manufacturers.

■Do not at any time, let brake fluids, gasoline, petroleum-based

products, penetrating oils, etc., come in contact with plastic parts.

Chemicals can damage, weaken, or destroy plastic, which could

result in serious personal injury.

■The light source of the product is not replaceable. When the light

source reaches its end of life, the product must be replaced.

■Do not use a multiple socket outlet or adaptor on the AC socket.

■Do not recharge primary cells (non-rechargeable).

■Remove the battery pack from the product before charging.

■Do not mix battery packs of different types or levels of use.

■Protect the battery contact terminals from metallic objects to avoid

a short circuit, which can cause fire or explosion.

■Do not charge battery packs that show signs of leaks. Dispose of

them properly.

■Do not place the product and battery pack in an area of extreme

heat or cold. They work best at normal room temperature.

■Never charge a damaged battery pack. Replace damaged battery

packs immediately.

■When charging, the charger and battery pack should be placed in

a location where the temperature is more than 10°C but less than

25°C.

OPERATION

CHARGING THE BATTERY PACK

The green LED on the battery pack ashes when charging the battery

pack and remains on after the battery pack is fully charged.

MAINTENANCE

■When not using or when cleaning the product, disconnect it from

the power supply and remove the battery pack.

■Avoid using solvents when cleaning plastic parts. Most plastics are

susceptible to damage from various types of commercial solvents

and may be damaged by their use. Use clean cloths to remove

dirt, dust, oil, or grease.

KNOW YOUR PRODUCT

See illustration.

1. Battery port

2. Area/warning light button

3. Power button

4. USB-C charging port

5. USB-A charging port

6. AC socket

SYMBOLS ON THE PRODUCT

Safety alert

Remove the battery pack before starting any work on

the product.

Beware of electric shock hazard.

Do not expose the product to rain or damp conditions.

Read and understand all instructions before operating

the product. Follow all warnings and safety instructions.

Class II: Protection against electric shock relies on

double insulation or reinforced insulation.

Press the power button for 2 seconds to turn the

product on or o󰀨.

F20A*2

Fast blow fuse

Indoor use only

European Conformity Mark

British Conformity Mark

EurAsian Conformity Mark

Ukraine Conformity Mark

Do not dispose of waste batteries, waste electrical and

electronic equipment as unsorted municipal waste.

Waste batteries and waste electrical and electronic

equipment must be collected separately. Waste

batteries, waste accumulators, and light sources

have to be removed from the equipment. Check with

your local authority or retailer for recycling advice

and collection point. According to local regulations,

retailers may have an obligation to take back waste

batteries and waste electrical and electronic equipment

free of charge. Your contribution to the reuse and

recycling of waste batteries and waste electrical and

electronic equipment helps to reduce the demand

of raw materials. Waste batteries, in particular

containing lithium, and waste electrical and electronic

equipment contain valuable and recyclable materials,

which can adversely impact the environment and the

human health if not disposed of in an environmentally

compatible manner. Delete personal data from waste

equipment, if any.

PRODUCT SPECIFICATIONS

Battery inverter RY18BI150B

Rated supply 18 V d.c.16 A max

288 W max

AC output 230 V d.c. 50 Hz

150 W

USB-A total output 18 W max

5 V d.c. 3 A / 9 V d.c. 2 A / 12 V d.c. 1.5 A

USB-C output PD 30 W max

5 V d.c. 3 A / 9 V d.c. 3 A / 12 V d.c. 2.5 A / 15 V d.c. 2 A / 20 V d.c. 1.5 A

Charge output 18 V d.c. 1.5 A

Dimensions 142 x 90 x 74 mm

Weight 370 g

BATTERY

Model RY18BI150B-120 RY18BI150B-0

Battery pack 2.0 Ah -

Compatible battery packs RB18..

Product specificaties

Merk:	Ryobi
Categorie:	Niet gecategoriseerd
Model:	One+ RY18BI150B

Heb je hulp nodig?

Als je hulp nodig hebt met Ryobi One+ RY18BI150B stel dan hieronder een vraag en andere gebruikers zullen je antwoorden

Uw naam*

Jouw email*

Schrijf hier uw vraag

Handleiding Niet gecategoriseerd Ryobi

Ryobi One+ RY18BI150B Handleiding

17 Juli 2023

Ryobi RC18640 Handleiding

22 Juni 2023

Ryobi CR120 Handleiding

17 Juni 2023

Ryobi RSH2445B Handleiding

9 Juni 2023

Ryobi One+ R18PDID2 Handleiding

22 Mei 2023

Ryobi RY18BLA Handleiding

19 Mei 2023

Ryobi RPN780 Handleiding

6 Mei 2023

Ryobi RLT36BS Handleiding

20 April 2023

Ryobi RBCLLG1 Handleiding

18 April 2023

Ryobi One+ R18CK3D Handleiding

16 April 2023

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd

Playtive IAN 327221 Handleiding

1 Mei 2024

Samsung UN32J4001AF Handleiding

1 Mei 2024

Bauknecht KSI 18GF2 P2 Handleiding

27 April 2024

Fakir Artemis TS 150 Handleiding

26 April 2024

Sony UTX-M03 Handleiding

26 April 2024

Sony URX-P03 Handleiding

26 April 2024

Sony WRU-806B Handleiding

26 April 2024

Sony UTX-B03 Handleiding

26 April 2024

Sony UTX-P03 Handleiding

26 April 2024

Sony ODS-L10 Handleiding

26 April 2024