RP Lighting & Fans BVF50L Handleiding
Pagina's 2 Afzuigkap
Bekijk de handleiding van RP Lighting & Fans BVF50L gratis online of download de PDF. Deze handleiding is 1 keer bekeken. Vraag over dit model? Stel een vraag
WARNING
READ AND SAVE THESE INSTRUCTIONS
Installer: Leave this manual with the homeowner.
CAUTION
CLEANING & MAINTENANCE
OPERATION
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR PERSONAL INJURY, OBSERVE
THE FOLLOWING:
•Use this unit only in the manner intended by the manufacturer. If you have questions, contact
the manufacturer at the address or telephone number listed in the warranty.
•Before servicinge panel. If possible, lock or cleaning the unit, switch the power off at the servic
out the switch. If the switch cannot be locked, securely fasten a prominent warning device,
such as a tag, to the service panel.
•Installation work and electrical wiring must be performed by a qualified person(s) in accordance
with all applicable codes and standards, including fire-rated construction codes and standards.
•Sufficient air is needed for proper combustion and exhausting of gases through the flue
(chimney). Proper venting is essential to expel gases safely and prevent backdrafting. Follow
the heating equipment manufacturpublisheder’s guideline and safety standards such as those
by the National Fire Protection Association (NFPA), and the American Society for Heating,
Refrigeration, and Air Conditioning Engineers (ASHRAE), and the local code authorities.
•When cutting or drilling into the wall or ceiling, do not damage electrical wiring and other hidden
utilities.
•Ducted fans must always be vented to the outdoors.
•Acceptable for use over a tub or shower when connected to a GFCI (Ground Fault Circuit
Interrupter) protected branch circuit.
•This unit must be grounded.
•For general ventilating use only. Do not use to exhaust hazardous or explosive materials and
vapors.
•This product is designed for installation in ceilings that have up to a 12/12 pitch (45 degree
angle). The duct connector must point up.
•To avoid motor bearing damage and noisy and/or unbalanced impellers, keep drywall spray,
construction dust, and other contaminants out of power unit.
•Please read the specification label on the product for further information and requirements.
•Do not use in a cooking area.
Use an on/off switch to operate this fan. See “Connect Electrical Wiring” for details.
MODEL: BVF50L BVF70L
BATH VENTILATION FAN
For quiet and efficient operation, long life, and an attractive appearance, lower or remove the grille and
vacuum the interior of the unit with a dusting brush attachment.
The motor is permanently lubricated and never needs oiling. If the motor bearings make excessive or
unusual noise(s), replace the motor with the same motor. The impeller should also be replaced.
1
ASSEMBLY INSTRUCTIONS
CONNECT ELECTRICAL WIRING
INSTALL GRILLE
2
WIRE
PANEL
UNIT
BLACK (BLK)
LIGHT
SWITCH BOX
FAN
POWER SUPPLY
120V AC
GROUND (GRD)
BLUE (BLU)
WHITE (WHT)
FAN
RECEPTACLE
LIGHT
RECEPTACLE
LIGHT
FAN
UNIT
SWITCH BOX
LINE
IN
FAN
SWITCH
LIGHT
SWITCH
BLK
BLU
BLK
WHT
WHT
WHT
GRD
Housing
Ceiling
5/16in.
1.Insert the light plug from the grille assembly into the wire panel.
2.Pinch the grille springs on the sides of the grille and position
the grille into the housing, with the grille springs in the appropriate
slots.
3.Push the grille assembly towards the ceiling to secure.
TEL: 800.937.6925ax: | F 800.207.9509 | www.rplighting.com
POSITION THE HOUSING ASSEMBLY
Position the housing assembly against the joist. With
a pencil, trace an outline of the housing assembly
onto the ceiling. Set the housing aside, and cut out
an opening for the fan.
Note: Hold the housing position 5/16" above the
ceiling edge.
MOUNT DIRECTLY TO JOIST OR I-JOIST
Place the housing assembly in the opening so the
bottom edge is flush with the finished ceiling. Fasten
the housing assembly to the joist using nails.
WARRANTY
ONE YEAR LIMITED WARRANTY from the original date of purchase against defects in material and
workmanship. This warranty is limited up to the amount of the original purchase price of the product,
excluding any labor cost. For inquiries please visit WWW.RPLIGHTING.COM or call 1-800-937-6925.
Run 120V AC house wiring to the location of the fan. Use only UL-approved wiring connectors
(not included) to attach the house wiring to the wiring plate. Refer to the wiring diagram and connect
the wires as shown.
v1.0
Product specificaties
| Merk: | RP Lighting & Fans |
| Categorie: | Afzuigkap |
| Model: | BVF50L |
Heb je hulp nodig?
Als je hulp nodig hebt met RP Lighting & Fans BVF50L stel dan hieronder een vraag en andere gebruikers zullen je antwoorden