Roland RMP-3 Handleiding

Roland Niet gecategoriseerd RMP-3

Lees hieronder de đź“– handleiding in het Nederlandse voor Roland RMP-3 (10 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 14 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/10
– 1 – C5100025 1RCC
fig.Panel
1. Mini Speaker
For the metronome’s beep sound only. If the
OUTPUT jack is being used, no sound is
output.
2. [METRONOME] Button
Selects the metronome parameter.
3. [START/STOP] Button
Starts and stops the metronome.
4. PHONES VOLUME Knob
Adjusts the OUTPUT jack’s volume.
* The volume of the mini speaker is adjusted with CLICK
VOLUME.
5. [COACH] Button
Selects the Coach mode.
6. VALUE [+]/[-] Button
Use these buttons to change the values of
each parameter.
To increase the value rapidly, hold down [+]
and press [-]. To decrease the value rapidly,
hold down [-] and press [+].
7. BEAT Indicator
Flashes along quarter notes.
Red indicator flashes on accent beats.
8. Head
9. Sensor
10.Tuning Bolts
Adjusts the head tension.
Thank you, and congratulations on your choice of the Roland RMP-3.
Before using this unit, carefully read the sections entitled: “USING THE UNIT SAFELY” and “IMPORTANT NOTES” (on another
leaflet). These sections provide important information concerning the proper operation of the unit. Additionally, in order to feel
assured that you have gained a good grasp of every feature provided by your new unit, Owner’s manual should be read in its
entirety. The manual should be saved and kept on hand as a convenient reference.
As shipped, the RMP-3’s battery is not installed. Please read “Preparations—Loading the Battery” and follow the
instructions to install the battery.
Copyright © 2005 ROLAND CORPORATION All rights reserved. No part of this publication may be reproduced in any form
without the written permission of ROLAND CORPORATION.
Panel Description
1
2
4
5
3
7
9
10
8
6
– 2 –
Side Panel
fig.Side
1. Security Slot ( )
http://www.kensington.com/
2. MIX IN Jack
For connecting an external audio source
(CD, MD, etc.) for playing along.
3. OUTPUT Jack
For headphones, amp, or audio system.
* The RMP-3 outputs sounds in monaural.
4. AC Adaptor Jack
Connect the AC adaptor (optional) here.
5. POWER Switch
Turns the power on/off.
fig.BattCase.e_50
1. Press down and slide off the lid of the battery compartment
(located on the bottom of the unit).
2. Connect the snap cord to the battery, and place it inside the
battery compartment.
* Verify the battery’s polarity (+ versus -).
3. Securely close the battery cover.
* Do not let the snap cord get caught in the battery compartment lid.
When to Change the Battery
The Battery LOW indicator ( ) at the lower left of the
display begins to flash when the battery power drops.
Insufficient battery power lowers the volume level of the mini speaker and causes unstable
operation. Replace the battery as soon as possible.
A BOSS PSA series AC adaptor (sold separately) can be used to power the RMP-3.
Turn off the power before connecting the AC adaptor.
Use only the BOSS PSA-series AC adaptor. Other adaptors may cause malfunction or damage
to the RMP-3 and must never be used.
The Battery LOW indicator ( ) flashes when the battery power drops while the AC
adaptor is used.
fig.Bolt
BEFORE playing the RMP-3, you must tune the head to your preferred
playing tension. The head is NOT tuned before shipping.
Always tighten the tuning bolts in the order shown in the figure.
* Failure to adjust the tension may result in damage to the head.
* Head tension may change with extended use. Make adjustments as needed.
5
4
2
1 3
Preparations
Loading the Battery
Connecting the AC Adaptor
Adjusting the Head Tension
Battery
Snap
9V
Battery
1
7
8
63
45
2
– 3 –
fig.Display.e
If the head has been damaged or no longer maintains correct tension, replace it.
To order replacement heads (RMP-3 Mesh Head), contact the retailer from whom you purchased
the unit or the nearest Roland Service Center.
The MH-8 Mesh Head is not compatible and cannot be used.
Replacing the Head
When replacing or tuning, use the included tuning key.
fig.HeadChange
1. Remove all tuning bolts.
Gradually loosen each one in order, turning them
counterclockwise.
* Do not lose the tuning bolts.
2. Open the case, and then remove the old head.
3. Place the new head in the case.
4. Securely close the case.
5. Attach all eight tuning bolts.
6. Adjust the tension of the head. Refer to “Adjusting the Head Tension.”
Pad Size
8 inches
Tempo
20–260
Beat
24 types
Rhythm Types
18 types
Metronome Sounds
5
Coach Mode
Functions: 5
Exercise Variations: 20
Connectors
PHONES/OUTPUT Jack: 1
(Stereo miniature phone type)
MIX IN Jack: 1 (Miniature phone type)
AC Adaptor Jack
Power Supply
DC 9 V:
Dry Battery 6F22/1604 (9 V) type
(carbon)
Dry Battery 6LR61/1604A (9 V) type
(alkaline)
AC Adaptor
Current Draw
55 mA
* Expected battery life under continuous use:
Carbon: 2 hours
Alkaline: 6 hours
These figures will vary depending on the
actual conditions of use.
Stand Screw Size
M8
Dimensions
263 (W) x 348 (D) x 78 (H) mm
10-3/8 (W) x 13-3/4 (D) x 3-1/8 (H)
inches
Weight
1.2 kg / 2 lbs 11 oz (including a battery)
Accessories
Dry Battery 6F22/1604 (9 V) type
(carbon)
Tuning Key
Owner’s Manual
Leaflet (“USING THE UNIT SAFELY”
and “IMPORTANT NOTES”)
Options
AC Adaptor: BOSS PSA series
Pad Stand: PDS-2
* In the interest of product improvement, the
specifications and/or appearance of this
unit are subject to change without prior
notice.
About the Display
Replacing the Head
Specifications
Beat
Battery LOW Indicator
Flashes when the battery
power drops.
Trigger Indicator
Appears when the
head is struck.
Count Tempo/Value
Rhythm Type
Metronome Needle

Product specificaties

Merk: Roland
Categorie: Niet gecategoriseerd
Model: RMP-3

Heb je hulp nodig?

Als je hulp nodig hebt met Roland RMP-3 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden


Handleiding Niet gecategoriseerd Roland

Roland

Roland RCP800 Handleiding

9 April 2024
Roland

Roland HP605 Handleiding

9 April 2024
Roland

Roland FD-01A Handleiding

9 April 2024
Roland

Roland MDS-4KVX Handleiding

9 April 2024
Roland

Roland CY-12C Handleiding

9 April 2024
Roland

Roland JUNO-60 Handleiding

9 April 2024
Roland

Roland TB-303 Handleiding

9 April 2024
Roland

Roland VP-42H Handleiding

9 April 2024
Roland

Roland PD-100 Handleiding

9 April 2024
Roland

Roland JX-3P Handleiding

9 April 2024

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd

Playtive

Playtive IAN 327221 Handleiding

1 Mei 2024
Samsung

Samsung UN32J4001AF Handleiding

1 Mei 2024
Bauknecht

Bauknecht KSI 18GF2 P2 Handleiding

27 April 2024
Fakir

Fakir Artemis TS 150 Handleiding

26 April 2024
Sony

Sony UTX-M03 Handleiding

26 April 2024
Sony

Sony URX-P03 Handleiding

26 April 2024
Sony

Sony WRU-806B Handleiding

26 April 2024
Sony

Sony UTX-B03 Handleiding

26 April 2024
Sony

Sony UTX-P03 Handleiding

26 April 2024
Sony

Sony ODS-L10 Handleiding

26 April 2024