Real Flame Optimyst CAS1000 Handleiding

Real Flame Heater Optimyst CAS1000

Lees hieronder de 📖 handleiding in het Nederlandse voor Real Flame Optimyst CAS1000 (16 pagina's) in de categorie Heater. Deze handleiding was nuttig voor 33 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/16
CAS1000
This product complies with all the required Product Safety, Electromagnetic Compatibility and Environmental Standards. This product is fully compliant with the
LVD, EMC, RoHS and Eco Design Directives.
08/53202/0 Issue 6
OCN 11671
CAS500
IMPORTANT NOTICE
AUSTRALIA: The CAS1000 & CAS500 may not be connected to mains water supply, the supplied
water bottles must be used.
NEW ZEALAND: The CAS1000 & CAS500 may be connected to mains water or may use the
supplied water bottles. Mains water connection must be undertaken by a qualiîš¿ed person, and
must be in compliance with relevant building codes and plumbing standards.
1
Real Flame CAS500, CAS1000
Important Safety Advice
Introduction
Please read this information guide carefully to be able to safely install, use and maintain your product.
When using electrical appliances, basic precautions should always be followed to reduce the
risk of îš¿re, electrical shock and injury to persons, including the following:
If the appliance is damaged, check with the supplier before installation and operation.
Do not use outdoors.
Do not use in the immediate surroundings of a bath, shower or swimming pool.
Do not locate the appliance immediately below a îš¿xed socket outlet or connection box.
This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance by a person responsible for
their safety.
Children should be supervised to ensure that they do not play with the appliance.
Children should be kept away unless continuously supervised.
Children shall only switch on/o󰀨 the appliance provided that it has been placed or installed
in its intended normal operating position and they have been given supervision or instruction
concerning use of the appliance in a safe way and understand the hazards involved. Children
shall not plug in, regulate and clean the appliance or perform user maintenance.
CAUTION: Some parts of this product can become very hot and cause burns. Particular
attention has to be given where children and vulnerable people are present.
Do not use this appliance in series with a thermal control, a program controller, a timer or any
other device that switches on the heat automatically, since a îš¿re risk exists when the heater is
accidentally covered or displaced.
Ensure that furniture, curtains or other combustible material are positioned no closer than 1
meter from the appliance.
In the event of a fault unplug the appliance.
Unplug the appliance when not required for long periods.
Although this appliance complies with safety standards, we do not recommend its use on deep
pile carpets or on long hair type of rugs.
The appliance must be positioned so that the plug is accessible.
If the supply cord is damaged it must be replaced by the manufacturer or service agent or a
similarly qualiîš¿ed person in order to avoid a hazard.
Keep the supply cord away from the front of the appliance.
WARNING: In order to avoid overheating, do not cover the appliance. Do not place material or
garments on the appliance, or obstruct the air circulation around the appliance.
The appliance carries a DO NOT COVER warning symbol.
This appliance is not equipped with a device to control the room temperature. Do not use this
appliance in small rooms when they are occupied by persons not capable of leaving the room
on their own, unless constant supervision is provided.
2
General Information
Only use îš¿ltered water in this appliance.
Unpack the appliance carefully and retain the packaging for possible future use, in the event of moving or returning the
îš¿re to your supplier.
Always ensure that the appliance is sitting on a level surface.
The appliance is a ame e󰀨ect only.
The appliance is designed to be built into a surround or built into a wall.
Before connecting the appliance, check that the supply voltage is the same as that stated on the appliance.
Please note: Used in an environment where background noise is very low, it may be possible to hear a sound which is
related to the operation of the ame e󰀨ect. This is normal and should not be a cause for concern.
Once installed, never move this appliance or lay on its back, without draining the water from sump and water tank.
The water tank, sump, sump lid, tank cap and air îš¿lters must be cleaned once every 2 weeks, particularly in hard water
areas.
If you intend not using the appliance for longer than 2 weeks, drain the water from sump and water tank and dry the
sump.
The sump and the water tank in this product are treated with a biocidal product, Silver Biocide. This conforms with the
latest relevant ISO standard
Do not drink the water from the sump or from the water tank(s)
This appliance is intended to be permanently connected to the water mains and not connected by a hose-set if not using
the water bottles provided
Installation Instructions
This section describes how to set up your îš¿re.
BEFORE YOU START
1. Ensure that all packing items are removed (read any warning labels carefully) and retain all packing for possible
future use.
2. Before connecting the appliance, check that the supply voltage is the same as that stated on the appliance.
3. Ensure that the appliance is sitting on a level surface
4. Lift o󰀨 the metal top plate to gain access to the appliance. Keep the top plate with the packing for possible future
use. (Fig.2)
Installation Guide
This product can be built into a wall, surround or structure. Please take note of the product dimensions (Fig.1) and build
your wall, surround or structure accordingly. You are required to leave a minimum of 400mm from the base of the fuelbed
to any shelf/enclosure above the product. This will allow enough space above the product to allow the ames to form
fully and not to be obstructed.
This product needs free ventilation from underneath to operate correctly. There are slots on the underside of the product
to allow this free air through the product (Fig.3). The free ventilation helps keep the electronic components cool, allow
the mist to evacuate the sump and lift out of the product e󰀨ortlessly.
THE AREA OF FREE VENTILATION THE CAS500 REQUIRES IS A MINIMUM OF 210CM 2.
THE AREA OF FREE VENTILATION THE CAS1000 REQUIRES IS A MINIMUM OF 420CM 2.
SEE Fig 4 AND Fig 5 FOR EXAMPLES OF THE REQUIRED VENTILLATION
Fig.1
MODEL DIM ‘A’
CAS500 508mm
CAS1000 1017mm


Product specificaties

Merk: Real Flame
Categorie: Heater
Model: Optimyst CAS1000

Heb je hulp nodig?

Als je hulp nodig hebt met Real Flame Optimyst CAS1000 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Heater Real Flame

Handleiding Heater

Nieuwste handleidingen voor Heater