QSC Axon DTH1620 Handleiding

QSC Niet gecategoriseerd Axon DTH1620

Lees hieronder de 📖 handleiding in het Nederlandse voor QSC Axon DTH1620 (19 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 19 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/19
TD-001622-01-A
*TD-001622-01*
Axon DTH1620
Themed Attraction
Amplifier
User Manual
Model:
Model:
Model:
Model: DTH1620
DTH1620
DTH1620
DTH1620Model: DTH1620
®
ii
TD-001622-01-A
EXPLANATION OF SYMBOLS
The term indicates instructions regarding personal safety. If the instructions are not followed the result may be bodily “WARNING!”
injury or death.
The term indicates instructions regarding possible damage to physical equipment. If these instructions are not followed, “CAUTION!”
it may result in damage to the equipment that may not be covered under the warranty.
The term “IMPORTANT!” indicates instructions or information that are vital to the successful completion of theprocedure.
The term is used to indicate additional useful information.“NOTE”
The intent of the lightning flash with arrowhead symbol in a triangle is to alert the user to the presence of un-insulated
«dangerous» voltage within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock
to humans.
The intent of the exclamation point within an equilateral triangle is to alert the user to the presence of important safety, and
operating and maintenance instructions in this manual.
IMPORTANT SAFETY INSTRUCTIONS
WARNING! TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR
MOISTURE.
Elevated Operating Ambient Temperature – If installed in a closed or multi-unit rack assembly, the ambient operating
temperature of the rack environment may be greater than room ambient. Consideration should be given to ensure that the
maximum operating temperature range -10°C to 50°C (14°F to 122°F ) is not exceeded. Reduced Air Flow – Installation
of the equipment in a rack should be such that the amount of air flow required for safe operation of the equipment is not
compromised.
1. Read these instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. Do not use this apparatus near water.
6. Clean only with a dry cloth.
7. Do not block any ventilation opening. Install in accordance with the manufacturer’s instructions.
8. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus that produce heat.
9. To reduce the risk of electrical shock, the power cord shall be connected to a mains socket outlet with a protective earthing
connection.
10. Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than the
other. A grounding type plug has two blades and a third grounding prong. The wide blade or the third prong are provided for your
safety. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet.
11. Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they
exit from theapparatus.
12. Only use attachments/accessories specified by the manufacturer.
13. Unplug this apparatus during lightning storms or when unused for long periods of time.
14. Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as
power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been
exposed to rain or moisture, does not operate normally, or has been dropped.
15. The appliance coupler, or the AC Mains plug, is the AC mains disconnect device and shall remain readily operable after installation.
16. Adhere to all applicable, local codes.
17. Consult a licensed, professional engineer when any doubt or questions arise regarding a physical equipment installation.
18. Do not use any aerosol spray, cleaner, disinfectant or fumigant on, near or into the apparatus. Clean only with a dry cloth.
19. Do not unplug the unit by pulling on the cord, use the plug.
20. Do not submerge the apparatus in water or liquids.
21. Keep ventilation opening free of dust or other matter.
iii
TD-001622-01-A
Maintenance and Repair
WARNING! Advanced technology, e.g., the use of modern materials and powerful electronics, requires specially adapted
maintenance and repair methods. To avoid a danger of subsequent damage to the apparatus, injuries to persons and/or
the creation of additional safety hazards, all maintenance or repair work on the apparatus should be performed only by a
QSC authorized service station or an authorized QSC International Distributor. QSC is not responsible for any injury, harm
or related damages arising from any failure of the customer, owner or user of the apparatus to facilitate those repairs. In
the event of malfunction, contact QSC Customer Support for assistance.
FCC Statement
NOTE:
NOTE:
NOTE:
NOTE:
NOTE:
This equipment has been tested and found to comply with the limits for a Class A or Class B digital device when ferrite
clamps are installed on the output cables, pursuant to Part 15 of the FCC Rules. To meet Class A or Class B emission requirements
two Ferrite 0431176451 clamps are required to be on the customer-supplied output cables connected to J1 and J5. Place the
ferrite clamps as close to connectors J1 and J5 as possible.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Environmental
Life cycle 10 years / Storage temperature -20 ° C to + 70 ° C / Relative humidity 5 - 85% RH
Service life - 10 years. Storage conditions: temperature from -20 ° C to + 70 ° C, humidity 5% - 85%.
If you wish to discard electronic equipment, please contact your dealer or supplier for further information.
RoHS Statement
The QSC DTH1620 Series Amplifier is in compliance with “China RoHS” directives. The following chart is provided for product use in
China and its territories:
QSC DTH1620 and DTH1620 Series Amplifiers
有毒有害物质或元素
有毒有害物质或元素
有毒有害物质或元素
有毒有害物质或元素有毒有害物质或元素
(Toxic or hazardous Substances and Elements)
部件名称
部件名称
部件名称
部件名称部件名称
(Part Name)
铅
(Pb)
汞
(Hg)
镉
(Cd)
六价铬
(Cr(vi))
多溴联苯
(PBB)
多溴二苯醚
(PBDE)
电路板组件
电路板组件
电路板组件
电路板组件电路板组件
(PCB Assemblies) X O O O O O
机壳装配件
机壳装配件
机壳装配件
机壳装配件机壳装配件
(Chassis Assemblies) X O O O O O
O: 表明这些有毒或有害物质在部件使用的同类材料中的含量是在 SJ/T11363_2006 极限的要求之下。
(O: Indicates that this toxic or hazardous substance contained in all of the homogeneous materials for this part is below the limit
requirement in SJ/T11363_2006.)
X: 表明这些有毒或有害物质在部件使用的同类材料中至少有一种含量是在 SJ/T11363_2006 极限的要求之上。
(X: Indicates that this toxic or hazardous substance contained in at least one of the homogeneous materials used for this part is
above the limit requirement in SJ/T11363_2006.)

Product specificaties

Merk: QSC
Categorie: Niet gecategoriseerd
Model: Axon DTH1620

Heb je hulp nodig?

Als je hulp nodig hebt met QSC Axon DTH1620 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden


Handleiding Niet gecategoriseerd QSC

QSC

QSC QIO-S4 Handleiding

27 Mei 2023
QSC

QSC Core 510i Handleiding

25 Mei 2023
QSC

QSC CXD4.3Q Handleiding

14 Mei 2023
QSC

QSC DPA-8K8Q Handleiding

13 Mei 2023
QSC

QSC Attero Tech unBT2A Handleiding

10 Mei 2023
QSC

QSC USL JSD-100 Handleiding

9 Mei 2023
QSC

QSC DPA 4.2 Handleiding

9 Mei 2023
QSC

QSC CX-Q 8K4 Handleiding

5 Mei 2023
QSC

QSC Q-SYS NV-32-H Handleiding

4 Mei 2023
QSC

QSC Core Nano Handleiding

15 April 2023

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd

Playtive

Playtive IAN 327221 Handleiding

1 Mei 2024
Samsung

Samsung UN32J4001AF Handleiding

1 Mei 2024
Bauknecht

Bauknecht KSI 18GF2 P2 Handleiding

27 April 2024
Fakir

Fakir Artemis TS 150 Handleiding

26 April 2024
Sony

Sony UTX-M03 Handleiding

26 April 2024
Sony

Sony URX-P03 Handleiding

26 April 2024
Sony

Sony WRU-806B Handleiding

26 April 2024
Sony

Sony UTX-B03 Handleiding

26 April 2024
Sony

Sony UTX-P03 Handleiding

26 April 2024
Sony

Sony ODS-L10 Handleiding

26 April 2024