Pyle PDWR69BTB Handleiding

Pyle Speaker PDWR69BTB

Lees hieronder de 📖 handleiding in het Nederlandse voor Pyle PDWR69BTB (3 pagina's) in de categorie Speaker. Deze handleiding was nuttig voor 35 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/3
www.PyleUSA.comwww.PyleUSA.com
Wall Mountable, 100 Watts MAX
with 2-Way Full Range Stereo
Sound Reproduction, Pair
PDWR69BTB - PDWR69BTW
6.5'' Pro Active Wireless BT
Streaming Speakers
Questions? Issues?
We are here to help!
Phone: (1) 718-535-1800
Email: support@pyleusa.com
Note:
Anytime you note distortion, reduce the volume to a lower setting. Never
allow your amplier to be driven into " ". Otherwise the speakers clipping
may be damaged. Damage caused by operating the speakers at distorted
volume levels is not covered by the warranty.
WIRELESS BT PAIRING
Ensure the speaker is connected to the power supply and turned on.
Any BT device (such as phones, tablets, laptops etc.) is available for pairing.
Note:
• There will be a prompt sound when BT is connected/disconnected.
• BT Input has the priority when BT input and RCA input are connected
simultaneously. To listen to RCA input audio, disconnect from BT before
using a RCA input device.
• One device can only connects or control one BT speaker at a time.
If device A connects and controls BT, device B cannot search or control the
BT speaker. Device A MUST no longer be connected, then device 8 can
connect and control.
• If pairing fails the rst time, restart all the equipment and then follow the
above instructions.
• If you are unable to reconnect a previously connected device, remove the
" " from the list of paired devices, and then follow the above PyleUSA
instructions again.
• The BT connection will be lost if the distance between the speaker and the
BT device exceeds 1Om (32.8 ft.).
PyleUSAPyleUSA
1. Open the setting
menu and select BT.
2. Turn on BT and
search devices.
3. Click "PyleUSA"to
pair with your device.
CARE AND MAINTENANCE
• Turn off the power to the speaker when unused for long periods of time.
• Ensure all equipment is turned off prior to cleaning. Surfaces and cabinet
need only occasional dusting/cleaning. Never use chemicals or solvents as
they may damage the surface. Always clean using a dry cloth.
• Never touch the speaker drivers.
Technical Specs:
• Power Supply: 100W (MAX Power)
• RMS Power: 50W (Passive Speaker)
• Speaker Size: Sound System: 6.5'' Subwoofers: 0.5'' Tweeter
• Subwoofer Type: 6.5'' Paper Cone
• Tweeter Type: 0.5'' Mylar Dome
• Frequency Response: 70-20 kHz (+/-3dB)
• Speaker Impedance: 8 Ohm
• Audio Sensitivity: 86dB
• Construction Material: Polypropylene
• Power Cable Length: 3.94 ft.
• Power Output: 100-240V
• Single Speaker Dimensions (L x W x H): 8.5'' x 7.6'' x 11.7'' -inches
www.PyleUSA.com www.PyleUSA.com
SAFETY INSTRUCTIONS
• Please read the instructions carefully before installation and use.
Keep the manual safe for future reference.
• Prior to installing the speakers into any wall, check the structure for weight
bearing ability and avoid contact with any wiring or plumbing that might
be behind the surface area. Installing on soft materials or in areas incapable
of supporting the speakers' weight may cause personal injury or damage
to the speaker.
• Make sure the speaker is properly secured to the wall. Please use the proper
screws, bolts, or anchors. Failure to do so may cause the speaker to became
unsecured and cause potential damages/injuries.
• When installing the speakers outside, choose areas such as the underside of
eaves to avoid strong direct sunlight that may affect the color and life of
the speaker enclosure.
• Use only approved and certied wiring in your installation.
Do not stretch or place the wire in contact with sharp objects.
• Prior to removing cables, ensure all power to your amplier and other
components is turned off.
• Damage to the woofer and tweeter may occur if the speaker is dropped or
hit-resulting in no sound or distorted sound.
• Never overdrive your speakers to the point of distortion and always reduce
volume prior to switching input sources.
PREPARATION
The hardware equipment listed below is needed to install the speaker.
PACKING LIST
Ensure that you have received all parts according to the component checklist
prior to installation. If any parts are missing or faulty, contact your place of
purchase for a replacement.
www.PyleUSA.com
SPEAKER OVERVIEW 1. Aux Input
2. Loop: A signal output for connecting to the other active speaker or amplier.
3. Bass output for connecting to subwoofer.SUB:
4. 2-Pin terminal block for connecting to the passive Speaker Output:
speaker.
5. LED Indicator
6. RCA Input
7. 5-Pin European-Style Terminal Block: Connects to a balanced stereo
audio input.
8. Treble: Increase or decrease the high frequency response. The O position
produces a at response. Control range: -12 dB to +12 dB.
9. Increase or decrease the low frequency response. The 0 position Bass:
produces a at response. Control range: -12 dB to +12 dB
10. Volume Control
11. USB Input
12. Replay
13. Switches audio sources.Mode:
14. (Short Press)Previous
Rewind (Press and hold)
15. (Short Press) Next
Forward (Press and hold)
16. Play/Pause (Short Press)
TWS Pairing (Press and hold)
17. Power Switch: When this switch is on Auto position, the amplier will
automatically turn on when a signal is present and it will go standby
when there is no signal input in about 15 seconds.
18. AC Power Input
CONNECTION
• Ensure that the speaker is unplugged from the mains before making any
connections.
• Connect active and passive speakers as shown. Always check to ensure
polarity is correct: "+ +" to " ", and " " to "- -".


Product specificaties

Merk: Pyle
Categorie: Speaker
Model: PDWR69BTB

Heb je hulp nodig?

Als je hulp nodig hebt met Pyle PDWR69BTB stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Speaker Pyle

Pyle

Pyle PDWR445TB Handleiding

24 Februari 2024
Pyle

Pyle PPHP129WMU Handleiding

24 Februari 2024
Pyle

Pyle PITS18 Handleiding

24 Februari 2024
Pyle

Pyle PDWR545TW Handleiding

24 Februari 2024
Pyle

Pyle PDWR445TW Handleiding

24 Februari 2024
Pyle

Pyle PAHT8 Handleiding

24 Februari 2024
Pyle

Pyle PLBKA60BK Handleiding

24 Februari 2024
Pyle

Pyle PLMCA31BT Handleiding

24 Februari 2024
Pyle

Pyle PDWR545TB Handleiding

24 Februari 2024
Pyle

Pyle PRETRAMP50 Handleiding

18 Augustus 2023

Handleiding Speaker

Nieuwste handleidingen voor Speaker