Pioneer DEH-P4100R Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor Pioneer DEH-P4100R (52 pagina's) in de categorie Autoradio/CD speler. Deze handleiding was nuttig voor 27 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/52
MANUEL D’INSTALLATION
DEH-P4100R
INSTALLATION MANUAL
ENGLISH ESPAÑOL DEUTSCH FRANÇAIS ITALIANO NEDERLANDS
This product conforms to new cord colors.
Los colores de los cables de este producto se confor-
man con un nuevo cĂłdigo de colores.
Dieses Gerät entspricht den neuen kabelfarben.
Le code de couleur des câbles utilisÊ pour ce produit est
nouveau.
Questo prodotto è conforme ai nuovi codici colori.
De kleuren van de snoeren van dit toestel zijn gewijzigd.
1
Contents
Connecting the Units ................................ 1
Installation .................................................. 7
Installation with the rubber bush ...................... 7
Removing the Unit ............................................ 8
Note:
• This unit is for vehicles with a 12-volt battery and
negative grounding. Before installing it in a recre-
ational vehicle, truck or bus, check the battery
voltage.
• To avoid shorts in the electrical system, be sure to
disconnect the battery cable before beginning≠
installation.
• Refer to the owner’s manual for details on con-
necting the power amp and other units, then make
connections correctly.
• Secure the wiring with cable clamps or adhesive
tape. To protect the wiring, wrap adhesive tape
around them where they lie against metal parts.
• Route and secure all wiring so it cannot touch any
moving parts, such as the gear shift, handbrake
and seat rails. Do not route wiring in places that
get hot, such as near the heater outlet. If the insu-
lation of the wiring melts or gets torn, there is a
danger of the wiring short-circuiting to the vehicle
body.
• Don’t pass the yellow lead through a hole into the
engine compartment to connect to the battery.
This will damage the lead insulation and cause a
very dangerous short.
• Do not shorten any leads. If you do, the protection
circuit may fail to work when it should.
• Never feed power to other equipment by cutting
the insulation of the power supply lead of the unit
and tapping into the lead. The current capacity of
the lead will be exceeded, causing overheating.
• When replacing fuse, be sure to use only fuse of
the rating prescribed on this unit.
• Since a unique BPTL circuit is employed, never
wire so the speaker leads are directly grounded or
the left and right speaker leads are common.≠
• The black lead is ground. Please ground this lead
separately from the ground of high-current prod-
ucts such as power amps.
If you ground the products together and the
ground becomes detached, there is a risk of dam-
age to the products or re.
Connecting the Units
• Speakers connected to this unit must be high-
power types with minimum rating of 45 W and
impedance of 4 to 8 ohms. Connecting speakers
with output and/or impedance values other than
those noted here may result in the speakers catch-
ing re, emitting smoke, or becoming damaged.
• When this product’s source is switched ON, a
control signal is output through the blue/white
lead. Connect to an external power amp’s system
remote control or the car’s Auto-antenna relay
control terminal. (Max. 300 mA 12 V DC.) If the
car features a glass antenna, connect to the anten-
na booster power supply terminal.
• When an external power amp is being used with
this system, be sure not to connect the blue/white
lead to the amp’s power terminal. Likewise, do
not connect the blue/white lead to the power ter-
minal of the auto-antenna. Such connection could
cause excessive current drain and malfunction.
• To avoid short-circuiting, cover the disconnected
lead with insulating tape. Especially, insulate the
unused speaker leads without fail. There is a pos-
sibility of short-circuiting if the leads are not insu-
lated.
• To prevent incorrect connection, the input side of
the IP-BUS connector is blue, and the output side
is black. Connect the connectors of the same col-
ors correctly.
• If this unit is installed in a vehicle that does not
have an ACC (accessory) position on the ignition
switch, the red lead of the unit should be connect-
ed to a terminal coupled with ignition switch
ON/OFF operations. If this is not done, the vehi-
cle battery may be drained when you are away
from the vehicle for several hours. (Fig. 1)
Fig. 1
• Cords for this product and those for other prod-
ucts may be different colors even if they have the
same function. When connecting this product to
another product, refer to the supplied Installation
manuals of both products and connect cords that
have the same function.
No ACC positionACC position
O
N
S
T
A
R
T
O
F
F
A
C
C
O
N
S
T
A
R
T
O
F
F
2
ENGLISH ESPAÑOL DEUTSCH FRANÇAIS ITALIANO NEDERLANDS


Product specificaties

Merk: Pioneer
Categorie: Autoradio/CD speler
Model: DEH-P4100R

Heb je hulp nodig?

Als je hulp nodig hebt met Pioneer DEH-P4100R stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Autoradio/CD speler Pioneer

Handleiding Autoradio/CD speler

Nieuwste handleidingen voor Autoradio/CD speler

Belson

Belson BS12100 Handleiding

31 Augustus 2023
Mx Onda

Mx Onda MX1500 Handleiding

6 Augustus 2023
Belson

Belson BS12150 Handleiding

31 Augustus 2023
Belson

Belson BS11900 Handleiding

31 Augustus 2023
Belson

Belson BS11520 Handleiding

31 Augustus 2023
Mx Onda

Mx Onda HUESCA Handleiding

6 Augustus 2023
DLS

DLS RA 10 Handleiding

22 Augustus 2023
Mx Onda

Mx Onda BAEZA Handleiding

6 Augustus 2023
Mx Onda

Mx Onda T825M Handleiding

6 Augustus 2023