Panduit FST24S Handleiding

Bekijk gratis de handleiding van Panduit FST24S (2 pagina’s), behorend tot de categorie Niet gecategoriseerd. Deze gids werd als nuttig beoordeeld door 6 mensen en kreeg gemiddeld 4.7 sterren uit 9 reviews. Heb je een vraag over Panduit FST24S of wil je andere gebruikers van dit product iets vragen? Stel een vraag

For Technical Support: www.panduit.com/resources/install_maintain.asp

INSTALLATION INSTRUCTIONS

© Panduit Corp. 2014

FS104

Page 1 of 2

24-Fiber Splice Tray

Part Number: FST24S

The FST24S splice tray holds up to 24 fusion or 24 mechanical splices for multimode or singlemode fibers.

2.0PRECAUTIONS

2.1Fiber optic cable is sensitive to excessive pulling, bending and crushing forces. Consult the manufacturer’s

cable specification sheet for the specific cable in use.

2.2DANGER: UNMATED CONNECTORS OR FIBERS MAY EMIT INVISIBLE LASER RADIATION. DO NOT

LOOK DIRECTLY INTO THE END OF THE CONNECTORS OR FIBER, DO NOT INSPECT WITH

MAGNIFYING DEVICES. MAINTAIN CAP ON UNMATED CONNECTORS.

2.3Consult cable manufacturer’s instructions for proper sheath removal method for the cable in use.Consult splice

manufacturer’s instructions for recommended precautions.

3.0INSTALLING SPLICE TRAY AND FIBER

3.1Install the splice holders, fusion or mechanical to base of FST24S splice tray.

3.2Routing Fiber - Follow instructions for cable in use when removing cable sheath. Strip outer sheath to expose

enough fiber for the application. The length will vary depending on the enclosure. Figure 2 shows the

recommended fiber routing for the FST24S.

3.3Prior to splicing fibers install splice tray in stacking unit and loop the fiber into the position it will occupy after

splicing to determine required slack length. Bring the fibers to the center of splice holders. Add 1.0" to this

length and trim excess.

3.4Securing Fiber In Splice Tray - Select crimping tab to be used for securing loose tube buffer. When multiple

buffer tubes are used select inner tabs first. Crimp loose buffer tubes using crimping pliers. Buffer tubes should

extend 1/2" beyond tab into tray. (Figure 3A)

3.5Tight buffered fibers can be secured with cable ties threaded through cable tie slots located on splice tray

base. If cable jacket cannot be routed up to splice tray use PVC tubing to protect buffered fibers. (Figure 3A)

3.6See Figure 3B for ribbon fiber splicing.

Splice Holder

(Qty. 4)

Spiral Wrap

Clear Cover

(Qty. 1)

Splice Tray

1.0COMPONENT IDENTIFICATION

Product specificaties