Nedis TVWM5850BK Handleiding

Nedis Tv-meubel TVWM5850BK

Lees hieronder de 📖 handleiding in het Nederlandse voor Nedis TVWM5850BK (2 pagina's) in de categorie Tv-meubel. Deze handleiding was nuttig voor 36 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/2

Motorized Mantel TV Wall Mount

INSTALLATION MANUAL

200x100/200x200

300x200/300x300

400x200/400x300

400x400/600x400

TVWM5850BK

35kg

(77lbs)

RATED

70"

MAX

Disposal:

The product with this mark indicates that this product shouldn't be disposed with other household wastes throughout

the EU. To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it

responsibly to promote the sustainable reuse of material resources. To return your used device, please use the local

recycle service or contact your point of purchase to withdraw the product.

·This appliance can be used by children aged from 8 years and above if they have been given supervision or instruction concerning

use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and

user maintenance shall not be made by children without supervision.

·Persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge must not use the appliance,

unless they're under supervision, understand the hazards involved or they have been thoroughly instructed in the use of the

apparatus by a person who is responsible for the safety of these persons.

·Don't leave the cords or plug unorganized in order to prevent tripping hazards.

·Any attempts to reconstruct the construction aren't allowed.

The product is powered by electricity. In order to avoid burns, fire and electric shock and make sure the safe and correct

use of the system and maintain the longevity of the overall construction and the built-in electronics, please read the

instructions carefully.

Warnings

Electrical Safety Instructions

·The appliance is only to be used with the power supply unit provided with the appliance. Alterations of the given power unit aren't allowed.

·Never operate the system with a damaged power supply cord or plug. If any part is damaged, please contact your service agent of

 purchase for a replacement.

·Never operate the system if it's in moist environment or its electrical components has contact with liquids.

·Don't clean the product while the power is still connected.

·Don't disassemble or replace components while the power is still connected.

·Unplug the appliance when the system isn't in use, and place the power plug out of children reach.

Remote Control Operation Instructions

1.Upward/Downward Movement

Press and hold the " " button to lift the mount. Press and hold the " " button to lower the mount.

(Tips: Clear up all obstacles within the range of motion.)

2.Memory Setting

Long press the “ ” or “ ” button for 2 seconds until you hear a beep, indicating that the current position   

has been saved to memory. The “ ” “ ” buttons can each store a different position.  

Press the “ ” or “ ” button and the mount will automatically get to the position saved in the corresponding  

button “ ” or “ ”. Press any button to stop motion.

3.Recall Memory

Short press the “ ” button and the mount will automatically retract to the highest position. Press any button to   

stop motion.

4.Default Setting

Disconnect the power supply cord. Wait for 10 seconds and reconnect. Long press the “ ” button for   

5 seconds until you hear a long beep. The mount starts to move upward to the highest position and the control 

box emits a beep. Then moves downward to the lowest position and the control box emits twice beeps.

5. Reset Mode

Note:The remote control is powered by two AAA batteries (not included).

B. Coding of Remote Control and Control Box

A. Button Functions

STEP1: When the mount is powered on, press the small button on the control box with a thin     

   tool as shown. The unit emits a beep, indicating that the control box is on standby for

program coding.

STEP2:   Press the “ ”button on the remote control, and the control box repeatedly beeps for

approximate10 seconds indicating that the remote control is being programmed. The

process will be finished automatically until you can't hear a beep any longer.

 Note: Clear up the historical data when replacing a new remote control to pair. Press the small

button on the control box with hearing a beep, and hold for 10 seconds to confirm the

data-cleaning process is completed until you hear two beeps.

TROUBLESHOOTING

If a problem arises, please try the troubleshooting guidelines below. If the problem is not listed,

please contact your local distributor for additional technical assistance.

Q: The motorized TV mount does not respond to remote control.

A: Possible reasons caused by TV mount or remote control

·The system may be overheating. Check if the unit beeps two times after pressing the button. If so, allow the unit to cool down and return

to room temperature (about 12 minutes).

·The AC/DC end of the power cord may be unplugged/disconnect from the outlet/mount. Check the connection to the outlet/mount to

ensure the unit has power.

-TV Mount-

-Remote Control-

·The remote control operating distance may be too far and not in range of the mount. Acceptable range should be less than 10m (30 feet).

·The batteries in the remote control may be low or dead. Replace the batteries.

·The remote control may be broken. Check to see if the indicator LED found on the remote lights when a button is pressed. If not, contact

your place of purchase for a replacement.

Q: The TV mount stops moving during operation and emits a long beep.

A: ·Check to see if a foreign object is impeding the mount from moving. If so, remove the object and discard.

·The weight of TV may exceed the maximum weight limitation of the mounting system. 

·The motor wire may be broken. Reset the system. If the problem still exists, contact your place of purchase for replacement.

Q: The TV mount is making an abnormal noise or sound.

A: Check all power connections and reset the system. If the unit continues to make an abnormal noise, please contact your place of

purchase for a replacement.

+3° -3°

±25°

Nedis BV

De Tweeling 28, 5215 MC ’s-Hertogenbosch

The Netherlalands 0 /213

Take Wall Placement Measurement

ø 10mm

(ø 3/8")

60mm

(

2.4"

.4"

.4")

)

60mm

(2.4")

W-B (x6) W-C (x6)W-A (x6)

M8x30 (x4)

M-D

M6x30 (x4)

M-C

M6x14 (x4)

M-B

M5x14 (x4)

M-A

M8x50 (x4)

M-E M-F (x4) M-G (x8) M-H (x8)

A (x1) B (x2) D (x1)

F (x1) G (x1)E (x2)

C (x1)

I (x1)H (x1)

ø 4.5mm

(ø 3/16")

55mm

(

2.2"

.2"

.2")

)

55mm

(2.2")

M-C

M-D

M-F

≤100mm

≤200mm

≤300mm

≤ ≥350mm 300mm

≥200mm

≥250mm

≥80mm

a. If Mantel Extends: b. Mounting Height

Required:

W-C

W-A

W-C

W-A

M-B

M-F

M-A

M-F

W-B

a. Mantel Extends

b. Mounting Height

M-G

M-H

M-E

M-F

M-G

M-H

Once drop down the mount,

please remove the

silicone pad,

or the mount

can’t fully retract.

Don'

n't pu

t pu

t put han

t han

t hands i

ds i

ds in th

n th

n the mo

e mo

e moun

unt to

t to

even

ent ser

t ser

t serio

ious b

us b

us bod

odil

ily inj

y inj

y injur

ury

Don't put hands in the mount to

prevent serious bodily injury.

A2 A1

X X

√

X X

√

Product specificaties

Merk:	Nedis
Categorie:	Tv-meubel
Model:	TVWM5850BK
Kleur van het product:	Zwart
Gewicht:	11100 g
Breedte:	650 mm
Diepte:	485 mm
Hoogte:	559 mm
Gebruikershandleiding:	Ja
Materiaal behuizing:	Acrylonitrile butadiene styrene (ABS), Steel
In hoogte verstelbaar:	Ja
Montagewijze:	Muur
Stroomverbruik (in standby):	0.2 W
Maximale gewichtscapaciteit:	39 kg
Paneelmontage-interface:	200 x 100,200 x 200,300 x 200,300 x 300,400 x 200,400 x 400,400 x 300,600 x 400 mm
Aantal per verpakking:	1 stuk(s)
Draaihoek:	25 °
Montage:	Schroeven
Gemakkelijk te installeren:	Ja
Montage interface compatibiliteit (min):	200 x 100 mm
Montage interface compatibiliteit (max):	600 x 400 mm
Aantal displays ondersteund:	1
Verbeterd kabelbeheer:	Ja
Afstandsbediening inbegrepen:	Ja
Stroomverbruik (typisch):	52.2 W
Bereik kantelhoek:	-3 - 3 °
Maximale schermgrootte:	70 "
Code geharmoniseerd systeem (HS):	85299097
Minimale schermgrootte:	37 "
Hoogte verstelbaarheidsbereik:	0 - 540 mm
kantel aanpassingen:	Ja
Minimale afstand tot vloer:	153 mm
Maximale afstand tot vloer:	485 mm