Mtx Audio TH800D Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor Mtx Audio TH800D (44 pagina's) in de categorie Autoradio. Deze handleiding was nuttig voor 11 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/44
TH800D
Mono Block Class-D Power Amplier
800W
RMS
Designed by MTX in Phoenix, USA
www.mtx.eu.com
www.mtx.com
www.mtx.com - www.mtx.eu.com
Introduction
Thank you for purchasing an MTX Audio Hi-Performance amplier. Proper installation matched with MTX speak-
ers and subwoofers provide superior sound and performance for endless hours of waking the neighbors, slam-
min' your friends or at out stomping wanna-be players. Congrats and enjoy the ultimate audio experience with
MTX !
Specications :
• Mono block class-D amplier
• CEA2006 certied Power Output :
- 800 watts RMS x 1-channel at 2 ohm and THD+N ≤1%
- 400 watts RMS x 1-channel at 4 ohm and THD+N ≤1%
• Crossover :
- Low pass 24dB/oct variable from 40Hz to 200Hz
- Subsonic lter 24dB/oct variable from 20Hz to 50Hz
• Signal-to-Noise Ratio (1 watt) : > 78dB
• THD+Noise (Distortion) (1 watt) : ≤ 0,5%
• Frequency Response (±0,5dB) : 20Hz-200Hz
• Maximum Input Signal : 6V
• Maximum Sensitivity : 100mV
• Dimensions : 383mm x 213mm x 52,5mm
• Phase switch 0° or 180°
• High level inputs with Smart Engage Technology
• EBC remote control
Features :
• XTC - (Xtant Technology Cooling) - A regulated thermal intercooler, injecting cool air through internal heat
sinks. Fan speed is load dependent and continuously variable, sampling the temperature of the heat sink and
transformers for maximum reliability. Intercooler exhaust is strategically placed to chill transformers and main-
tain exceptional performance at any volume level. (Cool eh ? An Amp with an Intercooler ! )
• Adaptive Class-D Technology - Patent N°: US06753729 - Moves the switching energy produced by the amp
away from FM radio frequency's as the load and output increases. This ensures harmonics do not interfere with
radio reception and are not picked up by the audio system's ground. This improves the amplier's overall signal-
to-noise ratio and eliminates interference generated by common Class-D ampliers. Yes, we have the best en-
gineers !
• EAF Technology (Ecient Auto Former) - Patent N°: US05598325 - Our Transformers are "Auto Formers"
which allows us to use smaller magnetics (-30% to -50%) yielding increased eciency. Turn ratios are improved
due to series connections between the primary and secondary taps meaning MORE Power !
• Smart Engage™ Technology - Patent N°: US06556683 - The amp switches on and o automatically when
connected with high level inputs. No need for a remote turn on wire from under the dashboard. No need to
remove the head unit. Thanks MTX !
• Bi-Level Inputs - High level inputs (Speaker cables) and line level inputs (RCA) utilize the same RCA type input
connections on the amp.
• 10mm2 Speaker Connectors - Two sets of speaker terminals are provided for dual woofer or dual voice coil
applications. The two (+) connectors are paralleled internally. Same for the two (-) connectors.
• 50mm2 Power Connectors - For maximum voltage and current transfer, MTX mono blocks are equipped with
MASSIVE 50mm2 power connectors. It takes BIG power to make BIG power!
• EBC - (External Bass Control) - A 6m remote sub control allowing you to ne tune bass levels every 2 seconds
from the driver seat with no need to scroll through complex head unit menus. Cool !
Owner’s Manual - TH800D
Control Panel :
Gain Control - The gain control matches the input sensitivity of the amplier to the source unit being used. The
operating range varies from 100mv to 6V.
Adjusting the gain
1. Turn the gain control on the amplier all the way down (counter clockwise).
2. Turn up the volume control on the source unit to approximately 3⁄4 of maximum.
3. Adjust the gain control on the amplier until audible distortion occurs.
4. Adjust the gain control down until audible distortion disappears.
5. The amplier is now calibrated to the output of the source unit.
Warning : Never adjust the gain control without a subwoofer connected.
This will damage the amp...
Low Pass X-Over Frequency Control - Used to select the desired LP x-over frequency. The frequency is adjustable
from 40Hz to 200Hz.
Subsonic Frequency Control - Used to select the desired subsonic frequency (high pass). The frequency can be
adjusted from 20Hz to 50Hz. The subsonic lter protects subwoofer(s) against low frequencies that can cause
damage. Very useful with vented enclosures.
Phase switch - Used to match the bass from subwoofers and front speakers. Toggle the phase switch from 0° to
180°. Keep the loudest bass response. Also useful in bridge mode.
Power On LED - The LED illuminates red when the amp is switched on. For Short or Thermal protection, see
points 9 and 10
Control Panel (Top)
Connectors Panel (Side)


Product specificaties

Merk: Mtx Audio
Categorie: Autoradio
Model: TH800D

Heb je hulp nodig?

Als je hulp nodig hebt met Mtx Audio TH800D stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Autoradio Mtx Audio

Handleiding Autoradio

Nieuwste handleidingen voor Autoradio