Monogram ZX2130SLSS Handleiding

Bekijk gratis de handleiding van Monogram ZX2130SLSS (8 pagina’s), behorend tot de categorie Magnetron. Deze gids werd als nuttig beoordeeld door 90 mensen en kreeg gemiddeld 4.2 sterren uit 6 reviews. Heb je een vraag over Monogram ZX2130SLSS of wil je andere gebruikers van dit product iets vragen? Stel een vraag

PartQuantity

Trim Frame1

Screw Covers4

Base Pan1

Upper Bracket1

Rail2

Bottom

Bracket

2

Phillips Round-

Head Screws

24

(19 required

for installation)

Phillips Round-

Head Flat-

tipped Screws

6

(4 required for

installation)

PARTS INCLUDED

Questions? Call GE Answer Center at 800.626.2000 orVisit our Website at:

www.GEAppliances.com

READ CAREFULLY.

KEEP THESE INSTRUCTIONS

.

Installation Built-In Trim Kits

Instructions

BEFORE YOU BEGIN

Read these instructions completely and carefully.

•

IMPORTANT –Save these

instructions for local inspector’s use.

•

IMPORTANT –Observe all

governing codes and ordinances.

• Be sure to leave these Note to Installer –

instructions with the Consumer.

• Keep these instructions Note to Consumer –

for future reference.

• For easier installation and personal safety, we

recommend that two people install this microwave oven.

• Unplug the microwave oven before attempting

installation of this kit.

• Skill level– Installation of this appliance requires

basic mechanical and electrical skills.

• Completion time– 1-3 hours

• Proper installation is the responsibility of the installer.

• Product failure due to improper installation is not

covered under the Warranty.

• This kit and microwave are approved for installation

alone or above any single electric wall oven. Do not

mount adjacent (within 2 feet) to any range, cooktop,

gas oven, or other microwave.

TOOLS YOU WILL NEED

#2 Phillips

screwdriver

Pencil

Tape measure

Level

Small flathead

screwdriver

Drill with

7

»64” bit or #35

1

FOR YOUR SAFETY

WARNING

Before beginning the installation,

switch power off at service panel and lock the

service disconnecting means to prevent power from

being switched on accidentally. When the service

disconnecting means cannot be locked, securely

fasten a prominent warning device, such as a tag, to

the service panel.

WARNING

This oven must be plugged into a

properly grounded 3-hole, 120 volt receptacle as

required by the National Electric Code.

MODELS

30” Profile Kit: JX7230DLWW, JX7230DLBB,

JX7230ELES, JX7230SLSS, JX7230BLTS

27” Profile Kit: JX7227DLWW, JX7227DLBB,

JX7227ELES, JX7227SLSS, JX7227BLTS

Monogram Kit: ZX2130SLSS, ZX2127SLSS

Product specificaties