Monogram ZISS420DHSS Handleiding
Pagina's 4 Koelkast
Bekijk de handleiding van Monogram ZISS420DHSS gratis online of download de PDF. Deze handleiding is 1 keer bekeken. Vraag over dit model? Stel een vraag
OVERALL DIMENSIONS
Product Specification Created 6/14
ZISS420DHSSGE Monogram
®
42" Built-In Side-by-Side Refrigerator
25 3/4"(65.4)
23 7/8" (60.7)
2"
(5.1)
*3 3/4"
(9.5)
42" (106.7)
*84"
(213.4)
*72 1/4"
(183.5)
13 1/2"
(34.3)
*40"
(101.6)
64 1/4"
(163.2)
*4 1/4"
(10.8)
*83 1/2"
(212.1)
SIDE VIEWFRONT VIEW
* Shipping height. Use leveling legs and wheels for maximum
1" height adjustment from shipping height.
41" (104.2)
Case width
26 5/8"
(67.6)
TOP VIEW
** Allow (10.2) min4"
clearance to a wall for 90˚
door swing
** Allow (10.2) min4"
clearance to a wall for 90˚
door swing
** These refrigerators are equipped with a 2-position door stop. The factory-set 130° door
swing can be adjusted to 90° if clearances to adjacent cabinets or walls is restricted. Allow
full 130° door swings for pan removal. If the 90° door stop position is used, pan access is
maintained, but pan removal is restricted.
** Allow (33.0) min13"
clearance for 130˚
door swing
** Allow (48.3) min19"
clearance for 130˚
door swing
ATTENTION ELECTRICIAN:
A 115 volt 60Hz., 15 or 20 amp power supply
is required. An inidividual properly grounded
branch circuit or circuit breaker is recommended.
Install a properly grounded 3-prong electrical
receptacle recessed into the back wall.
SPECIFICATIONS
Overall Width42" (91.44 cm)
Overall Height84" (213.36 cm)
Overall Depth25 3/4" (65.41 cm)
Door Clearance26 5/8" (67.6 cm)
Cutout Width41 1/2" (105.4 cm)
Cutout Height83 1/2" - 84 1/2"
(212.1 - 214.6 cm)
Cutout Depth24" (61 cm)
Plumbing Requirements1/4" OD copper
tubing or GE
SmartConnect kit
Shipping Weight725 lb
Dimensions in parentheses are in centimeters unless otherwise noted.
Actual product dimension may vary due to manufacturing tolerances.
STANDARD INSTALLATION
ANTI-TIP BRACKET
FRONT VIEWSIDE VIEW
W
24"(61.0)
2"
(5.1)
4"
(10.7)
7/16"
(1.1)
Trim overlap
3 1/2"
(8.9)
E
WATER
41 1/2"(105.4)
18"(45.7)
*83 1/2" min
*84 1/2" max
(212.1-214.6)
*Trim will overlap
additional 7/16"
3 1/2"
(8.9)
75"
(190.5 )
From floor
to bottom
of electrical
area
6"
(15.2)
5"
(12.7)
5"
(12.7)
5"
(12.7)
SIDE VIEW INSTALLED
WITH WOODEN WALL STUDS
AND NO SOFFIT
SIDE VIEW INSTALLED
UNDER SOFFIT
SOFFIT
*84"
(213.4)
*Or installation
height from floor
2" x 4"
Cut to 35" Length
Screws mounted
into vertical wall
studs
FRONT VIEW INSTALLED
WITH METAL WALL STUDS
AND NO SOFFIT
Top Case Trim
3/4"
Min.
Side View Top
Case Trim
Install Screws
Through Trim and Into
3/4" Min. Wood Brace
A
B
D
C
GE Monogram
®
42" Built-In Side-by-Side Refrigerator
The refrigerator will project forward,
slightly beyond adjacent cabinetry.
A
Mounting the junction
box in this location will
also allow for front
accessability through
access panel.
B
Water supply area.
WARNING:
The refrigerator is top
heavy and must be secured
to prevent the possibility of
tipping forward. Failure to
do so may result in death
or serious injury.
The information below is
for cabinet design only.
When installing the anti-
tip system you must use
the product installation
instructions.
Determine your installation
construction and required
anti-tip configuration:
C
Installed Under Soffit
After installing unit into
installation opening,
raise grille panel and
screw metal case sides to
adjacent cabinet. When
installed under a soffit,
the soffit cannot exeed 24”
deep. The top case trim
overlaps the bottom of the
soffit.
D
Wooden Wall Studs and
No Soffit
• Cut a 2” x 4” block and
secure to brackets
provided.
• Secure brackets to back
wall of opening at 84” or
your installation height
from the floor.
E
Metal Wall Studs and
No Soffit
This method requires
securely fastened cabinets
on both sides and a ¾”
minimum wood brace
above unit, with it’s front
surface 24” from back wall.
• After installing unit into
opening, raise grille panel
and attach metal case
top trim to ¾” minimum
wood brace.
• The brace spanning
the enclosure must be
securely fastened to
cabinets on both sides.
See Installation
Instructions for detailed
instructions.
NOTES
E
Product Specification Created 6/14
ZISS420DHSS
NOTES
GE Monogram
®
42" Built-In Side-by-Side Refrigerator
F
Side panels must be
used whenever the sides
of the refrigerator will
be exposed. The 1/4”
side panels will slip
into the side case trim.
Secure the panels to
the refrigerator with
stick-on hook and loop
fastener strips. Order
the side panels from the
cabinet manufacturer.
CUSTOM SIDE PANELS
F
2 9/16"
(6.5)
*3" - 4"
(7.6 - 10.2)
*Depending
on installation
height
1 7/8"
(4.8)
24" (61.0)
3/16"
(.5)
*”
(2)
*Deing
on ination
*84"
(213.4)
*Depending
on installation
height
Product Specification Created 6/14
ZISS420DHSS
Product specificaties
| Merk: | Monogram |
| Categorie: | Koelkast |
| Model: | ZISS420DHSS |
Heb je hulp nodig?
Als je hulp nodig hebt met Monogram ZISS420DHSS stel dan hieronder een vraag en andere gebruikers zullen je antwoorden