Monogram ZICS360NMRH Handleiding
Pagina's 20 Koelkast
Bekijk de handleiding van Monogram ZICS360NMRH gratis online of download de PDF. Deze handleiding is 0 keer bekeken. Vraag over dit model? Stel een vraag
ZIC360N RH, ZIC360N LH,
ZICS360N RH, ZICS360N LH
Built-In Bottom-Freezer
Refrigerators
Design Guide
With Installation Instructions
Monogram.
®
If you have questions
,
call 800.626.2000 or visit our website at:
www.monogram.com
Installation
Instructions
Safety Information
Skill Level
—
Installation of this refrigerator
requires basic mechanical, carpentry and plumbing
skills. Proper installation is the responsibility of the
installer. Product failure due to improper installation
is not covered under the GE Appliance Warranty.
See the Owner’s Manual for warranty information.
WARNING:
• These refrigerators are top-heavy and must
be secured to prevent the possibility of tipping
forward. Anti-Tip protection is required. See page
11 for details.
• Use this appliance only for its intended purpose.
• Immediately repair or replace electric service cords
that become frayed or damaged.
• Unplug the refrigerator before cleaning or making
repairs.
• Repairs should be made by a qualified service
technician.
AVERTISSEMENT
• Ces réfrigérateurs sont lourds en haut et il faut les
arrimer pour éviter leur basculement. Il faut avoir
un système de protection contre le renversement.
Voir les détails page 11.
• Il ne faut utiliser cet appareil que pour l’utilisation
appropriée.
• Réparer ou remplacer immédiatement tout cordon
électrique effiloché ou endommagé.
• Il faut débrancher le réfrigérateur avant le
nettoyage ou toute intervention.
• Les réparations doivent être faites par un
technicien qualifié.
For Monogram local service in your area, call
1.800.444.1845.
For Monogram service in Canada, call
1.888.880.3030
For Monogram Parts and Accessories, call
1.800.626.2002.
www. monogram.com
2
BEFORE YOU BEGIN
Read these instructions completely and carefully.
•
IMPORTANT
—
Save these instructions
for local inspector’s use. Observe all governing codes
and ordinances.
•
Note to Installer
—
Be sure to leave these
instructions with the Consumer.
•
Note to Consumer
—
Keep these instructions
with your Owner’s Manual for future reference.
WARNING:
This appliance must be properly grounded. See
“Grounding the Refrigerator,” page 9.
AVERTISSEMENT
Cet appareil doit être correctement mis à la terre.
Consulter «Mise à la terre du réfrigérateur», page 9.
If you received a damaged refrigerator, you should
immediately contact your dealer or builder.
CAUTION:
Due to the weight and size of this refrigerator, and
to reduce the risk of personal injury or damage to
the product—THREE PEOPLE ARE REQUIRED
FOR PROPER INSTALLATION.
PRUDENCE
À cause du poids et de la taille de ce réfrigérator et
pour réduire le risque de blessure et de dommages,
IL FAUT TROIS PERSONNES POUR FAIRE
L’INSTALLATION CORRECTEMENT.
CONTENTS
Planning Guide
The Installation Space............................3
Dimensions and Clearances..................3
130°Door Swing......................................4
90°Door Swing........................................5
Customization Basics..............................6
Panel Dimensions....................................7
Side Panels................................................8
ZUG2 Grille Panel Dimensions..............8
Installation Instructions
Tools, Hardware, Materials....................9
Grounding the Refrigerator....................9
Step 1, Remove Packaging..................10
Step 2, Install Water Line......................10
Step 2A, RO Water Line........................11
Step 3, Install Side Panels....................11
Step 4, Install Anti-Tip Brackets..........11
Step 5, Level Refrigerator....................12
Step 6, Secure Refrigerator to
Cabinetry....................................12
Step 7, Adjust Door Swing....................13
Step 8, Install Grille Panel....................13
Step 9, Install Framed Panels..............14
Step 9A, Install Overlay Panels............15
Step 10, Connect Water Supply..........16
Step 11, Connect Power........................16
Step 12, Start Icemaker........................16
Step 13, Install Toekick..........................17
36" Frame to
Frame Width
*84" From
Floor to
Top Frame
35"
Case Width
*83-1/2"
at
Rear
25-3/4" Framed Models
25-3/4" Stainless Steel Models
Case Depth
Depth Including Handles:
26-7/8" Framed Models
27-3/4" Stainless Steel Models
THE INSTALLATION SPACE
Water And Electrical Locations
Electrical and water supply must be located as shown.
The cutout depth must be 24"
The refrigerator will project forward, slightly beyond
adjacent cabinetry, depending on your installation.
Cutout depth beneath a soffit:
When installed beneath a soffit, the soffit cannot
exceed the 24" installation depth shown. The top case
trim overlaps the bottom of the soffit.
Additional Specifications
• A 115 volt 60Hz., 15 or 20 amp power supply is
required. An individual properly grounded branch
circuit or circuit breaker is recommended. Install
a properly grounded 3-prong electrical receptacle
recessed into the back wall. Electrical must be
located on rear wall as shown.
Note:
GFI (ground fault interrupter) is not
recommended.
• Water line can enter the opening through the
floor or back wall. The water line should be 1/4"
O.D. copper tubing or GE SmartConnect
™
kit
between the cold water line and water connection
location, long enough to extend to the front of the
refrigerator. Installation of an easily accessible
shut-off valve in the water line is required.
DIMENSIONS AND CLEARANCES
* Shipping height. The
refrigerator can be adjusted
to fit into a cutout that is
83-1/2" min. to 84-1/2" max.
height. Note that the top
case trim at the front is
1/2" higher and will overlap
upper cabinetry or soffit.
Use leveling legs and wheels
for a maximum 1” height
adjustment.
Product Clearances
These refrigerators are equipped with a 2-position
door stop. The factory set 130°door swing can be
adjusted to 90°if clearance to adjacent cabinets or
walls is restricted.
130°Door Swing90°Door Swing
3
23-7/8"
Behind
Frame
36-3/4"
4" Minimum
to Wall
90
°
6"
Wall View
Electrical
Area
84-1/2" max
83-1/2" min
Finished
Opening
75" From
Floor to
Bottom
of Electrical Area
10"
5"
3 1/2"
5"
3 1/2"
Water Supply
24" Cutout Depth
35-1/2"
Finished Width
2-5/16"
25"
Minimum
to Wall
130
°
ZUG2, ZUGSS2 Unified Grille Panel Kit
• If you are installing two refrigerators, side by side,
the installation space must be 71-1/2" wide.
Note:
Additional cutout width may be required when side panels
are used. Add side panel thickness to the finished cutout to
calculate rough-in width.
• The water and electrical locations for each product
must be located as shown.
• A separate 115V, 60Hz., 15 or 20 amp power supply
is recommended for each product.
2-5/16"
75" From
Floor to Bottom
of Electrical Area
84-1/2" max
83-1/2" min
Finished
Opening
71-1/2" Finished Width
Electrical
5"
3-1/2"
24" Cutout
Depth
Water Supply
Wall View
24-3/16"
26"
6"
10"
6"
10"
Water Supply
26"
5"
3-1/2"
The finished
cutout width
must be
35-1/2".
Allow 25" minimum clearance for a full
130°door swing. Allow 15" for pan removal.
4" minimum clearance is required when door swing
is adjusted to 90°. If the 90°door stop position is
used, pan access is maintained, but pan removal is
restricted.
See illustrations pages 4 and 5 to determine door swing
interaction with adjacent cabinets or countertops.
Design Guide
Product specificaties
| Merk: | Monogram |
| Categorie: | Koelkast |
| Model: | ZICS360NMRH |
Heb je hulp nodig?
Als je hulp nodig hebt met Monogram ZICS360NMRH stel dan hieronder een vraag en andere gebruikers zullen je antwoorden