Mitsubishi WD-52525 Handleiding

Mitsubishi Televisie WD-52525

Lees hieronder de 📖 handleiding in het Nederlandse voor Mitsubishi WD-52525 (108 pagina's) in de categorie Televisie. Deze handleiding was nuttig voor 65 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/108

TV Information:

Use this space to record the model and serial numbers of

your television. This information is on the back of your TV.

Model number

Serial number

visit our website at

www.mitsubishi-tv.com

Owner’s Guide

Projection Television Models

WD-52525, WD-52725

WD-62525, WD-62725

The lightning flash with arrowhead symbol within an equilateral triangle is intended to alert the user of

the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be sufficient

magnitude to constitute a risk of electric shock.

The exclamation point within an equilateral triangle is intended to alert the user to the presence of

important operating and maintenance (servicing) instructions in the literature accompanying the

appliance.

WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN

OR MOISTURE.

CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT.

NOTE TO CATV SYSTEM INSTALLER: THIS REMINDER IS PROVIDED TO CALL THE CATV SYSTEM INSTALLER’S

ATTENTION TO ARTICLE 820-40 OF THE NEC THAT PROVIDES GUIDELINES FOR THE PROPER GROUNDING AND,

IN PARTICULAR, SPECIFIES THAT THE CABLE GROUND SHALL BE CONNECTED TO THE GROUNDING SYSTEM

OF THE BUILDING, AS CLOSE TO THE POINT OF CABLE ENTRY AS PRACTICAL.

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR

BACK). NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE

PERSONNEL.

This TV is very heavy! Exercise extreme care when lifting or moving. A minimum of two adults

should lift or move the TV.

Portions of the advanced circuitry of this TV must continue to operate even when the TV is turned

off. Some of these circuits therefore need to be cooled at all times. A low power standby fan may

be heard in a quiet environment. This is normal operation.

Custom cabinet installation must allow for proper air circulation around the television.

STAND REQUIREMENT

CAUTION: Mitsubishi TV models WD-52525 and WD-52725 are for use only with Mitsubishi stand, model MB-52525.

Mitsubishi TV models WD-62525 and WD-62725 are for use only with Mitsubishi stand model MB-62525. Use with

other stands is capable of resulting in instability causing possible injury.

FCC Declaration of Conformity

Product: Projection Television Receiver

Models: WD-52525, WD-52725, WD-62525, WD-62725

Responsible Party: Mitsubishi Digital Electronics America, Inc.

9351 Jeronimo Road

Irvine, CA 92618-1904

Telephone: 949-465-6000

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that may cause undesired operation.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to

part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference

in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does

cause harmful interference to radio or television reception, which can be determined by turning the equipment off

and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and the receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

Changes or modifications not expressly approved by Mitsubishi could cause harmful interference and would

void the user’s authority to operate this equipment.

CAUTION: To assure continued FCC compliance, the user must use a shielded video interface cable

with bonded ferrite cores at both ends, when using the PC or HDMI input.

Product specificaties

Merk:	Mitsubishi
Categorie:	Televisie
Model:	WD-52525

Heb je hulp nodig?

Als je hulp nodig hebt met Mitsubishi WD-52525 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden

Uw naam*

Jouw email*

Schrijf hier uw vraag

Handleiding Televisie Mitsubishi

Mitsubishi LT2240 Handleiding

26 Juni 2023

Mitsubishi WD-65C8 Handleiding

12 Juni 2023

Mitsubishi WS65515A Handleiding

10 Juni 2023

Mitsubishi WT65315 Handleiding

9 Juni 2023

Mitsubishi WD-82742 Handleiding

4 Juni 2023

Mitsubishi VS60609 Handleiding

2 Juni 2023

Mitsubishi WD-73842 Handleiding

1 Juni 2023

Mitsubishi LT-37131 Handleiding

24 Mei 2023

Mitsubishi LT3020 Handleiding

14 Mei 2023

Mitsubishi WD-73640 Handleiding

8 Mei 2023

Handleiding Televisie

Nieuwste handleidingen voor Televisie

LG 50UR81006LJ Handleiding

26 April 2024

Philips 50PUS7009 Handleiding

25 April 2024

RevolutionHD S37LTD Handleiding

25 April 2024

RevolutionHD S46LTD Handleiding

25 April 2024

RevolutionHD S32LTD Handleiding

25 April 2024

RevolutionHD S42LTD Handleiding

25 April 2024

RevolutionHD S50PTD Handleiding

25 April 2024

LG OLED42C2AUA Handleiding

18 April 2024

LG 70UR8000AUA Handleiding

18 April 2024

LG 43UH610A Handleiding

18 April 2024