Mission TF-600 Handleiding

Mission Lamp TF-600

Bekijk gratis de handleiding van Mission TF-600 (1 pagina’s), behorend tot de categorie Lamp. Deze gids werd als nuttig beoordeeld door 93 mensen en kreeg gemiddeld 5.0 sterren uit 47 reviews. Heb je een vraag over Mission TF-600 of wil je andere gebruikers van dit product iets vragen? Stel een vraag

Pagina 1/1
RUBBER GASKET
WORM DRIVE CLAMP
4
3
21
APRON
QUICK-RELEASE CLAMP
Pull screw head away from clamp housing and pull “tail” through
housing. Cinch down clamp to hand-tight. Note: Housing should
be centered onto apron. Repeat clamp installation on opposite side.
Using a nut driver or torque wrench, tighten quick-release clamps
alternately and rmly to 60 in/lbs. of torque. Slide clamp “tail back
through top of square eyelet.
Slide “tail of quick-release clamp down through front square eyelet on
apron. Wrap “tail underneath and around sewer main, then back up
through rear square eyelet.
CLAMP TAIL
Core appropriate sized hole into sewer main (4" core i.d. of 4.60" -
4.90" & 6" core i.d. of 6.60" - 6.90"). After making sure pipe surface
is clean and free of debris, wrap stainless steel apron and gasket
around sewer main, making sure internal ange of gasket is centered
in hole of cored pipe.
Loosen lateral inlet worm drive clamp. Insert lateral pipe into mouth
of inlet until it rests against the internal pipe stop. Tighten lateral inlet
worm drive clamp to 60 in/lbs. of torque.
Mission Rubber Company LLC | 1660 Leeson Ln |Corona, CA 92879 USA
toll free
800.854.9991
fax
800.637.4601
missionrubber.com REV. 8/15
Designed to make lateral service connections.
S E W E R S A D D L E
TF
T-FLEX® Sewer Saddle
I N S T A L L A T I O N I N S T R U C T I O N S


Product specificaties

Merk: Mission
Categorie: Lamp
Model: TF-600

Heb je hulp nodig?

Als je hulp nodig hebt met Mission TF-600 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden